Growth, Metabolism and Yield of Rice Cultivated in Soils Amended with Fly Ash and Cyanobacteria and Metal Loads in Plant Parts

Soil amendment with fly ash（FA） and combined supplementation with N_2-fixing cyanobacteria masses as biofertilizer were done in field experiments with rice. Amendments with FA levels, 0, 0.5, 1.0, 2.0, 4.0, 8.0 and 10.0 kg/m2, caused increase in growth and yield of rice up to 8.0 kg/m2, monitored with several parameters. Pigment contents and enzyme activities of leaves were enhanced by FA, with the maximum level of FA at 10.0 kg/m2. Protein content of rice seeds was the highest in plants grown at FA level 4.0 kg/m2. Basic soil properties, p H value, percentage of silt, percentage of clay, water-holding capacity, electrical conductivity, cation exchange capacity, and organic carbon content increased due to the FA amendment. Parallel supplementation of FA amended plots with 1.0 kg/m2 N_2-fixing cyanobacteria mass caused further significant increments of the most soil properties, and rice growth and yield parameters. 1000-grain weight of rice plants grown at FA level 4.0 kg/m2 along with cyanobacteria supplementation was the maximum. Cyanobacteria supplementation caused increase of important basic properties of soil including the total N-content. Estimations of elemental content in soils and plant parts（root and seed） were done by the atomic absorption spectrophotometry. Accumulations of K, P, Fe and several plant micronutrients（Mn, Ni, Co, Zn and Cu） and toxic elements（Pb, Cr and Cd） increased in soils and plant parts as a function of the FA gradation, but Na content remained almost unchanged in soils and seeds. Supplementation of cyanobacteria had ameliorating effect on toxic metal contents of soils and plant parts. The FA level 4.0 kg/m2, with 1.0 kg/m2 cyanobacteria mass supplementation, could be taken ideal, since there would be recharging of the soil with essential micronutrients as well as toxic chemicals in comparative lesser proportions, and cyanobacteria mass would cause lessening toxic metal loads with usual N_2-fixation.

Effects of Fly Ash/Diatomite Admixture with Variable Particle Sizes on the Mechanical Properties and Porosity of Concrete

Fly ash and diatomite were mixed uniformly and ground within various time scale and fly ash/diatomite admixtures with variable particle sizes were obtained. Effects of particle size distributions of the admixtures on the mechanical properties and porosity of concrete were studied. The relationship between the size distribution of the admixture and the concrete porosity was obtained based on the regression analysis of the data. The results show that compressive and flexural strengths of the concrete at 3 d and 7 d increase with the decrease of the admixture particle size. With regards to the concrete at 14 d, lowering the particle size of fly ash/diatomite admixture leads to the increasing of the compressive and flexural strength of the concrete, before decreasing afterwards again. At the d50 value of 15.2 μm, the mechanical properties of concrete were greatly improved. In addition, finer particle of the fly ash/diatomite admixture leads to significant micro-aggregate effect and volcanic ash effect and thus obtains denser pore structure, smaller porosity and higher hydration degree of the cementitious material. Especially for the samples curing at the early stage, the improving effect on the pore structure was obvious.

Chemical composition and physical properties of filter fly ashes from eight grate-fired biomass combustion plants

For the handling, treatment and utilization of fly ash from biomass combustion its chemical composition and physical properties are important. In this study eight filter fly ashes from different grate-fired biomass combustion plants were investigated. In fly ash from straw combustion high concentrations of（K） were found, whereas in the fly ash from wood combustion the concentrations of Ca and Mg were higher. The average concentration of PO3-4was similar in both types of fly ashes. In all wood fly ashes some measured heavy metal concentrations were above the limits for utilization. The straw fly ashes were much less contaminated and can be utilized. For wood fly ash most parameters showed little variation, except from one fly ash where the dust pre-separator is in poor condition. The average values were： mass median diameter 4.3 ± 0.8 μm, spread of particle size distribution19 ± 11, particle density 2620 ± 80 kg/m^3 and angle of repose 50°± 1°. The density of the straw fly ashes is lower（2260 ± 80 kg/m^3） and the spread of the size distribution is higher（72 ± 24）.For one straw combustion fly ash the values of the mass median diameter and the angle of repose were similar to the values of wood combustion fly ash, for the other straw fly ash the values differed considerably. While the particle size of this fly ash was much smaller,surprisingly the angle of repose was also lower. This can be attributed to the formation of small agglomerates in this fly ash, which were not disintegrated without a certain stress.