Full duplex radio increases the frequency efficiency but its performance is limited by the self-interference （SI）. We first analyze the multiple noises in the full duplex radio system and model such noises as an α ...Full duplex radio increases the frequency efficiency but its performance is limited by the self-interference （SI）. We first analyze the multiple noises in the full duplex radio system and model such noises as an α - stable distribution. Then we formulate a novel non-Gaussian SI problem. Under the maximum correntropy criterion （MCC）, a robust digital non-linear self-interference cancellation algorithm is proposed for the SI channel estimation. A gradient descent based algorithm is derived to search the optimal solution. Simulation results show that the proposed algorithm can achieve a smaller estimation error and a higher pseudo signal to interference plus noise ratio （PSINR） than the well-known least mean square （LMS） algorithm and least square （LS） algorithm.展开更多
Although the structured light system that uses digital fringe projection has been widely implemented in three-dimensional surface profile measurement, the measurement system is susceptible to non-linear error. In this...Although the structured light system that uses digital fringe projection has been widely implemented in three-dimensional surface profile measurement, the measurement system is susceptible to non-linear error. In this work, we propose a convenient look-up-table-based （LUT-based） method to compensate for the non-linear error in captured fringe patterns. Without extra calibration, this LUT-based method completely utilizes the captured fringe pattern by recording the full-field differences. Then, a phase compensation map is established to revise the measured phase. Experimental results demonstrate that this method works effectively.展开更多
MPEG-1/2-based non-linear editing systems appear to have a tendency to replace the M-JPEG systems, but in so doing it is difficult to realize the video, audio and the synchronization editing algorithms. Such editing a...MPEG-1/2-based non-linear editing systems appear to have a tendency to replace the M-JPEG systems, but in so doing it is difficult to realize the video, audio and the synchronization editing algorithms. Such editing algorithms are presented. Based on an analysis of the structure of the MPEG-1/2 stream, and using parameters of the video, audio and the synchronization information, the video, audio and synchronization editing algorithms are provided. The characters of the algorithms are efficient, the quality loss of frames is low because it only decodes and codes part of the data; the editing algorithm is fast through use of some index files; synchronization editing is realized using the synchronization information, such as PTS, ESCR and other parameters.展开更多
High speed digital valves are devices ideally suited for the direct interface of fluid power components to digital computers due to their on/off characteristics. In this paper, a model of an extra high speed digital v...High speed digital valves are devices ideally suited for the direct interface of fluid power components to digital computers due to their on/off characteristics. In this paper, a model of an extra high speed digital valve applied in fuel injection system was presented. In order to get the ability of fast response and a simple construction, a new concept for designing and predicting the valve was presented herewith. A new predicting simulation model of the entire test stand was utilized in order to parameterize the model against measured data. The new model predicts transient valve behavior and the proper dynamic coupling between the electrical, magnetic, mechanical and fluid subsystems. Based on the model and simulation, a prototype valve with working pressure of 120 MPa and frequency of 2 kHz was designed and fabricated, its experimental and prediction results for armature motion show excellent agreement.展开更多
A mesh editing framework is presented in this paper, which integrates Free-Form Deformation (FFD) and geometry signal processing. By using simplified model from original mesh, the editing task can be accomplished with...A mesh editing framework is presented in this paper, which integrates Free-Form Deformation (FFD) and geometry signal processing. By using simplified model from original mesh, the editing task can be accomplished with a few operations. We take the deformation of the proxy and the position coordinates of the mesh models as geometry signal. Wavelet analysis is em- ployed to separate local detail information gracefully. The crucial innovation of this paper is a new adaptive regular sampling approach for our signal analysis based editing framework. In our approach, an original mesh is resampled and then refined itera- tively which reflects optimization of our proposed spectrum preserving energy. As an extension of our spectrum editing scheme, the editing principle is applied to geometry details transferring, which brings satisfying results.展开更多
