Investigation on the seismic response of nuclear power stations with a pile-raft foundation using centrifuge tests

Research to reliably predict the seismic response of nuclear power stations with a pile-raft foundation is needed to meet the high safety requirements of nuclear power stations.In this study,a scaled superstructure with a 4×3 pile-raft foundation,which is constructed in Shanxi kaolin clay,is modelled.Accordingly,the characteristics of seismic response for nuclear power stations with a pile-raft foundation are analyzed using dynamic centrifuge tests.In particular,multiple earthquake motions with different magnitudes and frequency properties are utilized to map the relationship between structural response and properties of earthquake motions.The results show that the seismic response of the soil,raft,and structure are significantly affected by the natural frequency and magnitude of the earthquake motion.The soil surface acceleration is lower than the raft acceleration.The results provide a reliable reference to better understand the seismic response of nuclear power stations.

Analytical evaluation and experimental validation on dynamic rocking behavior for shallow foundation considering structural response

The challenge in the practical application of rocking foundations is the estimation of its performance,particularly the rotation angle,during a strong earthquake.In this study,the dynamic rocking behavior for a shallow foundation considering structural response was evaluated through two analytical approaches:the conventional soil-foundation-structure interaction(SFSI)governing equation of a single-degree-of-freedom(SDOF)structure on a rocking shallow foundation,and the Housner rocking model(i.e.,a rocking rigid block on a rigid base).Both approaches were validated with dynamic centrifuge tests.The test models consisted of a soft soil deposit,a shallow rectangular foundation,and an SDOF structure dominated by a bending behavior.A total of 11 foundation-structure systems and six seismic waves,including recorded earthquake signals and sinusoidal waves,were utilized.The results showed that the conventional SFSI equation well predicted the maximum rotation during strong earthquakes.However,this method was less accurate regarding the rotational phase information and maximum rotation of the foundation during weak earthquakes.On the other hand,although the modified Housner′s rocking model required five parameters relevant to a soil-foundation-structure system,it overestimated the maximum rotation of the foundation when compared with the results from dynamic centrifuge tests.

Seismic performances of dyke on liquefiable soils

Various field investigations of earthquake disaster cases have confirmed that earthquake-induced liquefaction is a main factor causing significant damage to dyke,research on seismic performances of dyke is thus of great importance.In this paper,seismic responses of dyke on liquefiable soils were investigated by means of dynamic centrifuge model tests and three-dimensional（3D） effective stress analysis method which is based on a multiple shear mechanism model and a liquefaction front.For the prototype scale centrifuge tests,sine wave input motions with peak accelerations 0.806 m/s2,1.790 m/s2 and 3.133 m/s2 of varied amplitudes were adopted to study the seismic performances of dyke on the saturated soil layer foundation with relative density of approximately 30%.Then,corresponding numerical simulations were conducted to investigate the distribution and variations of deformation,acceleration,excess pore-water pressure（EPWP）,and behaviors of shear dilatancy in the dyke and the liquefiable soil foundation.Moreover,detailed discussions and comparisons between numerical simulations and centrifuge tests were also presented.It is concluded that the computed results have a good agreement with the measured results by centrifuge tests.The physical and numerical models both indicate that the dyke hosted on liquefiable soils subjected to earthquake motions has exhibited larger settlement and lateral spread：the stronger the motion is,the larger the dyke deformation is.Compared to soils in the deep ground under the dyke and the free field,the EPWP ratio is much smaller in the shallow liquefiable soil beneath the dyke in spite of large deformation produced.For the same overburden depth soil from free site and the liquefiable foundation beneath dyke,the characteristics of effective stress path and stress-strain relations are different.All these results may be of theoretical and practical significance for seismic design of the dyke on liquefiable soils.

Geographically distributed hybrid testing & collaboration between geotechnical centrifuge and structures laboratories

Distributed Hybrid Testing（DHT） is an experimental technique designed to capitalise on advances in modern networking infrastructure to overcome traditional laboratory capacity limitations. By coupling the heterogeneous test apparatus and computational resources of geographically distributed laboratories, DHT provides the means to take on complex, multi-disciplinary challenges with new forms of communication and collaboration. To introduce the opportunity and practicability afforded by DHT, here an exemplar multi-site test is addressed in which a dedicated fibre network and suite of custom software is used to connect the geotechnical centrifuge at the University of Cambridge with a variety of structural dynamics loading apparatus at the University of Oxford and the University of Bristol. While centrifuge time-scaling prevents real-time rates of loading in this test, such experiments may be used to gain valuable insights into physical phenomena, test procedure and accuracy. These and other related experiments have led to the development of the real-time DHT technique and the creation of a flexible framework that aims to facilitate future distributed tests within the UK and beyond. As a further example, a real-time DHT experiment between structural labs using this framework for testing across the Internet is also presented.