A process of simultaneous desulfurization and denitrification of flue gas was conducted in this study.The flue gas containing 200 mg·m^-3NO,1000-4000 mg·m^-3SO(2,)3%-9%O(2)and 10%-20%CO(2)was first oxidized ...A process of simultaneous desulfurization and denitrification of flue gas was conducted in this study.The flue gas containing 200 mg·m^-3NO,1000-4000 mg·m^-3SO(2,)3%-9%O(2)and 10%-20%CO(2)was first oxidized b(y)O3 and then absorbed by ammonia in a bubbling reactor.Increasing the ammonia concentration or the SO2 content in flue gas can promote the absorption of NOx and extend the effective absorption time.On the contrary,both increasing the absorbent temperature or the O(2)content shorten the effective absorption time of NO((x.))The change of solution pH had substantial influence on NOx absorption.In the presence of CO(2)the NOx removal efficiency reached 89.2%when the absorbent temperature was raised to 60℃and the effective absorption time can be maintained for 8 h,which attribute to the buffering effect in the absorbent.Besides,both the addition of Na(2)S2 O3 and urea can promote the NOx removal efficiency when the absorbent temperature is 25℃and the addition of Na(2)S2 O3 had achieved better results.The advantage of adding Na(2)S2 O3 became less evident at higher absorbent temperature and coexistence of CO(2.)In all experiments,SO(2)removal efficiency was always above 99%,and it was basically not affected by the above factors.展开更多
Wet Flue Gas Desulfurization(WFGD)unit based upon spray scrubber has beenwidely employed to control SO_(2) emissions from flue gas in coal-fired power plant.To clarify the dependence of desulfurization performance on ...Wet Flue Gas Desulfurization(WFGD)unit based upon spray scrubber has beenwidely employed to control SO_(2) emissions from flue gas in coal-fired power plant.To clarify the dependence of desulfurization performance on inter-phase transfer behaviors with non-ideal contacting patterns of flue gas and slurry droplets,three regions in spray scrubber are distinguished in terms of gas-slurry flow structures using CFD method in the Eulerian-Lagrangian framework.A comprehensive model is established by involving the transfer process between two phases and chemical reactions in aqueous phase,which is validatedwith the measured data froma WFGD scrubber of 330 MW coal-fired power unit.Numerical results show that the overall uniformity degree of flue gas in whole scrubber is largely determined by the force-balanced droplets in the middle part of scrubber,which is dominated by counter-current mode.Both momentum transfer behavior and SO_(2) chemical absorption process present the synchronicity with the evolution of gas-slurry flow pattern,whilst the heat transfer together with H_(2)O evaporation has little effect on overall absorption process.Three regions are firstly defined as Gas Inlet Region(GIR),Dominant Absorption Region(DAR)and Slurry Dispersed Region(SDR)from the bottom to top of scrubber.SO_(2) is mainly scrubbed in DAR,which provides much more intensive interaction between two phases compared to GIR or SDR.A better understanding of the desulfurization process is obtained from the fundamental relationship between transport phenomena and chemical reactions based upon the complicated hydrodynamics of gas-slurry two-phase flow,which should be useful for designing and optimizing the scrubber in coal-fired power unit.展开更多
Selective catalytic reduction(SCR) denitration may increase the emission of NH4+and NH3.The removal and transformation characteristics of ammonium sulfate aerosols and ammonia slip during the wet flue gas desulfurizat...Selective catalytic reduction(SCR) denitration may increase the emission of NH4+and NH3.The removal and transformation characteristics of ammonium sulfate aerosols and ammonia slip during the wet flue gas desulfurization(WFGD) process, as well as the effect of desulfurization parameters, were investigated in an experimental system equipped with a simulated SCR flue gas generation system and a limestone-based WFGD system.The results indicate that the ammonium sulfate aerosols and ammonia slip in the flue gas from SCR can be partly removed by slurry scrubbing, while the entrainment and evaporation of desulfurization slurry with accumulated NH4+will generate new ammoniumcontaining particles and gaseous ammonia.The ammonium-containing particles formed by desulfurization are not only derived from the entrainment of slurry droplets, but also from the re-condensation of gaseous ammonia generated by slurry evaporation.Therefore,even if the concentration of NH4+in the desulfurization slurry is quite low, a high level of NH4+was still contained in the fine particles at the outlet of the scrubber.When the accumulated NH4+in the desulfurization slurry was high enough, the WFGD system promoted the conversion of NH3 to NH4+and increased the additional emission of primary NH4+aerosols.With the decline of the liquid/gas ratio and flue gas temperature, the removal efficiency of ammonia sulfate aerosols increased, and the NH4+emitted from entrainment and evaporation of the desulfurization slurry decreased.In addition, the volatile ammonia concentration after the WFGD system was reduced with the decrease of the NH4+concentration and p H values of the slurry.展开更多
中国石油独山子石化公司催化裂化(FCC)烟气脱硫脱硝装置采用选择性催化还原工艺(SCR)。针对生产过程中出现的因省煤器堵塞而导致余热锅炉压降缓慢升高的问题,采取降低烟机负荷,提高余热锅炉省煤器烟气温度至NH_4HSO_4露点温度(约231℃)...中国石油独山子石化公司催化裂化(FCC)烟气脱硫脱硝装置采用选择性催化还原工艺(SCR)。针对生产过程中出现的因省煤器堵塞而导致余热锅炉压降缓慢升高的问题,采取降低烟机负荷,提高余热锅炉省煤器烟气温度至NH_4HSO_4露点温度(约231℃)以上的方法加以解决。工业应用表明:当烟机入口蝶阀由90%关至45%,排烟温度由200℃提高到260℃时,SCR反应器入口和出口压力分别下降了3.11,3.25 k Pa;在提高余热锅炉排烟温度运行15 d后,高、中和低温省煤器压降依次下降0.6,1.9,0.5 k Pa,锅炉总压降下降3.0 k Pa。展开更多
基金financially supported by the National Key Research and Development Program of China(2016YFB0600701)。
文摘A process of simultaneous desulfurization and denitrification of flue gas was conducted in this study.The flue gas containing 200 mg·m^-3NO,1000-4000 mg·m^-3SO(2,)3%-9%O(2)and 10%-20%CO(2)was first oxidized b(y)O3 and then absorbed by ammonia in a bubbling reactor.Increasing the ammonia concentration or the SO2 content in flue gas can promote the absorption of NOx and extend the effective absorption time.On the contrary,both increasing the absorbent temperature or the O(2)content shorten the effective absorption time of NO((x.))The change of solution pH had substantial influence on NOx absorption.In the presence of CO(2)the NOx removal efficiency reached 89.2%when the absorbent temperature was raised to 60℃and the effective absorption time can be maintained for 8 h,which attribute to the buffering effect in the absorbent.Besides,both the addition of Na(2)S2 O3 and urea can promote the NOx removal efficiency when the absorbent temperature is 25℃and the addition of Na(2)S2 O3 had achieved better results.The advantage of adding Na(2)S2 O3 became less evident at higher absorbent temperature and coexistence of CO(2.)In all experiments,SO(2)removal efficiency was always above 99%,and it was basically not affected by the above factors.