The R-2R resistor ladder is one of the best topologies for implementing compact-sized digital-to-analog converter(DAC)arrays in implantable neuro-stimulators.However,it has a limited resolution and considerable inter-...The R-2R resistor ladder is one of the best topologies for implementing compact-sized digital-to-analog converter(DAC)arrays in implantable neuro-stimulators.However,it has a limited resolution and considerable inter-channel variation due to component mismatches.To avoid losing analog information,we present sub-radix-2 DAC implemented by the R-βR resistor ladder in this paper.The digital successive approximation register(DSAR)algorithm corrects the transfer function of DACs based on their actual bit weights.Furthermore,a low-cost in situ adaptive bit-weight calibration(ABC)algorithm drives the analog output error between two DACs to zero by adjusting their bit weights automatically.The simulation results show that the proposed algorithm can calibrate the non-linear transfer function of each DAC and the gain error among multiple channels in the background.展开更多
We develop a new technique to measure the exact upper diameters of trees that is comparatively simple and inexpensive. We can measure the diameters of entire tree trunks efficiently and with high precision. The system...We develop a new technique to measure the exact upper diameters of trees that is comparatively simple and inexpensive. We can measure the diameters of entire tree trunks efficiently and with high precision. The system uses a digital camera with a ~15 - 30× telephoto lens to take a photograph that can be used for measuring the diameter of the upper part of a comparatively slender tree trunk. Since this method requires a measuring distance and the height of the target point in the image, a range finder capable of measuring angles was combined with the main digiscoping system. A range finder sensor uses a laser and makes a 360 degree angle of observation possible. The diameter of a target position of the objective tree can be obtained by measuring the digital image using image editing software and calculations from spreadsheet software. We focus on the Japanese cedar species in the southwestern part of Japan. Photographic measurements were obtained prior to thinning. The estimates that we obtained largely agree with the true measurements of all trees. With regard to the estimated accuracy of all measured trees, the maximum error ratio was 7.0% (1.45 cm), with a ~2% - 4% error for most of the estimated results. Although the absolute value of the estimation error was 1.87 cm (5.3%) at the maximum (9.87 m in height and 35.5 cm in diameter), an estimation accuracy of <1 cm was reproduced in almost all measurements except for the extreme hypertrophy portion by butt swelling.展开更多
基金supported by the National Natural Science Foundation of China under Grants 61372092"863" Program under Grants 2014AA01A701
文摘Full duplex radio increases the frequency efficiency but its performance is limited by the self-interference （SI）. We first analyze the multiple noises in the full duplex radio system and model such noises as an α - stable distribution. Then we formulate a novel non-Gaussian SI problem. Under the maximum correntropy criterion （MCC）, a robust digital non-linear self-interference cancellation algorithm is proposed for the SI channel estimation. A gradient descent based algorithm is derived to search the optimal solution. Simulation results show that the proposed algorithm can achieve a smaller estimation error and a higher pseudo signal to interference plus noise ratio （PSINR） than the well-known least mean square （LMS） algorithm and least square （LS） algorithm.
基金the financial support provided by the National Natural Science Foundation of China(11472267 and 11372182)the National Basic Research Program of China(2012CB937504)
文摘Although the structured light system that uses digital fringe projection has been widely implemented in three-dimensional surface profile measurement, the measurement system is susceptible to non-linear error. In this work, we propose a convenient look-up-table-based （LUT-based） method to compensate for the non-linear error in captured fringe patterns. Without extra calibration, this LUT-based method completely utilizes the captured fringe pattern by recording the full-field differences. Then, a phase compensation map is established to revise the measured phase. Experimental results demonstrate that this method works effectively.
