Effect of partial pit exhaust ventilation system on ammonia removal ratio and mass transfer coefficients from different emission sources in pig houses

A partial pit exhaust ventilation(PPEV)system installed below the slatted floor has been widely used in fattening pig barns nowadays in Denmark.Experimental tests showed that annually around 50%of ammonia emissions was collected by PPEV system.However,the percent of emissions collected by PPEV system from different emission sources including slurry manure surfaces,top surfaces,bottom surfaces and side surfaces of the slatted floor has not been investigated as well as the mass transfer coefficients.This study applied CFD modeling to investigate the removal ratio of ammonia emissions from four emission surfaces including the top,side,bottom surfaces of the slatted floor and slurry manure surfaces.The CFD model was validated by experimental air speeds measured in a room equipped with two full-scale pigpens.The validated CFD model was further adopted to simulate cases under five ventilation rates(2000-4000 m^(3)/h),four emission sources and two locations of PPEV system exhaust.The results showed that the removal ratios of ammonia emissions by PPEV system from the four emission sources were generally higher for the cases that the PPEV exhaust was installed opposite to the air supplier than the values of those cases that the PPEV exhaust was located at the same side of side wall air supplier.The removal ratios of ammonia emissions were the highest with the emission source of slurry manure surface and generally 30%higher than the values of other cases.The mass transfer coefficients with the emission sources on the side surfaces of the slatted floor were the largest.The results indicated that the airflow patterns and locations of emission sources greatly influenced the removal ratios of ammonia emissions and ammonia mass transfer coefficients.

Temperature-insensitive fiber cantilever vibration sensor based on a fiber-to-fiber structure

A simple optical fiber cantilever vibration sensor consisting of two opposite aligned bare optical fibers sealed in a quartz capillary is presented.The fiber with the longer bare section is suspended in air and acts as a cantilever.By detecting the transmission power of the sensor directly,the environmental vibrational frequencies and amplitudes may be obtained.By adjusting the cantilever＇s natural deflection angle,the sensor can achieve high sensitivity,good response linearity,and a wide dynamic range.Coupling conditions are optimized to minimize temperature effects by simply setting an appropriate air gap between the bare fibers.