Effects of microwave oxygen plasma treatments on microstructure and Ge-V photoluminescent properties of diamond particles

The microstructure and Ge-V photoluminescent properties of diamond particles treated by microwave oxygen plasma are investigated.The results show that in the first 5 min of microwave plasma treatment,graphite and disordered carbon on the surface of the particles are etched away,so that diamond with regular crystal plane,smaller lattice stress,and better crystal quality is exposed,producing a Ge-V photoluminescence(PL)intensity 4 times stronger and PL peak FWHM(full width at half maximum)value of 6.6 nm smaller than the as-deposited sample.It is observed that the cycles of‘diamond is converted into graphite and disordered carbon,then the graphite and disordered carbon are etched’can occur with the treatment time further increasing.During these cycles,the particle surface alternately appears smooth and rough,corresponding to the strengthening and weakening of Ge-V PL intensity,respectively,while the PL intensity is always stronger than that of the as-deposited sample.The results suggest that not only graphite but also disordered carbon weakens the Ge-V PL intensity.Our study provides a feasible way of enhancing the Ge-V PL properties and effectively controlling the surface morphology of diamond particle.

Growth of SiC as Binder to Adhere Diamond Particle and Tribological Properties of Diamond Particles Coated SiC

The purpose of this work was to grow SiC as binder to adhere diamond particles to graphite substrate by low pressure chemical vapor deposition （LPCVD） at 1100 ℃ and 100 Pa using methyltrichlorosilane （MTS： CH3SiCl3） as precursor. The composite coatings on graphite substrates were analyzed by various techniques. Results show that a dense SiC coating with a cloud-cluster shape was formed both on the diamond particles and the substrate after deposition, The thermal stress （290.6 MPa） strengthened the interfacial bonding between the diamond particle and the SiC coating, which is advantageous for the purpose of adhering diamond particles to graphite substrate. The applied load of sliding wear test was found to affect not only the friction coefficient, but also the wear surface morphology. With increasing loads, the asperity penetration was high and the friction coefficient decreased.

Enhanced mechanical properties in Al/diamond composites by Si addition

Diamond particles reinforced aluminum–silicon matrix composites,abbreviated as Al（Si）/diamond composites,were fabricated by squeeze casting.The effect of Si content on the microstructure and mechanical properties of the composites were investigated.The mechanical properties are found to increase monotonically with Si content increasing up to 7.0 wt%.The Al-7.0 wt% Si/diamond composite exhibits tensile strength of 78 MPa,bending strength of 230 MPa,and compressive strength of426 MPa.Al–Si eutectic phases are shown to connect with Al matrix and diamond particles tightly,which is responsible for the enhancement of mechanical properties in the Al（Si）/diamond composites.