文摘MPEG-1/2-based non-linear editing systems appear to have a tendency to replace the M-JPEG systems, but in so doing it is difficult to realize the video, audio and the synchronization editing algorithms. Such editing algorithms are presented. Based on an analysis of the structure of the MPEG-1/2 stream, and using parameters of the video, audio and the synchronization information, the video, audio and synchronization editing algorithms are provided. The characters of the algorithms are efficient, the quality loss of frames is low because it only decodes and codes part of the data; the editing algorithm is fast through use of some index files; synchronization editing is realized using the synchronization information, such as PTS, ESCR and other parameters.
文摘High speed digital valves are devices ideally suited for the direct interface of fluid power components to digital computers due to their on/off characteristics. In this paper, a model of an extra high speed digital valve applied in fuel injection system was presented. In order to get the ability of fast response and a simple construction, a new concept for designing and predicting the valve was presented herewith. A new predicting simulation model of the entire test stand was utilized in order to parameterize the model against measured data. The new model predicts transient valve behavior and the proper dynamic coupling between the electrical, magnetic, mechanical and fluid subsystems. Based on the model and simulation, a prototype valve with working pressure of 120 MPa and frequency of 2 kHz was designed and fabricated, its experimental and prediction results for armature motion show excellent agreement.
基金Project supported by the National Basic Research Program (973) of China (No. 2002CB312102), and the National Natural Science Foun-dation of China (Nos. 60021201, 60333010 and 60505001)
文摘A mesh editing framework is presented in this paper, which integrates Free-Form Deformation (FFD) and geometry signal processing. By using simplified model from original mesh, the editing task can be accomplished with a few operations. We take the deformation of the proxy and the position coordinates of the mesh models as geometry signal. Wavelet analysis is em- ployed to separate local detail information gracefully. The crucial innovation of this paper is a new adaptive regular sampling approach for our signal analysis based editing framework. In our approach, an original mesh is resampled and then refined itera- tively which reflects optimization of our proposed spectrum preserving energy. As an extension of our spectrum editing scheme, the editing principle is applied to geometry details transferring, which brings satisfying results.
基金supported by the Shanghai Municipal of Science and Technology Project under Grant No.20JC1419500the Open Research Projects of Zhejiang Lab under Grant No.2021MC0AB06.
文摘The R-2R resistor ladder is one of the best topologies for implementing compact-sized digital-to-analog converter(DAC)arrays in implantable neuro-stimulators.However,it has a limited resolution and considerable inter-channel variation due to component mismatches.To avoid losing analog information,we present sub-radix-2 DAC implemented by the R-βR resistor ladder in this paper.The digital successive approximation register(DSAR)algorithm corrects the transfer function of DACs based on their actual bit weights.Furthermore,a low-cost in situ adaptive bit-weight calibration(ABC)algorithm drives the analog output error between two DACs to zero by adjusting their bit weights automatically.The simulation results show that the proposed algorithm can calibrate the non-linear transfer function of each DAC and the gain error among multiple channels in the background.
文摘We develop a new technique to measure the exact upper diameters of trees that is comparatively simple and inexpensive. We can measure the diameters of entire tree trunks efficiently and with high precision. The system uses a digital camera with a ~15 - 30× telephoto lens to take a photograph that can be used for measuring the diameter of the upper part of a comparatively slender tree trunk. Since this method requires a measuring distance and the height of the target point in the image, a range finder capable of measuring angles was combined with the main digiscoping system. A range finder sensor uses a laser and makes a 360 degree angle of observation possible. The diameter of a target position of the objective tree can be obtained by measuring the digital image using image editing software and calculations from spreadsheet software. We focus on the Japanese cedar species in the southwestern part of Japan. Photographic measurements were obtained prior to thinning. The estimates that we obtained largely agree with the true measurements of all trees. With regard to the estimated accuracy of all measured trees, the maximum error ratio was 7.0% (1.45 cm), with a ~2% - 4% error for most of the estimated results. Although the absolute value of the estimation error was 1.87 cm (5.3%) at the maximum (9.87 m in height and 35.5 cm in diameter), an estimation accuracy of <1 cm was reproduced in almost all measurements except for the extreme hypertrophy portion by butt swelling.
