Numerical modeling for the coupled thermo-mechanical processes and spalling phenomena in sp Pillar Stability Experiment (APSE)

In this paper, the coupled thermo-mechanical （TM） processes in the AEspoe Pillar Stability Experiment （APSE） carried out by the Swedish Nuclear Fuel and Waste Management Company （SKB） were simulated using both continuum and discontinuum based numerical methods. Two-dimensional （2D） and three- dimensional （3D） finite element method （FEM） and 2D distinct element method （DEM） with particles were used. The main objective for the large scale in situ experiment is to investigate the yielding strength of crystalline rock and the formation of the excavation disturbed/damaged zone （EDZ） during excavation of two boreholes, pressurizing of one of the boreholes and heating. For the DEM simulations, the heat flow algorithm was newly introduced into the original code. The calculated stress, displacement and temperature distributions were compared with the ones obtained from in situ measurements and FEM simulations. A parametric study for initial microcracks was also performed to reproduce the spalling phenomena observed in the APSE.

Analysis of the Wave Velocity Ratio Anomalies in the Tianshan Region of Xinjiang

Based on the seismic observation report data provided by the Xinjiang Digital Seismic Network from 2009 to 2014,we calculate the wave velocity ratio and its background value for medium and small earthquakes by using the multi-station method in Tianshan,Xinjiang.This paper analyzes the variation of the wave velocity ratio disturbance value to highlight the abnormal,and also back-traces 7 moderate earthquakes at the research area.The results show that:(1)the background value of the wave velocity ratio is almost 1.70,the wave velocity ratio obviously decreases in the middle-eastern part of Tianshan and the region near the Puchang fault;(2)the wave velocity ratio disturbance value is mostly low in the epicenter before four earthquakes of M≥5.0 from 2011 to 2013 in the study area;(3)before 7 moderate strong earthquakes,the earthquake events with low value of the wave velocity ratio account for over 60% of corresponding total events near the epicenters,and the low value of the wave velocity ratio is relatively obvious before moderate earthquakes.

A rapid compensation method for launch data of long-range rockets under influence of the Earth＇s disturbing gravity field

Regarding the rapid compensation of the influence of the Earth＇ s disturbing gravity field upon trajectory calculation,the key point lies in how to derive the analytical solutions to the partial derivatives of the state of burnout point with respect to the launch data.In view of this,this paper mainly expounds on two issues：one is based on the approximate analytical solution to the motion equation for the vacuum flight section of a long-range rocket,deriving the analytical solutions to the partial derivatives of the state of burnout point with respect to the changing rate of the finalstage pitch program;the other is based on the initial positioning and orientation error propagation mechanism,proposing the analytical calculation formula for the partial derivatives of the state of burnout point with respect to the launch azimuth.The calculation results of correction data are simulated and verified under different circumstances.The simulation results are as follows：（1） the accuracy of approximation between the analytical solutions and the results attained via the difference method is higher than 90%,and the ratio of calculation time between them is lower than 0.2%,thus demonstrating the accuracy of calculation of data corrections and advantages in calculation speed;（2） after the analytical solutions are compensated,the longitudinal landing deviation of the rocket is less than 20 m and the lateral landing deviation of the rocket is less than 10 m,demonstrating that the corrected data can meet the requirements for the hit accuracy of a long-range rocket.

A Surface Heat Disturbance Method for Measuring Local Tissue Blood Perfusion Rate

A non-damage method for measuring local tissue blood perfusion rate by surface heat disturbance and its two special embodiments for realizing this measurement are presented in this paper.In the derivation of mathematical model,the Pennes equation is used, and two parameters which are very difficult to be known-the arterial blood temperature Tαand the metabolic heat generation rate qm,have been eliminated.So it has provided a feasible basis for application.In this paper,the performance and the adaptable condition of the measurement method and its structure peculiarities are discussed over a wide variety of parameters.Moreover,the effectiveness of the measurement method has been demonstrated by means of the quantitative measurement of tissue in vitro,the comparative measurement of animal under artificial perfusion and the dependence measurement in human body.