First-Order Symmetry Energy Induced by Neutron-Proton Mass Difference

The 1st-order symmetry energy coefficient of nuclear matter induced merely by the neutron-proton （n p） mass difference is derived analytically, which turns out to be completely model-independent. Based on this result, （npDM） the 1st-order symmetry energy Esym,1 （A） of heavy nuclei such as 2~spb induced by the np mass difference is investigated with the help of a local density approximation combined with the Skyrme energy density functionals. Although /U（npDM） Esym,1 （A） is small compared with the second-order symmetry energy, it cannot be dropped simply for an accurate estimation of nuclear masses as it is still larger than the rms deviation given by some accurate mass formulas. It is therefore suggested that one perhaps needs to distinguish the neutron mass from the proton one in the construction of nuclear density funetionals.

Energy Scaling of Terahertz Pulses Produced through Difference Frequency Generation

We study the energy scaling of terahertz (THz) emission through difference frequency generation of near-infrared pulses, and demonstrate that Gigawatt few-cycle THz transients at the central frequency of 30 THz are produced from GaSe crystal pumped by two pulses at 1.65 and 1.95 micrometers, with the high quantum yield of 28%. Our analysis indicates that the high yield of DFG originates from the largely reduced group velocity mismatch as the long-wavelength pumping pulses are employed.

Assessment of Flue Gas Reinjecting Operating Strategy in Performance of CCHP System using Energy Level Difference Analysis

A proper operating strategy is helpful to improve the off-design performance of combined cooling,heating and power(CCHP)systems,providing high efficiency and low emission.The energy level difference graphic analysis method is used to identify energy level as well as exergy destruction of the part-load process.This method illustrates the energy efficiency upgrading mechanism of the flue gas reinjecting(FGR)operating strategy.It is referenced to a reducing turbine inlet temperature(TIT)operating strategy.By comparison,the FGR operating strategy leads to a 2.62%exergy distribution reduction in a gas turbine at an 85%load level due to the decrease of the energy level difference.When the output power is reduced further,the FGR operating strategy is supplanted by the TIT operating strategy with the limit of compressor inlet temperature.However,the opposite results of exergy distribution are presented in the exhaust-heat recovery devices.A heat-driven refrigeration and power cycle is introduced in a typical CCHP system as a solution.Moreover,the results suggest that the operational flexibility of the CCHP system is improved by enlarging the ratio of cooling to electricity.

Contributions of optimized tensor interactions on the binding energies of nuclei

The tensor parts of Skyrme interactions are constrained from the collective charge-exchange spin-dipole and Gamow-Teller excitation energies in 90Zr and 208Pb,together with the isotopic dependence of energy splitting between proton h11=2 and g7=2 single-particle orbits along the Z=50 isotopes.With the optimized tensor interactions,the binding energies of spherical or weakly deformed nuclei with A=54-228 are studied systematically.The present results show that the global effect of tensor interaction is attractive and systematically increases the binding energies of all these nuclei and makes the nuclei more bound.The root mean squared deviation of the calculated binding energies from the experimental values is significantly improved by the optimized tensor interactions,and the contribution of the tensor interaction to the binding energy is estimated.

QUANTITATIVE METHODOLOGY FOR STABILITY ANALYSIS OF NONLINEAR ROTOR SYSTEMS

Rotor-bearings systems applied widely in industry are nonlinear dynamic systems of multi-degree-of-freedom. Modem concepts on design and maintenance call for quantitative stability analysis. Using trajectory based stability-preserving and dimensional-reduction, a quantitative stability analysis method for rotor systems is presented. At first, an n-dimensional nonlinear non-autonomous rotor system is decoupled into n subsystems after numerical integration. Each of them has only onedegree-of-freedom and contains time-varying parameters to represent all other state variables. In this way, n-dimensional trajectory is mapped into a set of one-dimensional trajectories. Dynamic central point （DCP） of a subsystem is then defined on the extended phase plane, namely, force-position plane. Characteristics of curves on the extended phase plane and the DCP＇s kinetic energy difference sequence for general motion in rotor systems are studied. The corresponding stability margins of trajectory are evaluated quantitatively. By means of the margin and its sensitivity analysis, the critical parameters of the period doubling bifurcation and the Hopf bifurcation in a flexible rotor supported by two short journal bearings with nonlinear suspensionare are determined.

Effects of Microalloying on Glass Forming Ability and Thermodynamic Fragility of Cu-Pr-Based Amorphous Alloys

The effects of microalloying of Ti and B on the glass formation of Cu60Pr30Ni10Al10-2xTixBx（x = 0, 0.05% （atom fraction）） amorphous alloys was investigated using differential scanning calorimetry （DSC） and X-ray diffraction （XRD）. XRD analysis showed that mieroalloying with 0.05% Ti and 0.05% B improved the glass forming ability （GFA）. The smaller difference in the Gibbs free energy between the liquid and crystalline states at the glass transition temperature （△G1-X（Tg）） and the smaller thermodynamic fragility index （△Sf/Tm, where ASf is the entropy of fusion, and Tm is the melting temperature） after mieroalloying correlated with the higher GFA.

Different Charging-Induced Modulations of Highest Occupied Molecular Orbital Energies in Fullerenes in Comparison with Carbon Nanotubes and Graphene Sheets

The highest occupied molecular orbital（HOMO） energies of fullerenes are found by quantitative first-principles calculations to be raised by negative charging, and the rising rate rank of the fullerenes is C60 >C70 >C80 >C90>C100 >C180. Then we compare fullerenes with carbon nanotubes（CNTs） and graphene sheets（GSs） and find that the increase of the HOMO energy of a fullerene is much faster than that of CNTs and graphene sheets with the same number of C atoms. The rising rate rank is fullerene>CNT>GS, which holds no matter what the number of C atoms is or which structure the fullerene isomer is. This work paves a new path for developing all-carbon devices with low-dimensional carbon nanomaterials as different functional elements.

Ground-state mass of ^(22)Al and test of state-of-the-art ab initio calculations

The ground-state mass excess of the T_(z)=−2 drip-line nucleus ^(22)Al is measured for the first time as 18103(10)keV using the newly-developed Bρ-defined isochronous mass spectrometry method at the cooler storage ring in Lanzhou.The new mass excess value allowed us to determine the excitation energies of the two low-lying 1+states in ^(22)Al with significantly reduced uncertainties of 51 keV.When compared to the analogue states in its mirror nucleus ^(22)F,the mirror energy differences of the two 1^(+)states in the ^(22)Al-^(22)F mirror pair are determined to be−625(51)keV and−330(51)keV.The excitation energies and mirror energy differences are used to test the state-of-the-art ab initio valence-space in-medium similarity renormalization group calculations with four sets of interactions derived from the chiral effective field theory.The mechanism leading to the large mirror energy differences is investigated and attributed to the occupation of theπs_(1/2) orbital.

Correlation between solubility parameters and recovery of phenolic compounds from fast pyrolysis bio-oil by diesel extraction

Fast pyrolysis bio-oils(fpBO)were extracted with two alternative commercial transportation fuels,hydrocarbon diesel and bio-diesel.The extraction of fpBO with commercial diesel fuel provided a yield of 4.3 wt%,but the yield increased significantly to 26.6 wt%when bio-diesel was the extractant.The molecular weight of fpBO before and after extraction were consistent with the loss of a more soluble,low molecular weight fraction from the crude fpBO.The relative energy difference(RED),based on the Hansen solubility parameter(HSP),is used to examine the extraction efficiency of specific compounds in the two different‘solvents’.Differences in the RED values could be used to rationalize differences in the partitioning of common fpBO phenolics.