Research on the longitudinal protection of a through-type cophase traction direct power supply system based on the empirical wavelet transform

This paper proposes a longitudinal protection scheme utilizing empirical wavelet transform(EWT)for a through-type cophase traction direct power supply system,where both sides of a traction network line exhibit a distinctive boundary structure.This approach capitalizes on the boundary’s capacity to attenuate the high-frequency component of fault signals,resulting in a variation in the high-frequency transient energy ratio when faults occur inside or outside the line.During internal line faults,the high-frequency transient energy at the checkpoints located at both ends surpasses that of its neighboring lines.Conversely,for faults external to the line,the energy is lower compared to adjacent lines.EWT is employed to decompose the collected fault current signals,allowing access to the high-frequency transient energy.The longitudinal protection for the traction network line is established based on disparities between both ends of the traction network line and the high-frequency transient energy on either side of the boundary.Moreover,simulation verification through experimental results demonstrates the effectiveness of the proposed protection scheme across various initial fault angles,distances to faults,and fault transition resistances.

Device-assisted traction methods in colorectal endoscopic submucosal dissection and options for difficult cases

Endoscopic submucosal dissection(ESD)procedure has a longer procedure time and higher perforation rate than endoscopic mucosal resection owing to technical complications,including a poor field of vision and inadequate tension for the submucosal dissection plane.Various traction devices were developed to secure the visual field and provide adequate tension for the dissection plane.Two randomized controlled trials demonstrated that traction devices reduce colorectal ESD procedure time compared with conventional ESD(C-ESD),but they had limitations,including a single-center fashion.The CONNECT-C trial was the first multicenter randomized controlled trial comparing the C-ESD and traction device-assisted ESD(T-ESD)for colorectal tumors.In the T-ESD,one of the device-assisted traction methods(S-O clip,clip-with-line,and clip pulley)was chosen according to the operator’s discretion.The median ESD procedure time(primary endpoint)was not significantly different between C-ESD and T-ESD.For lesions≥30 mm in diameter or in cases treated by nonexpert operators,the median ESD procedure time tended to be shorter in T-ESD than in C-ESD.Although T-ESD did not reduce ESD procedure time,the CONNECT-C trial results suggest that T-ESD is effective for larger lesions and nonexpert operators in colorectal ESD.Compared with esophageal and gastric ESD,colorectal ESD has some difficulties,including poor endoscope maneuverability,which may be associated with prolonged ESD procedure time.T-ESD may not effectively improve these issues,but a balloon-assisted endoscope and underwater ESD may be promising options and these methods can be combined with T-ESD.

Advances in traction methods for endoscopic submucosal dissection:What is the best traction method and traction direction?

Endoscopic submucosal dissection(ESD)has been developed as a treatment for superficial gastrointestinal neoplasms,which can achieve en bloc resection regardless of the lesion size.However,ESD is technically difficult because endoscopists cannot bring their hand into the gastrointestinal tract,unlike surgeons in regular surgery.It is difficult to obtain sufficient tension in the dissection plane and a good field of vision.Therefore,ESD is associated with a long procedure time and a high risk of adverse events in comparison with endoscopic mucosal resection.Traction methods have been developed to provide sufficient tension for the dissection plane and a good field of vision during the ESD procedure.However,traction direction is limited in most traction methods,resulting in insufficient effect in some cases.Although traction direction is considered important,there have been few investigations of its effect.In the first half of this review,important traction methods are discussed,including traction direction.In second half,appropriate traction methods for each organ are considered.Other important considerations for traction method,such as ability to adjust traction strength,interference between traction device and endoscope,and the need for specialized devices are also discussed.

Optimal traction direction in traction-assisted gastric endoscopic submucosal dissection

Various traction devices have been developed to secure a visual field and sufficient tension at the dissection plane during endoscopic submucosal dissection(ESD).However,few large-scale studies have investigated the effectiveness of traction devices in gastric ESD.Clip-with-line(CWL)is one such traction device that is widely used in cases of gastric ESD.The CONNECT-G trial was the first multicenter randomized controlled trial to compare conventional ESD with CWLassisted ESD(CWL-ESD)for superficial gastric neoplasms.Overall,no significant intergroup difference was observed in terms of the gastric ESD procedure time.However,subgroup analysis according to lesion location revealed a significant reduction in the procedure time of gastric ESD for the lesion located at the greater curvature of the middle and upper third of the stomach in the CWL-ESD group.In this subgroup analysis,lesion location was categorized as follows:anterior wall,posterior wall,lesser curvature,and greater curvature of the upper,middle,and lower thirds of the stomach.However,the gastric ESD procedure time showed no significant difference,except for lesions located at the greater curvature of the upper and middle thirds of the stomach.The traction direction of CWL in the stomach was limited to the cardia and changed depending on the lesion location.Therefore,outcomes of the CONNECT-G trail suggest that the effectiveness of CWL was influenced by lesion location,i.e.,traction direction.Further studies are warranted to investigate the optimal traction direction in gastric ESD.

A Straightforward Direct Traction Boundary Integral Method for Two-Dimensional Crack Problems Simulation of Linear Elastic Materials

This paper presents a direct traction boundary integral equation method(DTBIEM)for two-dimensional crack problems of materials.The traction boundary integral equation was collocated on both the external boundary and either side of the crack surfaces.The displacements and tractions were used as unknowns on the external boundary,while the relative crack opening displacement(RCOD)was chosen as unknowns on either side of crack surfaces to keep the single-domain merit.Only one side of the crack surfaces was concerned and needed to be discretized,thus the proposed method resulted in a smaller system of algebraic equations compared with the dual boundary element method(DBEM).A new set of crack-tip shape functions was constructed to represent the strain field singularity exactly,and the SIFs were evaluated by the extrapolation of the RCOD.Numerical examples for both straight and curved cracks are given to validate the accuracy and efficiency of the presented method.