The influence of Fe2O3 impurity on the crystalline structure of cordierite synthesized from waste aluminum slag is discussed. XRD and SEM techniques were employed to characterize the crystalline structure and micros...The influence of Fe2O3 impurity on the crystalline structure of cordierite synthesized from waste aluminum slag is discussed. XRD and SEM techniques were employed to characterize the crystalline structure and microstructure of each specimen. Philips X’pert plus software was used to determine the lattice parameters of each specimen. The results show that the Fe2O3 content of 0.8～1.6wt% is beneficial to the formation of cordierite, with the cordierite amount reaching 90wt%. So 0.8～1.6wt% is considered as the allowable Fe2O3 content in the specimens and 0.8wt% is determined to be the best after overall analysis. Plus software analysis shows that the cordierite in each specimen has the same symmetrical hexagonal structure as the single crystal, and the lattice parameters as well as the lattice dimensions change slightly.展开更多
Fe(Ⅲ)has been proved to be a more eff ective oxidant than dissolved oxygen at ambient temperature,however,the role of Fe(Ⅲ)in pyrite acidic pressure oxidation was rarely discussed so far.In this paper,in-situ electr...Fe(Ⅲ)has been proved to be a more eff ective oxidant than dissolved oxygen at ambient temperature,however,the role of Fe(Ⅲ)in pyrite acidic pressure oxidation was rarely discussed so far.In this paper,in-situ electrochemical investigation was performed using a flow-through autoclave system in acidic pressure oxidation environment.The results illustrated that increasing Fe(Ⅲ)concentrations led to raising in redox potential of the solution,and decreased passivation of pyrite caused by deposition of elemental sulfur.Reduction of Fe(Ⅲ)at pyrite surface was a fast reaction with low activation energy,it was only slightly promoted by rising temperatures.While,the oxidation rate of pyrite at all investigated Fe(Ⅲ)concentrations increased obviously with rising temperatures,the anodic reaction was the rate-limiting step in the overall reaction.Activation energy of pyrite oxidation decreased from 47.74 to 28.79 kJ/mol when Fe(Ⅲ)concentration was increased from 0.05 to 0.50 g/L,showing that the reaction kinetics were limited by the rate of electrochemical reaction at low Fe(Ⅲ)concentrations,while,it gradually turned to be diffusion control with increasing Fe(Ⅲ)concentrations.展开更多
A new technique-series electro-pulse discharge (SEPD)-was developed as a sur-face coating process. In this technique, both positive and negative poles of a pulse power were used as the depositing electrodes with the s...A new technique-series electro-pulse discharge (SEPD)-was developed as a sur-face coating process. In this technique, both positive and negative poles of a pulse power were used as the depositing electrodes with the substrate alloy as an induction electrode. Fe-Cr and Fe-Cr-Y2O3 micro-crystalline coatings were deposited on stain-less steel (Fe-18Cr-8Ni) surfaces. Oxidation at 950℃ in ambient air showed that the coatings greatly improved the oxidation resistance of the steel. The addition of dis-persed Y2O3 nano-particles into the alloy coatings was found to further reduce the scaling rate and enhance the adhesion of oxide scales.展开更多
Fe-Cu thin films of 0.2 mum in thickness with different Cu contents wereprepared by using r.f. magnetron sputtering onto glass substrate. The effect of sputteringparameters, including Ar gas pressure and input rf powe...Fe-Cu thin films of 0.2 mum in thickness with different Cu contents wereprepared by using r.f. magnetron sputtering onto glass substrate. The effect of sputteringparameters, including Ar gas pressure and input rf power, on the structure and magnetic propertieswas investigated. It was found that when the power is lower than 70W, the structure of the filmsremained single bcc-Fe phase with Cu solubility of up to 50at. percent. TEM observations for thebcc-Fe phase showed that the grain size was in the nanometer range of less than 20nm. The coercivityof Fe- Cu films was largely affected by not only Ar gas pressure but also rf power, and reachedabout 2.5Oe in the pressure of 0.67-6.67Pa and in the power of less than 100W. In addition,saturation magnetization, with Cu content less than 60at. percent, was about proportional to thecontent of bcc-Fe. When Cu content was at 60at. percent, however, saturation magnetization was muchsmaller than its calculation value.展开更多
基金This work was supported by the '863' Project (2003AA322020)
文摘The influence of Fe2O3 impurity on the crystalline structure of cordierite synthesized from waste aluminum slag is discussed. XRD and SEM techniques were employed to characterize the crystalline structure and microstructure of each specimen. Philips X’pert plus software was used to determine the lattice parameters of each specimen. The results show that the Fe2O3 content of 0.8～1.6wt% is beneficial to the formation of cordierite, with the cordierite amount reaching 90wt%. So 0.8～1.6wt% is considered as the allowable Fe2O3 content in the specimens and 0.8wt% is determined to be the best after overall analysis. Plus software analysis shows that the cordierite in each specimen has the same symmetrical hexagonal structure as the single crystal, and the lattice parameters as well as the lattice dimensions change slightly.