基金This work was supported by the National Natural Science Foundation of China(51706070 and U1910215)the Fundamental Research Funds for the Central Universities(2018ZD03,2020MS008 and 2020MS078).
文摘Wet Flue Gas Desulfurization(WFGD)unit based upon spray scrubber has beenwidely employed to control SO_(2) emissions from flue gas in coal-fired power plant.To clarify the dependence of desulfurization performance on inter-phase transfer behaviors with non-ideal contacting patterns of flue gas and slurry droplets,three regions in spray scrubber are distinguished in terms of gas-slurry flow structures using CFD method in the Eulerian-Lagrangian framework.A comprehensive model is established by involving the transfer process between two phases and chemical reactions in aqueous phase,which is validatedwith the measured data froma WFGD scrubber of 330 MW coal-fired power unit.Numerical results show that the overall uniformity degree of flue gas in whole scrubber is largely determined by the force-balanced droplets in the middle part of scrubber,which is dominated by counter-current mode.Both momentum transfer behavior and SO_(2) chemical absorption process present the synchronicity with the evolution of gas-slurry flow pattern,whilst the heat transfer together with H_(2)O evaporation has little effect on overall absorption process.Three regions are firstly defined as Gas Inlet Region(GIR),Dominant Absorption Region(DAR)and Slurry Dispersed Region(SDR)from the bottom to top of scrubber.SO_(2) is mainly scrubbed in DAR,which provides much more intensive interaction between two phases compared to GIR or SDR.A better understanding of the desulfurization process is obtained from the fundamental relationship between transport phenomena and chemical reactions based upon the complicated hydrodynamics of gas-slurry two-phase flow,which should be useful for designing and optimizing the scrubber in coal-fired power unit.
基金supported by the National Natural Science Foundation of China(Nos.51576039 and 51576039).
文摘Selective catalytic reduction(SCR) denitration may increase the emission of NH4+and NH3.The removal and transformation characteristics of ammonium sulfate aerosols and ammonia slip during the wet flue gas desulfurization(WFGD) process, as well as the effect of desulfurization parameters, were investigated in an experimental system equipped with a simulated SCR flue gas generation system and a limestone-based WFGD system.The results indicate that the ammonium sulfate aerosols and ammonia slip in the flue gas from SCR can be partly removed by slurry scrubbing, while the entrainment and evaporation of desulfurization slurry with accumulated NH4+will generate new ammoniumcontaining particles and gaseous ammonia.The ammonium-containing particles formed by desulfurization are not only derived from the entrainment of slurry droplets, but also from the re-condensation of gaseous ammonia generated by slurry evaporation.Therefore,even if the concentration of NH4+in the desulfurization slurry is quite low, a high level of NH4+was still contained in the fine particles at the outlet of the scrubber.When the accumulated NH4+in the desulfurization slurry was high enough, the WFGD system promoted the conversion of NH3 to NH4+and increased the additional emission of primary NH4+aerosols.With the decline of the liquid/gas ratio and flue gas temperature, the removal efficiency of ammonia sulfate aerosols increased, and the NH4+emitted from entrainment and evaporation of the desulfurization slurry decreased.In addition, the volatile ammonia concentration after the WFGD system was reduced with the decrease of the NH4+concentration and p H values of the slurry.
文摘中国石油独山子石化公司催化裂化(FCC)烟气脱硫脱硝装置采用选择性催化还原工艺(SCR)。针对生产过程中出现的因省煤器堵塞而导致余热锅炉压降缓慢升高的问题,采取降低烟机负荷,提高余热锅炉省煤器烟气温度至NH_4HSO_4露点温度(约231℃)以上的方法加以解决。工业应用表明:当烟机入口蝶阀由90%关至45%,排烟温度由200℃提高到260℃时,SCR反应器入口和出口压力分别下降了3.11,3.25 k Pa;在提高余热锅炉排烟温度运行15 d后,高、中和低温省煤器压降依次下降0.6,1.9,0.5 k Pa,锅炉总压降下降3.0 k Pa。
