Theoretical Research and Experimental Validation of Elastic Dynamic Load Spectra on Bogie Frame of High-speed Train

When a train runs at high speeds, the external exciting frequencies approach the natural frequencies of bogie critical components, thereby inducing strong elastic vibrations. The present international reliability test evaluation standard and design criteria of bogie frames are all based on the quasi-static deformation hypothesis. Structural fatigue damage generated by structural elastic vibrations has not yet been included. In this paper, theoretical research and experimental validation are done on elastic dynamic load spectra on bogie frame of high-speed train. The construction of the load series that correspond to elastic dynamic deformation modes is studied. The simplified form of the load series is obtained. A theory of simplified dynamic load–time histories is then deduced. Measured data from the Beijing–Shanghai Dedicated Passenger Line are introduced to derive the simplified dynamic load–time histories. The simplified dynamic discrete load spectra of bogie frame are established. Based on the damage consistency criterion and a genetic algorithm, damage consistency calibration of the simplified dynamic load spectra is finally performed. The computed result proves that the simplified load series is reasonable. The calibrated damage that corresponds to the elastic dynamic discrete load spectra can cover the actual damage at the operating conditions. The calibrated damage satisfies the safety requirement of damage consistency criterion for bogie frame. This research is helpful for investigating the standardized load spectra of bogie frame of high-speed train.

Light weight analysis of a skeleton vehicle frame using BS960 super-high-strength steel

Static strength finite element analysis was conducted to decrease the weight of a skeleton vehicle＇s frame. Results indicated that the maximum stress occurs on the front beam ＇s variable section area. Dynamic sensitivity analysis elucidated the relationship between the maximum stress and the thickness of a particular beam,e. g.,top,middle,and bottom beam. Displacement was analyzed by the key part that influenced the maximum stress. Finally,the new plan using BS960 super-high-strength beam steel and the preferred beam thickness was compared with the original plan. New combinations of beam thickness were introduced on the basis of different purposes; the maximum responding light w eight ratio was 21%.

A Simplified Approach to Analysis of High-Rise Frame Tube Structures

Based on finite element method and finite strip method, a simplified approach was presented to analyze high rise frame tube structures. The generalized strip element is introduced and then the generalized stiffness matrices for beam and column line are derived by using the displacement functions that describe the nodal displacements and displacement transforms. Furthermore, the formulas for the generalized stiffness matrix of generalized strip element and load arrays corresponding to the displacement parameters were developed. It is shown through a series of numerical computation that the nodal angular displacements at the same floor in a generalized strip element are approximately identical. A comparison of the finite element method and the finite strip method shows that the simplified approach not only is accurate, but also reduces the number of basic unknown quantities.

Finite element model validation of bridge based on structural health monitoring——Part I: Response surface-based finite element model updating

In the engineering practice, merging statistical analysis into structural evaluation and assessment is a tendency in the future. As a combination of mathematical and statistical techniques, response surface （RS） methodology has been successfully applied to design optimization, response prediction and model validation. With the aid of RS methodology, these two serial papers present a finite element （FE） model updating and validation method for bridge structures based on structural health monitoring. The key issues to implement such a model updating are discussed in this paper, such as design of experiment, parameter screening, construction of high-order polynomial response surface model, optimization methods and precision inspection of RS model. The proposed procedure is illustrated by a prestressed concrete continuous rigid-frame bridge monitored under operational conditions. The results from the updated FE model have been compared with those obtained from online health monitoring system. The real application to a full-size bridge has demonstrated that the FE model updating process is efficient and convenient. The updated FE model can relatively reflect the actual condition of Xiabaishi Bridge in the design space of parameters and can be further applied to FE model validation and damage identification.