Predicting landslide scenes under potential earthquake scenarios in the Xianshuihe fault zone, Southwest China

Earthquake-induced landslides can seriously aggravate the earthquake's destructive consequences and have caused widespread concern in recent decades. The Xianshuihe fault is a large active left-lateral strike-slip fault in the southeast margin of Qinghai-Tibet Plateau, Southwest China, where the frequent strong earthquakes have brought abundant geo-hazards. This study focuses mainly on exploring and predicting the landslide scenes induced by the potential earthquakes. Firstly, the sophisticated Newmark model is improved through landslide cases induced by the Ms7.9 Luhuo earthquake in 1973 to adapt the field seismotectonics of the Xianshuihe fault zone. Then, it is used to predict the landslide scenes under one speculated potential earthquake scenario with the similar focal mechanism with the Luhuo earthquake. The preliminary results show that the slope displacement resulted from Newmark model can reflect spatial distribution characteristics ofearthquake-induced landslides. The predicted potential earthquake-induced landslide scenes present an obvious extending trend along the Xianshuihe fault. The landslide hazard is greater in the northeast regions than southwest regions of the Xianshuihe fault, where there are more complex topographic conditions. The study procedure will be a helpful demonstration for exploration and prediction of landslide scenes under potential earthquakes in the regions with high seismic activity.

In search of potential earthquake source regions in the Chinese mainland in the light of ambient shear stress field

Earth media are incomplete media.There exist many cracks in it. The achievements of fracture mechanics showthat the strength of the incomplete materials will be much lower than that of the complete materials. We consider that earthquake occurrence is the result of unstable propagation of a crack in crust media in proper conditionand the earthquake rupture is the phenomenon of a failure by fast fracture under applied low shear stress. It hasalready been explained by fracture mechanics.The occurrence of failure by fast fracture is necessarily associated with the presence of high level concentration of local stress and strain. The elastic/plastic stress analysis in cracked pieces by Dugdale indicates that thestate of stress at the tip of a crack takes a very important role to crack propagation. A plastic zone has necessarilyformed in the tip of a crack due to stress concentration. Therefore, the dislocations st the tip of a crack are naturally a plastic displacement, rather than elastic one. The plastic displacement, where τ0 is appliedshear stress which is equivalent to initial or tectonic shear stress when the quake occurs, a is the half length of acrack, It is the rigidity,τy is the yield stresses in shear. The main seismic dislocations take place exactly at theends of the crack where the plastic zone had been formed. SO, a critical assumption is adopted, i. e. we assumethe dislocation D(1,,t) as formula (5) in text. The maximum earthquake dislocation, whereL is the fault length. If p is taken the value in the upper crust, μ=33 GPa; and τy is taken the average valuegiven from laboratories,τy= 30 MPa. Thus, according to observation values of Dmax and L, using the formula,one can estimate the initial shear stresses for large earthquakes. Computations show that the initial shear stressesfor large earthquakes all over the world are about 5-20 MPa which have some differences between regions.We further research the characteristics of source spectra and have derived the dependent relation of bodywave magnitude mb on the shear stress τ0 and seismic moment M, as formula (11)in text. Thus, the formulaprovides a POssibility of computation of large amount of tectonic shear stress values from seismic data. We consider that the tectonic shear stress field is a main factor which controls the earthquake occurrence. The regions withhigh tectonic shear stress values are considered to be prone to occur great earthquakes (Ms>6) and called earthquake hazard regions. Based on this criterion, τ0 values for all earthquakes with mb≥3. 8 all over China since1987 have been computed, and the great earthquake hazard regions with magnitude ranges have been zoned inthe Chinese mainland.During April 1992 -January 31, 1994, there were 9 Ms≥6 earthquakes which occurred in the Chinesemainland, 8 earthquakes of the 9 had fallen into the regions delineated by us prior to the earthquake occurrence,with only one failure. This new approach as a method for medium--term prediction of strong earthquakes hasbeen proved by practice to be an efficient one.It has good physical bases and bright prospect and worth furtherresearch. Received February 7,1994 1 Accepted February 10, 1995.Contribution No. 95A0061, Institute of Geophysics,SSB, China.

Seismic Risk Assessment and Maximum Magnitudes of Potential Earthquakes on Active Faults near Lanzhou City

The Zhuanglang river and Baiyin Baiyangshu river faults are late Quaternary faults near Lanzhou city, which pose a threat to the safety of the city. However, the cause of medium- strong earthquakes along the fault is rather complicated and even uncertain. It is important for us how to assess the magnitudes of maximum potential earthquakes and the seismic risk of the faults. The authors make reference to the method that Wen Xueze, et ai. （2007） developed to assess the magnitudes of maximum potential earthquakes in sub-areas of moderately and weakly active faults in the eastern Chinese Mainland, and brought forward an empirical relationship between the maximum magnitudes Mmax and the at/b values of the sub-areas＇ frequency- magnitude relationships in the Lanzhou area. By using this empirical relationship, the authors have estimated the upper-limits Mu of the Zhuanglang river and Baiyin Baiyangshu river active faults near Lanzhou city as Ms6.9 and 6.3, respectively. In addition, they have assessed the average interval recurrence time and the probabilities of destructive earthquakes on the faults.

Is the September 5,2022,Luding MS6.8 earthquake an‘unexpected’event?

After the September 5,2022(Beijing time).Luding Ms6.8 earthquake(29.59°N.102.08°E.depth 16 km.according to the initial determination by the China Earthquake Networks Center(CENC)).field investigation was carried out by the China Earthquake Administration(CEA).which associated the earthquake to the Moxi segment on the south part of the Xianshuihe fault system.This segment,with horizontal slip rate 5-10 mm/a.locates in the convergent part among the Xianshuihe fault.

