A group function relation curve between flux(J) and bulk phase concentration of substrate(S) was set up. The biodegradation kinetic of organic compounds of acrylic fiber wastewater in biofilm is studied(the treatment ...A group function relation curve between flux(J) and bulk phase concentration of substrate(S) was set up. The biodegradation kinetic of organic compounds of acrylic fiber wastewater in biofilm is studied(the treatment technology is coagulation/sedimentation-anoxic/aerobic biofilm process), and the results showed that the concentration of non-degradation pollutants in effluent is 77 mg/L. In aerobic zone, the half-rate constant is 72.84 mg/L, the maximum removal rate of organic compounds at unit area filler is very low, 0.089 g/(m 2·d), which corresponds to the fact that there are some biorefractory compounds in the wastewater.展开更多
Copolymer of maleic acid and acrylic acid （PMA-100）, combining with polyvinyl butyral （PVB） ultrafiltration membrane was used for the removal of Mn（II） from waste water by complexation-ultrafiltration. The carbo...Copolymer of maleic acid and acrylic acid （PMA-100）, combining with polyvinyl butyral （PVB） ultrafiltration membrane was used for the removal of Mn（II） from waste water by complexation-ultrafiltration. The carboxylic group content of PMA-100 and the rate of complexation reaction were measured. Effects of the mass ratio of PMA-100 to Mn（II） （n）, pH, background electrolyte, etc on the rejection rate （R） and permeate flux （J） were investigated. The results show that carboxylic group content of PMA-100 is 9.5 mmol/g. The complexation of Mn（II） with PMA-100 is rapid and completed within 5 min at pH 6.0. Both R and J increase with pH increasing in the range of 2.5-7.0, and R increases with the increase of n at pH 6.0 while J is little affected. The background electrolyte leads to the decrease of R, and CaCl2 has much greater effect on R than NaCl at the same ionic strength.展开更多
A three-dimensional electrochemical oxidation （3D-EC） reactor with introduction of activated carbon （AC） as particle micro-electrodes was apphed for the advanced treatment of secondary wastewater effluent of a wet...A three-dimensional electrochemical oxidation （3D-EC） reactor with introduction of activated carbon （AC） as particle micro-electrodes was apphed for the advanced treatment of secondary wastewater effluent of a wet-spun acrylic fiber manufacturing plant. Under the optimized conditions （current density of 500 A/m2, circulation rate of 5 mL/min, AC dosage of 50 g, and chloride concentration of 1.0 g/L）, the average removal efficiencies of chemical oxygen demand （CODer）, NH3-N, total organic carbon （TOC）, and ultraviolet absorption at 254 nm （UV2s4） of the 3D-EC reactor were 64.5%, 60.8%, 46.4%, and 64.8%, respectively; while the corresponding effluent concentrations of CODcr, NH3-N, TOC, and UV2s4 were 76.6, 20.1, and 42.5 mg/L, and 0.08 Abs/cm, respectively. The effluent concentration of CODer was less than 100 mg/L, which showed that the treated wastewater satisfied the demand of the integrated wastewater discharge standard （GB 8978-1996）. The 3D-EC process remarkably improved the treatment efficiencies with synergistic effects for CODer, NH3-N, TOC, and UV2s4 during the stable stage of 44.5%, 38.8%, 27.2%, and 10.9%, respectively, as compared with the sum of the efficiencies of a two-dimensional electrochemical oxidation （2D-EC） reactor and an AC adsorption process, which was ascribed to the numerous micro-electrodes of AC in the 3D-EC reactor. Gas chromatography mass spectrometry （GC-MS） analysis revealed that electro- chemical treatment did not generate more toxic organics, and it was proved that the increase in acute biotoxicity was caused primarily by the production of free chlorine.展开更多
文摘A group function relation curve between flux(J) and bulk phase concentration of substrate(S) was set up. The biodegradation kinetic of organic compounds of acrylic fiber wastewater in biofilm is studied(the treatment technology is coagulation/sedimentation-anoxic/aerobic biofilm process), and the results showed that the concentration of non-degradation pollutants in effluent is 77 mg/L. In aerobic zone, the half-rate constant is 72.84 mg/L, the maximum removal rate of organic compounds at unit area filler is very low, 0.089 g/(m 2·d), which corresponds to the fact that there are some biorefractory compounds in the wastewater.
基金Project (21176264) supported by the National Natural Science Foundation of ChinaProject (11JJ2010) supported by Hunan Provincial Natural Science Foundation of ChinaProject (LC13076) supported by Undergraduate Innovation Foundation of Central South University,China
文摘Copolymer of maleic acid and acrylic acid （PMA-100）, combining with polyvinyl butyral （PVB） ultrafiltration membrane was used for the removal of Mn（II） from waste water by complexation-ultrafiltration. The carboxylic group content of PMA-100 and the rate of complexation reaction were measured. Effects of the mass ratio of PMA-100 to Mn（II） （n）, pH, background electrolyte, etc on the rejection rate （R） and permeate flux （J） were investigated. The results show that carboxylic group content of PMA-100 is 9.5 mmol/g. The complexation of Mn（II） with PMA-100 is rapid and completed within 5 min at pH 6.0. Both R and J increase with pH increasing in the range of 2.5-7.0, and R increases with the increase of n at pH 6.0 while J is little affected. The background electrolyte leads to the decrease of R, and CaCl2 has much greater effect on R than NaCl at the same ionic strength.
基金supported by the Major Science and Technology Program for Water Pollution Control and Treatment (No. 2012ZX07201002-6)
文摘A three-dimensional electrochemical oxidation （3D-EC） reactor with introduction of activated carbon （AC） as particle micro-electrodes was apphed for the advanced treatment of secondary wastewater effluent of a wet-spun acrylic fiber manufacturing plant. Under the optimized conditions （current density of 500 A/m2, circulation rate of 5 mL/min, AC dosage of 50 g, and chloride concentration of 1.0 g/L）, the average removal efficiencies of chemical oxygen demand （CODer）, NH3-N, total organic carbon （TOC）, and ultraviolet absorption at 254 nm （UV2s4） of the 3D-EC reactor were 64.5%, 60.8%, 46.4%, and 64.8%, respectively; while the corresponding effluent concentrations of CODcr, NH3-N, TOC, and UV2s4 were 76.6, 20.1, and 42.5 mg/L, and 0.08 Abs/cm, respectively. The effluent concentration of CODer was less than 100 mg/L, which showed that the treated wastewater satisfied the demand of the integrated wastewater discharge standard （GB 8978-1996）. The 3D-EC process remarkably improved the treatment efficiencies with synergistic effects for CODer, NH3-N, TOC, and UV2s4 during the stable stage of 44.5%, 38.8%, 27.2%, and 10.9%, respectively, as compared with the sum of the efficiencies of a two-dimensional electrochemical oxidation （2D-EC） reactor and an AC adsorption process, which was ascribed to the numerous micro-electrodes of AC in the 3D-EC reactor. Gas chromatography mass spectrometry （GC-MS） analysis revealed that electro- chemical treatment did not generate more toxic organics, and it was proved that the increase in acute biotoxicity was caused primarily by the production of free chlorine.
