Carbon monoxide oxidation on copper manganese oxides prepared by selective etching with ammonia

A series of copper manganese oxides were prepared using a selective etching technique with various amounts of ammonia added during the co-precipitation process. The effect of the ammonia etching on the structure and catalytic properties of the copper manganese oxides was investigated using elemental analysis, nitrogen physisorption, X-ray powder diffraction, scanning and transmission electron microscopy, X-ray photoelectron spectroscopy, H2 temperature-programmed reduc- tion, and Oz temperature-programmed desorption combined with catalytic oxidation of CO. It was found that ammonia can selectively remove copper species from the copper manganese oxides, which correspondingly generates more defects in these oxides. An oxygen spillover from the man- ganese to the copper species was observed by H2 temperature-programmed desorption, indicating that ammonia etching enhanced the mobility of lattice oxygen species in these oxides. The Oz tem- perature-programmed desorption measurements further revealed that ammonia etching improved the ability of these oxides to release lattice oxygen. The improvement in redox properties of the copper manganese oxides following ammonia etching was associated with enhanced catalytic performance for CO oxidation.

Effect of Precipitation Method and Ce Doping on the Catalytic Activity of Copper Manganese Oxide Catalysts for CO Oxidation

The influence of Ce doping and the precipitation method on structural properties and the catalytic activity of copper manganese oxides for CO oxidation at ambient temperature have been investigated. The catalysts were characterized by means of the powder X-ray diffraction and N2 adsorption-desorption, the inductively coupled plasma atomic emission spectrometry, the temperature programmed reduction, diffuse reflectance UV-Vis spectra, and the X-ray photoelectron spectroscopy. It was found that after doping little amount of Ce in copper manganese oxide, CeO2 phase was highly dispersed and could prevent sintering and aggregating of the catalyst, the size of the catalytic material was decreased, the reducibility was enhanced, the specific surface area was increased and the formation of the active sites for the oxidation of CO was improved significantly. Therefore, the activity of the rare earth promoted catalyst was enhanced remarkably.

Roles of Ceria on Copper and Manganese Oxides Catalyst——Adsorption of NO and CO

A microreactor system and TPD techniques were used to study the reaction kinetics of the CO+ NO reaction and the adsorption of CO,NO,CO_2 and N_2O over Cu-Mn-O(Ⅰ)and Cu-Mn-Ce-O(Ⅱ) catalysts.The results show that the catalytic activity of(Ⅱ)is higher than that of(Ⅰ)for the CO+NO reac- tion,and the higher the conversion of NO,the larger was the activity difference between(Ⅰ)and(Ⅱ).For (Ⅰ)the rate of NO elimination is dependent on the partial pressures of NO,CO,CO_2 with the kinetics or- ders of 0.48,0.56,0.08,respectively.The TPD study shows that the presence of Ce in(Ⅱ)may promote the adsorption of NO,CO on the surface,i.e.an increase of the coverage θ_(NO),θ_(CO),which result in a decrease of the hindrance of the reaction products.For CO_2 and N_2O the situation is in the opposite,the presence of Ce makes the θ_(CO)_2)and θ_(NO)on(Ⅱ)decrease,which weakens the inhibition of CO_2 for the reaction.