Crustal Stress Evolution over the Past 700 Years in North China and Earthquake Occurrence

Fault interaction and earthquake occurrence have attracted much attention in seismological community during recent years. Many studies have shown that the rupture of one fault could encourage or discourage earthquake nucleation on a neighboring fault, depending on the relative geometry of the two faults and the earthquake rupture mechanisms. In this paper, we simulate the evolutionary process of cumulative Coulomb failure stress change （ CCFSC ） in North China since 1303, manifested by secular tectonic stress loading and occurrence of large earthquakes. Secular tectonic stress loading is averaged from crustal strain rates derived from GPS. Fault rupture parameters of historical earthquakes are estimated as follows： the earthquake rupture length and the amount of slip are derived based on their statistical relationships with the earthquake intensity distribution and magnitude, calibrated using parameters of instrumentally measured contemporary earthquakes. The earthquake rake angle is derived based on geologically determined fault orientational parameters and seismically estimated orientation of regional tectonic stresses. Assuming a layered visco-elastic medium, we calculate stress evolution resulting from secular tectonic loading and coseismic and postseismic deformation. On the eve of each large earthquake, the accumulated stress field is projected to the fault surface of that earthquake and the CCFSC is evaluated to assess the triggering effect of CCFSC. Forty-nine earthquakes with M≥6.5 have occurred in North China since 1303. Statistics shows that 39 out of the 48 subsequent events were triggered by positive CCFSC, yielding a triggering rate of 81.3%. If we use the accumulative stress field to evaluate the CCFSC for the M ≥ 5.0 earthquakes that occurred in North China since 1303, we find that 75.5% of those events were triggered. The triggering rate for the M ≥ 5.0 earthquakes after the 1976 Ninghe earthquake is up to 82.1%. The triggering rates can be higher if corrections are made for some aftershocks which were wrongly identified as occurring in stress shadow zones because of errors in parameter estimates of historical earthquakes. Our study shows a very high correlation between positive CCFSC and earthquake occurrences. Relatively high CCFSC in North China at present is concentrated around the Bohai Sea, the west segment of the Northern Qinling fault, the western end of the Zhangjiakou-Bohai Sea seismic zone, and the shiyuan basin, Shanxi graben, suggesting relatively higher earthquake potential in these areas.

Some considerations on the physical mea-sure of seismic intensity

The study on seismic intensity can be traced prior to the time that modern seismology was established. In its early stage the seismic intensity was designed to serve as a measure in scaling the severity of earthquake damage to civil engineering and environmental structures. Also the seismic intensity is usually assigned by engineers and seismologists with one or two characteristic parameters of earthquake ground motions to reflect earthquake damage potential so as to be able to serve as an input earthquake load for seismic design of structures. So choosing a proper parameter to reflect the action of seismic intensity is the main objective of the research on physical measure of seismic intensity. However, since various kinds of structures have quite different damage mechanisms, there will exist great differences in damages to different structures located at the same area during the same earthquake. Particularly, in some cases, quite different damages have happened even to the structures of same kind due to many other factors such as different construction materials, different configurations or on the different types of sites where structures located. In addition, the ground motion parameters, which result in damage to structures, are not the single peak value of ground motion. Hence, this paper emphasizes that the research on new physical measure of seismic intensity should not only consider the structural characteristics but also take into account other parameters such as duration, energy of ground motion and so on. In particular, as the physical measures of intensity, different ground motion parameter should be adopted for different structures.

Ambient tectonic shear stress field in Southern California and seismic hazard regions

ccording to the fracture mechanics rupture model of earthquakes put forward by us, several equations to compute tectonic ambient shear stress value τ0 have been derived [equations (1), (2), (3), (5)].τ0 values for intermediate and small earthquakes occurred in Chinese mainland and Southern California have been calculated by use of these equations. The results demonstrate that the level and distribution of τ0 are closely related to the location where large earthquakes will occur, i.e. the region with higher level of τ0 will be prone to occur large earthquakes and the region with lower level will usually occur small earthquakes. According to the spatial distribution of τ0 , the seismic hazard regions or the potential earthquake source regions can in some degree be determined. According to the variation of τ0 with time, the large earthquake occurrence time can be roughly estimated. According to the distribution of τ0 in Southern California and variation with time, three high stress level regions are determined, one (Goldfield area) of them is the present seismic hazard region.

Fault－weakening effect of reservoir temperature of hot spring and its influence on seismic activities

In this paper, the reservoir temperatures of 14 hot spring samples collected from the northern segment of theRed River Fault are calculated by using the mixing-model of SiO2-geothermometer. Based on the features ofreservoir temperatures and densities of hot springs, the northern segment of the Red River Fault is furtherdivided into 4 sub-segments. The influence of weakening effect of water on seismic activities is discussed fromthe view point of fault-weakening effect of water. It is suggested that the difference in seismic activity between various sub-segments is principally caused by the difference in intensity of the fault-weakening effect ofwater of these sub-segments. The Eryuan sub-segment where the reservoir temperatures are high and the hotsprings are dense corresponds to a slipped region, however, the Jianchuan and Midu sub-segments where thereservoir temperatures are lower and the hot springs are fewer as well as the Dan sub-segment where the hotspring are very few all correspond to locked regions. It is suggested that Dan sub-segment is the riskiest region for strong earthquake preparation, while the possibility for strong earthquake preparation is very little inthe Eryuan sub-segment.