Grain refinement of pure aluminum by direct current pulsed magnetic field and inoculation

The combined effects of direct current pulsed magnetic field （DC-PMF） and inoculation on pure aluminum were investigated, the grain refinement behavior of DC-PMF and inoculation was discussed. The experimental results indicate that the solidification micro structure of pure aluminum can be greatly refined under DC-PMF. Refinement of pure aluminum is attributed to electromagnetic undercooling and forced convection caused by DC-PMF. With single DC-PMF, the grain size in the equiaxed zone is uneven. However, under DC-PMF, by adding 0.05% （mass fraction） Al5Ti-B, the grain size of the sample is smaller, and the size distribution is more uniform than that of single DC-PMF. Furthermore, under the combination of DC-PMF and inoculation, with the increase of output current, the grain size is further reduced. When the output current increases to 100 A, the average grain size can decrease to 113 μn.

Three-dimensional transformation of magnetization direction and magnetic field component at low latitudes based on vertical relationship

The transformation of the magnetization direction and the magnetic fi eld component is one of the important methods in magnetic data processing and transformation,which can be conducted in both wavenumber and spatial domains.The transformation method in the wavenumber domain has simpler processing expression and higher processing effi ciency than in the spatial domain;however,they are unstable at low latitude.In this paper,the conclusion that the sum is 0 of two vertical magnetic fi eld components(magnetization inclinations are also perpendicular)in 2D is used for the 3D transformation of the magnetization direction and the magnetic field component.In addition,the transformation method at low latitudes based on vertical relationship(VMT)is proposed,which is an iterative algorithm that converts the transformation of the magnetization direction and the magnetic field component at the low latitude into the high latitude.This method restrains the instability of transformation of constant and variable magnetization direction and magnetic fi eld components in low latitudes.The accuracy,stability,and practicality are verifi ed from synthetic models and real data.

Reversal of radial glow distribution in helicon plasma induced by reversed magnetic field

In this work, the reversal of radial glow distribution induced by reversed magnetic field is reported. Based on the Boswell antenna which is symmetric and insensitive to the magnetic field direction, it seems such a phenomenon in theory appears impossible. However, according to the diagnostic of the helicon waves by magnetic probe, it is found that the direction of magnetic field significantly affects the propagation characteristic of helicon waves, i.e., the interchange of the helicon waves at the upper and the lower half of tube was caused by reversing the direction of magnetic field. It is suggested that the variation of helicon wave against the direction of magnetic field causes the reversed radial glow distribution. The appearance of the traveling wave does not only improve the discharge strength, but also determines the transition of the discharge mode.

A fault-tolerant triple-redundant voice coil motor for direct drive valves:Design, optimization, and experiment

A direct drive actuator （DDA） with direct drive valves （DDVs） as the control device is an ideal solution for a flight actuation system. This paper presents a novel triple-redundant voice coil motor （TRVCM） used for redundant DDVs. The TRVCM features electrical/mechanical hybrid triple-redundancy by securing three stators along with three moving coils in the same frame. A permanent magnet （PM） Halbach array is employed in each redundant VCM to simplify the system structure. A back-to-back design between neighborly redundancies is adopted to decouple the magnetic flux linkage. The particle swarm optimization （PSO） method is implemented to optimize design parameters based on the analytical magnetic circuit model. The optimization objective function is defined as the acceleration capacity of the motor to achieve high dynamic performance. The optimal geometric parameters are verified with 3D magnetic field finite element analysis （FEA）. A research prototype has been developed for experimental purpose. The experimental results of magnetic field density and force output show that the proposed TRVCM has great potential of applications in DDA systems.