基金supported by the Science and Technology Foundation of Guizhou Province,China(No.[2020]1Y163)the National Natural Science Foundation of China(No.41827802).
文摘Fe(Ⅲ)has been proved to be a more eff ective oxidant than dissolved oxygen at ambient temperature,however,the role of Fe(Ⅲ)in pyrite acidic pressure oxidation was rarely discussed so far.In this paper,in-situ electrochemical investigation was performed using a flow-through autoclave system in acidic pressure oxidation environment.The results illustrated that increasing Fe(Ⅲ)concentrations led to raising in redox potential of the solution,and decreased passivation of pyrite caused by deposition of elemental sulfur.Reduction of Fe(Ⅲ)at pyrite surface was a fast reaction with low activation energy,it was only slightly promoted by rising temperatures.While,the oxidation rate of pyrite at all investigated Fe(Ⅲ)concentrations increased obviously with rising temperatures,the anodic reaction was the rate-limiting step in the overall reaction.Activation energy of pyrite oxidation decreased from 47.74 to 28.79 kJ/mol when Fe(Ⅲ)concentration was increased from 0.05 to 0.50 g/L,showing that the reaction kinetics were limited by the rate of electrochemical reaction at low Fe(Ⅲ)concentrations,while,it gradually turned to be diffusion control with increasing Fe(Ⅲ)concentrations.
基金This project was supported by The National Natural Science Foundation of China (Grant No. 59801002).
文摘A new technique-series electro-pulse discharge (SEPD)-was developed as a sur-face coating process. In this technique, both positive and negative poles of a pulse power were used as the depositing electrodes with the substrate alloy as an induction electrode. Fe-Cr and Fe-Cr-Y2O3 micro-crystalline coatings were deposited on stain-less steel (Fe-18Cr-8Ni) surfaces. Oxidation at 950℃ in ambient air showed that the coatings greatly improved the oxidation resistance of the steel. The addition of dis-persed Y2O3 nano-particles into the alloy coatings was found to further reduce the scaling rate and enhance the adhesion of oxide scales.
基金This research is sponsored by the National Natural Science Foundation of China (Grant No.69971006).
文摘Fe-Cu thin films of 0.2 mum in thickness with different Cu contents wereprepared by using r.f. magnetron sputtering onto glass substrate. The effect of sputteringparameters, including Ar gas pressure and input rf power, on the structure and magnetic propertieswas investigated. It was found that when the power is lower than 70W, the structure of the filmsremained single bcc-Fe phase with Cu solubility of up to 50at. percent. TEM observations for thebcc-Fe phase showed that the grain size was in the nanometer range of less than 20nm. The coercivityof Fe- Cu films was largely affected by not only Ar gas pressure but also rf power, and reachedabout 2.5Oe in the pressure of 0.67-6.67Pa and in the power of less than 100W. In addition,saturation magnetization, with Cu content less than 60at. percent, was about proportional to thecontent of bcc-Fe. When Cu content was at 60at. percent, however, saturation magnetization was muchsmaller than its calculation value.
