Effect of heating methods on drying quality of small-diameter birch lumbers

Following a normal low temperature drying schedule, the small-diameter Birch lumbers （ 1 000mm× 45mm ×30mm） were dried with consecution-heats or intermittent-heating, visual drying defects （bow, crook, twist, check along grain and end check） were measured, and then statistical analyses were performed. It was found that the drying quality of small-diameter Birch lumbers could be improved with intermittent-heating, but the intermittent time should be prolonged. Prolonging intermittent time helped to weaken or even avoid wood distortion and drying checks. It wash＇ t helpful in avoiding crook. The drying quality of small-diameter Birch lumbers with all kinds of drying methods reached the second class of the Chinese National Standard. The drying quality reached the first class of the Chinese National Standard with the intermittent-heating in the area of visual wood defects.

Field performance of alternate wetting and drying furrow irrigation on tomato crop growth, yield, water use efficiency, quality and profitability

Sustainable irrigation method is now essential for adaptation and adoption in the areas where water resources are limited. Therefore, a field experiment was conducted to test the performance of alternate wetting and drying furrow irrigation（AWDFI） on crop growth, yield, water use efficiency（WUE）, fruit quality and profitability analysis of tomato. The experiment was laid out in randomized complete block design with six treatments replicated thrice during the dry seasons of 2013-2014 and 2014-2015. Irrigation water was applied through three ways of furrow： AWDFI, fixed wetting and drying furrow irrigation（FWDFI） and traditional（every） furrow irrigation（TFI）. Each irrigation method was divided into two levels： irrigation up to 100 and 80% field capacity（FC）. Results showed that plant biomass（dry matter） and marketable fruit yield of tomato did not differ significantly between the treatments of AWDFI and TFI, but significant difference was observed in AWDFI and in TFI compared to FWDFI at same irrigation level. AWDFI saved irrigation water by 35 to 38% for the irrigation levels up to 80 and 100% FC, compared to the TFI, respectively. AWDFI improved WUE by around 37 to 40% compared to TFI when irrigated with 100 and 80% FC, respectively. Fruit quality（total soluble solids and pulp） was found greater in AWDFI than in TFI. Net return from AWDFI technique was found nearly similar compared to TFI and more than FWDFI. The benefit cost ratio was viewed higher in AWDFI than in TFI and FWDFI by 2.8, 8.7 and 11, 10.4% when irrigation water was applied up to 100 and 80% FC, respectively. Unit production cost was obtained lower in AWDFI compared to TFI and FWDFI. However, AWDFI is a useful water-saving furrow irrigation technique which may resolve as an alternative choice compared with TFI in the areas where available water and supply methods are limited to irrigation.

Effects of Modulation Methods on the Drying Characteristics and Nutritional Quality of Medicago sativa Hay

Two-year-old Medicago sativa at budding initial stage was taken as research materials.Five methods were used to make green hay,including flatting stems ＋ spraying 2.5% K2CO3,flatting stems,sun curing,drying in shade and drying under 105 ℃ condition（CK）.Besides,effects of different green hay making methods on dry characteristics and nutritional quality of M.sativa green hay were studied,and a comprehensive evaluation of M.sativa green hays was conducted.Results showed that,except CK,the drying rates in other making methods were all fast at first,and then slow down.Both of drying under 105 ℃ condition and flatting stems ＋ spraying K2CO3 could speed up drying rate and reduce nutritional losses of green hay.Sun curing could also speed up drying rate,but it could not maintain the quality of green hay.The results of Grey Relational Analysis on five green hay making methods indicated that CK had the best comprehensive performance,followed by green hays made by flatting stems ＋ spraying K2CO3.Therefore,flatting stems ＋ spraying K2CO3 was a quick and easy method to make green hay,and it was worth to be recommended in practical production.

Study of drying of small diameter Larch lumbers with intermittent heating

Intermittent heating for drying of small diameter Larch lumbers is investigated experimentally. The lumbers were dried using an experimental drying schedule. Moisture content (MC) of the lumber was continuously recorded and final drying defects were examined. The drying curves showed that the drying rate was a constant in the early stage of intermittent heating drying and decreased evidently when the MC was about 18% (intermittent 2h) and 20% (intermittent 6h). The drying quality reached the second (intermittent 2h) and first grade (intermittent 6h) of the Chinese National Standard. The visual drying defects, especially the check extent along grains were reduced with intermittent heating. When the intermittent time increased, the effect was more obvious.

Effects of Different Slow-release Fertilizers on Growth and Yield of Ratooning Rice

The effect of slow-release fertilizer application on reducing the fertilization times of ratooning rice was explored by carrying out plot experiments using different slow-release fertilizer formulas.The results showed that compared with conventional fertilization of farmers(TCK),there were no significant differences in plant heights of the first rice crop and ratoon rice crop and the number of tillers was slightly increased,by applying different ratios and types of slow-release fertilizers,indicating that reducing fertilization times did not affect rice growth.Compared with the TCK,the yields of treatments T1,T2,T3 and T4 of slow-release fertilizers increased to a certain extent.The yield of the first rice crop increased by 14.7%,16.7%,23.5% and 17.5%,respectively,the yields of the ratoon rice crop increased by 6.3%,5.8%,7.4% and 8.1%,respectively,and the yields of the two rice crops increased between 10.8% and 16.1%,indicating that reasonable combined application of slow-release nitrogen and fast-acting nitrogen fertilizer could meet the nutrient requirements of ratooning rice at different growth stages,and the application of slow-release fertilizers could reduce the fertilization times of ratooning rice.Based on the combination of rice yield and slow-release fertilizer cost in the first rice crop and ratoon rice crop,the T 3 formula was preferred,that is,urea-formaldehyde slow-release nitrogen fertilizer was used as the base and tillering fertilizer,and polyurethane-coated slow-release nitrogen fertilizer was used as the panicle-sprouting fertilizer.