Railway Point System(RPS)is an important infrastructure in railway industry and its faults may have significant impacts on the safety and efficiency of train operations.For the fault diagnosis of RPS,most existing met...Railway Point System(RPS)is an important infrastructure in railway industry and its faults may have significant impacts on the safety and efficiency of train operations.For the fault diagnosis of RPS,most existing methods assume that sufficient samples of each failure mode are available,which may be unrealistic,especially for those modes of low occurrence frequency but with high risk.To address this issue,this work proposes a novel fault diagnosis method that only requires the power signals generated under normal RPS operations in the training stage.Specifically,the failure modes of RPS are distinguished through constructing a reasoning diagram,whose nodes are either binary logic problems or those that can be decomposed into the problems of the binary logic.Then,an unsupervised method for the signal segmentation and a fault detection method are combined to make decisions for each binary logic problem.Based on the results of decisions,the diagnostic rules are established to identify the failure modes.Finally,the data collected from multiple real-world RPSs are used for validation and the results demonstrate that the proposed method outperforms the benchmark in identifying the faults of RPSs.展开更多
In this study,geochemical anomaly separation was carried out with methods based on the distribution model,which includes probability diagram(MPD),fractal(concentration-area technique),and U-statistic methods.The main ...In this study,geochemical anomaly separation was carried out with methods based on the distribution model,which includes probability diagram(MPD),fractal(concentration-area technique),and U-statistic methods.The main objective is to evaluate the efficiency and accuracy of the methods in separation of anomalies on the shear zone gold mineralization.For this purpose,samples were taken from the secondary lithogeochemical environment(stream sediment samples)on the gold mineralization in Saqqez,NW of Iran.Interpretation of the histograms and diagrams showed that the MPD is capable of identifying two phases of mineralization.The fractal method could separate only one phase of change based on the fractal dimension with high concentration areas of the Au element.The spatial analysis showed two mixed subpopulations after U=0 and another subpopulation with very high U values.The MPD analysis followed spatial analysis,which shows the detail of the variations.Six mineralized zones detected from local geochemical exploration results were used for validating the methods mentioned above.The MPD method was able to identify the anomalous areas higher than 90%,whereas the two other methods identified 60%(maximum)of the anomalous areas.The raw data without any estimation for the concentration was used by the MPD method using aminimum of calculations to determine the threshold values.Therefore,the MPD method is more robust than the other methods.The spatial analysis identified the detail soft hegeological and mineralization events that were affected in the study area.MPD is recommended as the best,and the spatial U-analysis is the next reliable method to be used.The fractal method could show more detail of the events and variations in the area with asymmetrical grid net and a higher density of sampling or at the detailed exploration stage.展开更多
A special method based on the local equilibrium principle has been introduced in the research of the phase diagram of Mn-MnO system.With this method,the problems of volatilization of Mn and the corrosion of Mn and MnO...A special method based on the local equilibrium principle has been introduced in the research of the phase diagram of Mn-MnO system.With this method,the problems of volatilization of Mn and the corrosion of Mn and MnO to refractory materials were prevented efficiently.The solubility of oxygen in Mn and the composition of the interface between MnO and Mn were determined.Partial phase diagram of Mn-MnO system were constructed according to pres- ent experimental results.展开更多
increasing penetration of renewable energy sources with a wide range of operating conditions causing power system uncertainties, conventional controllers are incapable of providing proper performance to keep the syste...increasing penetration of renewable energy sources with a wide range of operating conditions causing power system uncertainties, conventional controllers are incapable of providing proper performance to keep the system stable. However, controllable or dispatchable loads such as electric vehicles （EVs） and heat pumps （HPs） can be utilized for supplementary frequency control. This paper shows the ability of plug-in hybrid EVs, HPs, and batteries （BTs） to contribute in the frequency control of an isolated power system. Moreover, we propose a new online intelligent approach by using a coefficient diagram method （CDM） to enhance the system performance and robustness against uncertainties. The performance of the proposed intelligent CDM control has been compared with the proportional-integral （PI） controller and the superiority of the proposed scheme has been verified in Matiab/Simulink programs.展开更多
Numerical methods commonly used for the calculating phase diagrams were listed. A new method to calculate stable phase diagrams was presented which possesse the advantages of both the New-ton Raphson method and the si...Numerical methods commonly used for the calculating phase diagrams were listed. A new method to calculate stable phase diagrams was presented which possesse the advantages of both the New-ton Raphson method and the simplex method. This method is suitable for the calculation of the stable equilibria in complicated systems. For example. calculated results in comparison with experimental results as well as the prediction of new systems were shown in the present work展开更多
Experimental and theoretical studies of the mechanisms of vibration stimulation of oil recovery in watered fields lead to the conclusion that resonance oscillations develop in fractured-block formations. These oscilla...Experimental and theoretical studies of the mechanisms of vibration stimulation of oil recovery in watered fields lead to the conclusion that resonance oscillations develop in fractured-block formations. These oscillations, caused by weak but long-lasting and frequency-stable influences, create the conditions for ultrasonic wave’s generation in the layers, which are capable of destroying thickened oil membranes in reservoir cracks. For fractured-porous reservoirs in the process of exploitation by the method of water high-pressure oil displacement, the possibility of intensifying ultrasonic vibrations can have an important technological significance. Even a very weak ultrasound can destroy, over a long period of time, the viscous oil membranes formed in the cracks between the blocks, which can be the reason for lowering the permeability of the layers and increasing the oil recovery. To describe these effects, it is necessary to consider the wave process in a hierarchically blocky environment and theoretically simulate the mechanism of the appearance of self-oscillations under the action of relaxation shear stresses. For the analysis of seism acoustic response in time on fixed intervals along the borehole an algorithm of phase diagrams of the state of many-phase medium is suggested.展开更多
基金supported by National Key R&D Program of China(2022YFB2602203)Talent Fund of Beijing Jiaotong University(2021RC274,I22L00131)National Natural Science Foundation of China(U1934219,52202392,52022010,U22A2046,52172322,62271486,62120106011,52172323)。
文摘Railway Point System(RPS)is an important infrastructure in railway industry and its faults may have significant impacts on the safety and efficiency of train operations.For the fault diagnosis of RPS,most existing methods assume that sufficient samples of each failure mode are available,which may be unrealistic,especially for those modes of low occurrence frequency but with high risk.To address this issue,this work proposes a novel fault diagnosis method that only requires the power signals generated under normal RPS operations in the training stage.Specifically,the failure modes of RPS are distinguished through constructing a reasoning diagram,whose nodes are either binary logic problems or those that can be decomposed into the problems of the binary logic.Then,an unsupervised method for the signal segmentation and a fault detection method are combined to make decisions for each binary logic problem.Based on the results of decisions,the diagnostic rules are established to identify the failure modes.Finally,the data collected from multiple real-world RPSs are used for validation and the results demonstrate that the proposed method outperforms the benchmark in identifying the faults of RPSs.
