A Two-Layer Fuzzy Control Strategy for the Participation of Energy Storage Battery Systems in Grid Frequency Regulation

To address the frequency fluctuation problem caused by the power dynamic imbalance between the power system and the loadwhen a large number of newenergy sources are connected to the grid,a two-layer fuzzy control strategy is proposed for the participation of the energy storage battery system in FM.Firstly,considering the coordination of FM units responding to automatic power generation control commands,a comprehensive allocation strategy of two signals under automatic power generation control commands is proposed to give full play to the advantages of two FM signals while enabling better coordination of two FM units responding to FM commands;secondly,based on the grid FM demand and battery FM capability,a double-layer fuzzy control strategy is proposed for FM units responding to automatic power generation control commands in a coordinated manner under dual-signal allocation mode to precisely allocate the power output depth of FM units,which can control the fluctuation of frequency deviation within a smaller range at a faster speed while maintaining the battery charge state;finally,the proposed Finally,the proposed control strategy is simulated and verified inMatlab/Simulink.The results show that the proposed control strategy can control the frequency deviation within a smaller range in a shorter time,better stabilize the fluctuation of the battery charge level,and improve the utilization of the FM unit.

Coupling characteristics of laterally coupled gratings with slots

Laterally-coupled ridge-waveguide distributed feedback lasers fabricated without epitaxial regrowth steps have the advantages of process simplification and low cost.We present a laterally coupled grating with slots.The slots etched between the ridge and grating area are designed to suppress the lateral diffusion of carriers and to reduce the influence of the aspect-ratio-dependent-etching effect on the grating morphology in the etching process.Moreover,the grating height in this structure can be decreased to lower the aspect ratio significantly,which is advantageous over the conventional laterally coupled ridge waveguide gratings.The effects of five main structural parameters on the coupling characteristics of gratings are studied by MODE Solutions.It is found that varying the lateral width of the grating can be used as an effective way to tune the coupling strength;narrow slots(100 nm and 300 nm)and wide ridge(2μm–4μm)promote the stability of grating coupling coefficient and device performance.It is important to note that the grating bottom should be fabricated precisely.The comparative study of carrier distribution and mode field distribution shows that the introduction of narrow slots can strengthen the competitive advantage and stability of the fundamental mode.

Polarization Mode Dispersion Probability Distribution for Arbitrary Mode Coupling

The probability distribution of the differential group delay for arbitrary mode coupling is simulated with Monte-Carlo method. Fitting the simulation results, we obtain probability distribution function for arbitrary mode coupling.

Simulation of gas-solid flow in sinter vertical cooling furnace

The velocity distribution of sinter and gas in vertical cooling furnace(VCF)has an important influence on gas-solid heat transfer.Based on the slot model of single hopper in the VCF of Meishan Iron and Steel Co.,Ltd.,the velocity and particle size distribution of sinter and the velocity and pressure distribution of gas were studied using a computational fluid dynamics-discrete element method model to obtain the gas-solid flow rule in the VCF.The results showed that the velocity of sinter near the wall and the edge of vent cowl was lower than that in the rest of the same plane.Therefore,the rectangular section of the vertical cooling furnace can be divided into a quasi-static zone,a plug flow zone and a convergent flow zone according to the flow velocity of the sinter.The average particle size and the void fraction of sinter bed were distributed in"W"and"V"shape along the width direction,respectively.The distribution of gas velocity in the furnace cavity was uneven,and the high-velocity area gradually changed from the center to the edge of the furnace cavity with the rise of gas.Reducing the ratio of edge to center gas flow from 2.7∶1 to 0.7∶1 could improve the gas velocity,but could not change the gas velocity distribution.The gas velocity distribution was more affected by the average particle size distribution of the sinter bed.It was suggested that measures need be taken to adjust it to improve the gas velocity distribution in the VCF.