The flow control mechanism of plasma actuators with periodic pulsed discharge to control the bi-stable vortices over a cone-cylinder is investigated. The actuators are installed on the leeward surface near the apex of...The flow control mechanism of plasma actuators with periodic pulsed discharge to control the bi-stable vortices over a cone-cylinder is investigated. The actuators are installed on the leeward surface near the apex of a cone which has a semi-apex angle of 10°. The effectiveness of the plasma actuation under different free-stream velocities and angles of attack is analyzed. The pressure distributions over the conical forebody are measured by both steady and dynamic pressure transducers. The transient dynamic pressure distribution tends to gradually become steady as the free-stream velocity increases, that is, the pulsed actuation approximates a continuous one. Furthermore, the flow control effectiveness becomes less noticeable as the free-stream velocity or the angle of attack increases under certain controlling electrical parameters.展开更多
Duty-cycle modulation alternately blowing from two opposite-facing plasma actu- ators on the leeward surface near the apex of a cone with a 10° semi-apex angle is adopted to control mean lateral force and moment,...Duty-cycle modulation alternately blowing from two opposite-facing plasma actu- ators on the leeward surface near the apex of a cone with a 10° semi-apex angle is adopted to control mean lateral force and moment, and the flow control mechanisms are presented. Pressure distributions over the forebody of the cone are measured by steady pressure tappings. The experiments are performed in a 3.0×1.6 m open-circuit wind tunnel at a wind speed of 20 m/s, a 45° angle of attack and a Reynolds number of 2×10^5, based on the diameter of the base of the cone. Almost linearly proportional control of the lateral forces and moments over a slender conical forebody at a high angle of attack has been demonstrated by employing a pair of single dielectric barrier discharge plasma actuators near the apex of the cone, combined with a duty-cycle tech- nique. The pressure distribution measurements indicate that the hi-stable vortex pattern appears to be shifted in the opposite direction when the port or starboard actuator is activated, while the other is kept off during the test. It is shown that the reduced pulse-repetition frequency based on the local diameter at the plasma actuator equal to one yields the highest effectiveness among the cases considered.展开更多
基金supported by the Foundation for Fundamental Research of the Northwestern Polytechnical University (NPU-FFR-W018102 and JC201103)
文摘The flow control mechanism of plasma actuators with periodic pulsed discharge to control the bi-stable vortices over a cone-cylinder is investigated. The actuators are installed on the leeward surface near the apex of a cone which has a semi-apex angle of 10°. The effectiveness of the plasma actuation under different free-stream velocities and angles of attack is analyzed. The pressure distributions over the conical forebody are measured by both steady and dynamic pressure transducers. The transient dynamic pressure distribution tends to gradually become steady as the free-stream velocity increases, that is, the pulsed actuation approximates a continuous one. Furthermore, the flow control effectiveness becomes less noticeable as the free-stream velocity or the angle of attack increases under certain controlling electrical parameters.
基金supported by the Specialized Research Fund for Doctoral Program of Higher Education,SPFDP-200806990003the Foundation for Fundamental Research of the Northwestern Polytechnical University,NPU-FFR-W018102
文摘Duty-cycle modulation alternately blowing from two opposite-facing plasma actu- ators on the leeward surface near the apex of a cone with a 10° semi-apex angle is adopted to control mean lateral force and moment, and the flow control mechanisms are presented. Pressure distributions over the forebody of the cone are measured by steady pressure tappings. The experiments are performed in a 3.0×1.6 m open-circuit wind tunnel at a wind speed of 20 m/s, a 45° angle of attack and a Reynolds number of 2×10^5, based on the diameter of the base of the cone. Almost linearly proportional control of the lateral forces and moments over a slender conical forebody at a high angle of attack has been demonstrated by employing a pair of single dielectric barrier discharge plasma actuators near the apex of the cone, combined with a duty-cycle tech- nique. The pressure distribution measurements indicate that the hi-stable vortex pattern appears to be shifted in the opposite direction when the port or starboard actuator is activated, while the other is kept off during the test. It is shown that the reduced pulse-repetition frequency based on the local diameter at the plasma actuator equal to one yields the highest effectiveness among the cases considered.