文摘In this study,geochemical anomaly separation was carried out with methods based on the distribution model,which includes probability diagram(MPD),fractal(concentration-area technique),and U-statistic methods.The main objective is to evaluate the efficiency and accuracy of the methods in separation of anomalies on the shear zone gold mineralization.For this purpose,samples were taken from the secondary lithogeochemical environment(stream sediment samples)on the gold mineralization in Saqqez,NW of Iran.Interpretation of the histograms and diagrams showed that the MPD is capable of identifying two phases of mineralization.The fractal method could separate only one phase of change based on the fractal dimension with high concentration areas of the Au element.The spatial analysis showed two mixed subpopulations after U=0 and another subpopulation with very high U values.The MPD analysis followed spatial analysis,which shows the detail of the variations.Six mineralized zones detected from local geochemical exploration results were used for validating the methods mentioned above.The MPD method was able to identify the anomalous areas higher than 90%,whereas the two other methods identified 60%(maximum)of the anomalous areas.The raw data without any estimation for the concentration was used by the MPD method using aminimum of calculations to determine the threshold values.Therefore,the MPD method is more robust than the other methods.The spatial analysis identified the detail soft hegeological and mineralization events that were affected in the study area.MPD is recommended as the best,and the spatial U-analysis is the next reliable method to be used.The fractal method could show more detail of the events and variations in the area with asymmetrical grid net and a higher density of sampling or at the detailed exploration stage.
文摘A special method based on the local equilibrium principle has been introduced in the research of the phase diagram of Mn-MnO system.With this method,the problems of volatilization of Mn and the corrosion of Mn and MnO to refractory materials were prevented efficiently.The solubility of oxygen in Mn and the composition of the interface between MnO and Mn were determined.Partial phase diagram of Mn-MnO system were constructed according to pres- ent experimental results.
文摘increasing penetration of renewable energy sources with a wide range of operating conditions causing power system uncertainties, conventional controllers are incapable of providing proper performance to keep the system stable. However, controllable or dispatchable loads such as electric vehicles （EVs） and heat pumps （HPs） can be utilized for supplementary frequency control. This paper shows the ability of plug-in hybrid EVs, HPs, and batteries （BTs） to contribute in the frequency control of an isolated power system. Moreover, we propose a new online intelligent approach by using a coefficient diagram method （CDM） to enhance the system performance and robustness against uncertainties. The performance of the proposed intelligent CDM control has been compared with the proportional-integral （PI） controller and the superiority of the proposed scheme has been verified in Matiab/Simulink programs.
文摘Numerical methods commonly used for the calculating phase diagrams were listed. A new method to calculate stable phase diagrams was presented which possesse the advantages of both the New-ton Raphson method and the simplex method. This method is suitable for the calculation of the stable equilibria in complicated systems. For example. calculated results in comparison with experimental results as well as the prediction of new systems were shown in the present work
文摘Experimental and theoretical studies of the mechanisms of vibration stimulation of oil recovery in watered fields lead to the conclusion that resonance oscillations develop in fractured-block formations. These oscillations, caused by weak but long-lasting and frequency-stable influences, create the conditions for ultrasonic wave’s generation in the layers, which are capable of destroying thickened oil membranes in reservoir cracks. For fractured-porous reservoirs in the process of exploitation by the method of water high-pressure oil displacement, the possibility of intensifying ultrasonic vibrations can have an important technological significance. Even a very weak ultrasound can destroy, over a long period of time, the viscous oil membranes formed in the cracks between the blocks, which can be the reason for lowering the permeability of the layers and increasing the oil recovery. To describe these effects, it is necessary to consider the wave process in a hierarchically blocky environment and theoretically simulate the mechanism of the appearance of self-oscillations under the action of relaxation shear stresses. For the analysis of seism acoustic response in time on fixed intervals along the borehole an algorithm of phase diagrams of the state of many-phase medium is suggested.
