Effects of Different Vegetable Planting Modes on Soil Microbial Flora and Enzyme Activity

To investigate the effects of different vegetable growing regions and planting modes on soil quality,soils in high,medium and low altitude areas of Guizhou were respectively sampled under different vegetable efficient planting modes,and the variations of soil microbial flora and enzyme activities were analyzed. The soil microbial count and total bacteria of the vegetable efficient cultivation mode were significantly higher than that of the control （traditional planting mode） in each planting area,and the microbial diversity index was also improved to varying de- grees.The soil phosphatase,catalase and urease activities of the vegetable efficient planting mode were higher than that of the control.The soil catalase and urease activities were higher than that of the control by 1.37-1.44 and 1.51-2.80 times. Application of vegetable efficient planting mode in different regions will help to im- prove the soil quality in a given period.

On the Design and Optimization of a Clean and Efficient Combustion Mode for Internal Combustion Engines through a Computer NSGA-Ⅱ Algorithm

In order to address typical problems due to the huge demand of oil for consumption in traditional internal combustion engines,a new more efficient combustion mode is proposed and studied in the framework of Computational Fluid Dynamics(CFD).Moreover,a Non-dominated Sorting Genetic Algorithm(NSGA-Ⅱ)is applied to optimize the related parameters,namely,the engine methanol ratio,the fuel injection time,the initial temperature,the Exhaust Gas Re-Circulation(EGR)rate,and the initial pressure.The so-called Conventional Diesel Combustion(CDC),Homogeneous Charge Compression Ignition(HCCI)and the Reactivity Controlled Compression Ignition(RCCI)combustion modes are compared.The results show that RCCI has a higher methanol ratio and an earlier injection timing with moderate EGR rate and higher initial pressure.The initial temperature increases as the methanol ratio increases.In comparison,CDC has the lowest hydrocarbon and CO emissions and the highest combustion efficiency.At different crankshaft rotation angles corresponding to 50%of the combustion amount(CA50),the combustion temperature and boundary layer temperature of HCCI change significantly,while those of RCCI undergo limited variations.At the same CA50,the exergy losses of HCCI and RCCI are lower than that of the CDC.On the basis of these findings,it can be concluded that the methanol/diesel RCCI engine can be used to obtain a clean and efficient combustion process,which should be regarded as a promising combustion mode.

A comparison of the energy consumption and carbon emissions for different modes of transportation in open-cut coal mines

Transportation accounts for 80% of open-cut coal mine carbon emissions. With regard to the energy con- sumption and carbon emissions of transportation within an open-cut mine, this paper systematically compared the work and energy consumption of a truck and belt conveyor on a theoretical basis, and con- structed a model to calculate the energy consumption of open-cut mine transportation. Life cycle carbon emission factors and power consumption calculation model were established through a Process Analysis- Life Cycle Analysis （PA-LCA）. The following results were obtained： （1） the energy consumption of truck transportation was four to twelve times higher than that of the belt conveyor; （2） the C02 emissions from truck transportation were three to ten times higher than those of the belt conveyor; （3） with the increase in the slope angle for transportation, the ratio of truck to belt conveyor for both energy consumption and carbon emissions gradually decreased; （4） based on 2013 prices in China, the energy cost of transportation using a belt conveyor in open-cut coal mines could save 0.6-2.4 Yuan/（t kin） compared to truck transportation.

Energy Efficiency Optimization in Relay-Assisted Networks with Energy Harvesting Relay Constraints

In this paper we consider data transmission in a decode-and-forward(DF)relay-assisted network in which the relay is energy harvesting(EH) powered while the base station(BS) is power-grid powered.Our purpose is to maximize the BS's energy efficiency(EE) while making full use of the relay's renewable energy and satisfying the specific average throughput requirements.In contrast to existing literature on energy harvesting system which only considers the radio transmission power,we take the static circuit power into account as well.We formulate the EE optimization problem and prove that the EE of the BS and relay are both quasiconvex in the instantaneous transmission rate.Then we divide the complex optimization problem into two point-to-point link level optimization parts and propose an energyefficient resource allocation(EERA) scheme in which power control and sleep mode management are jointly used.The simulation results demonstrate that EERA may achieve good energy saving effects.We also compare the EE of an energy harvesting relay system with a power-grid powered one and provide more insight into the EE problem of energy harvesting relay system.

An Efficient Three-Dimensional Coupled Normal Mode Model and Its Application to Internal Solitary Wave Problems

We present an efficient three-dimensional coupled-mode model based on the Fourier synthesis technique. In principle, this model is a one-way model, and hence provides satisfactory accuracy for problems where the forward scattering dominates. At the same time, this model provides an efficiency gain of an order of magnitude or more over two-way coupled-mode models. This model can be applied to three-dimensional range-dependent problems with a slowly varying bathymetry or internal waves. A numerical example of the latter is demonstrated in this work. Comparisons of both accuracy and efficiency between the present model and a benchmark model are also provided.

Impacts of Corporate Culture on Merger

By studying the cultural background and corporate culture in China, Japan and USA, this paper analyzes the effects of cultural background and corporation culture on the transaction cost and the efficiency of control right, thus shows that cultural backgrounds have great impact on merger. This paper further studies the choice and application of the mode of culture combination of the transnational merger.

Efficient separating orbital angular momentum mode with radial varying phase

It is shown that orbital angular momentum(OAM) is a promising new resource in future classical and quantum communications. However, the separation of OAM modes is still a big challenge. In this paper, we propose a simple and efficient separation method with a radial varying phase. In the method, specific radial varying phases are designed and modulated for different OAM modes. The resultant beam is focused to the spots with different horizontal and vertical positions after a convex lens, when the coordinate transformation, including two optical elements with coordinate transformation phase and correct phase, operates on the received beam.The horizontal position of the spot is determined by the vortex phases, and the vertical position of the spot is dependent on the radial varying phases. The simulation and experimental results show that the proposed method is feasible both for separation of two OAM modes and separation of three OAM modes. The proposed separation method is available in principle for any neighboring OAM modes because the radial varying phase is controlled. Additionally, no extra instruments are introduced, and there is no diffraction and narrowing process limitation for the separation.

Three-dimensional computational fluid dynamics （volume of fluid） modelling coupled with a stochastic discrete phase model for the performance analysis of an invert trap experimentally validated using field sewer solids

Invert traps are used to trap sewer solids flowing into a sewer drainage system, The performance of the invert trap in an open rectangular channel was experimentally and numerically analysed using field sewer solids collected from a sewer drain. Experiments showed that the free water surface rises over the central opening （slot） of the invert trap, which reduces the velocity near the slot and allows more sediment to be trapped in comparison with the case for the fixed-lid model （assuming closed conduit flow with a shear-free top wall） used by earlier investigators. This phenomenon cannot be modelled using a closed conduit model as no extra space is provided for the fluctuation of the water surface, whereas this space is provided in the volume of fluid （VOF） model in the form of air space in ANSYS Fluent 14.0 software. Additionally, the zero atmospheric pressure at the free water surface cannot be modelled in a fixed-lid model. In the present study, experimental trap efflciencies of the invert trap using field sewer solids were fairly validated using a three-dimensional computational fluid dynamics model （VOF model） coupled with a stochastic discrete phase model. The flow field （i.e., velocities） predicted by the VOF model were compared with experimental velocities obtained employing particle image velocimetry. The water surface profile above the invert trap predicted by the VOF model was found to be in good agreement with the experimentally measured profile. The present study thus showed that the VOF model can be used with the stochastic discrete phase model to well predict the performance of invert traps.