Traditional oil-based drilling muds(OBMs) have a relatively high solid content, which is detrimental to penetration rate increase and reservoir protection. Aimed at solving this problem, an organoclay-free OBM system ...Traditional oil-based drilling muds(OBMs) have a relatively high solid content, which is detrimental to penetration rate increase and reservoir protection. Aimed at solving this problem, an organoclay-free OBM system was studied, the synthesis methods and functioning mechanism of key additives were introduced, and performance evaluation of the system was performed. The rheology modifier was prepared by reacting a dimer fatty acid with diethanolamine, the primary emulsifier was made by oxidation and addition reaction of fatty acids, the secondary emulsifier was made by amidation of a fatty acid, and finally the fluid loss additive of water-soluble acrylic resin was synthesized by introducing acrylic acid into styrene/butyl acrylate polymerization. The rheology modifier could enhance the attraction between droplets, particles in the emulsion via intermolecular hydrogen bonding and improve the shear stress by forming a three-dimensional network structure in the emulsion. Lab experimental results show that the organoclay-free OBM could tolerate temperatures up to 220 ?C and HTHP filtration is less than 5 m L. Compared with the traditional OBMs, the organoclay-free OBM has low plastic viscosity, high shear stress, high ratio of dynamic shear force to plastic viscosity and high permeability recovery, which are beneficial to penetration rate increase, hole cleaning and reservoir protection.展开更多
The increasing application of near balanced drilling technology to low-pressure and depleted fractured reservoirs requires the use of low-density drilling fluids to avoid formation damage.Solids-free oil-in-water(O/W)...The increasing application of near balanced drilling technology to low-pressure and depleted fractured reservoirs requires the use of low-density drilling fluids to avoid formation damage.Solids-free oil-in-water(O/W)emulsion drilling fluid is one type of low-density drilling fluid suitable for depleted fractured reservoirs.In this paper,the solids-free O/W drilling fluid was developed and has been successfully used in the Bozhong 28-1 oil and gas field,by which lost circulation,a severe problem occurred previously when drilling into fractured reservoir beds,was controlled,thereby minimizing formation damage.The O/W emulsion drilling fluid was prepared by adding 20%(by volume)No.5 mineral oil(with high flash point,as dispersed phase)into seawater(as continuous phase).Surfactant HTO-1(as a primary emulsifier)and non-ionic surfactant HTO-2(as a secondary emulsifier)were added into the drilling fluid system to stabilize the emulsion;and YJD polymer was also added to seawater to improve the viscosity of the continuous phase(seawater).The drilling fluid was characterized by high flash point,good thermal stability and high stability to crude oil contamination.展开更多
The esterification of free fatty acids(FFA) in waste cooking oil with methanol in the presence of Fe2(SO4)3/C(ferric sulfate/active carbon) catalyst was studied.The effects of different temperature,methanol/FFA mole r...The esterification of free fatty acids(FFA) in waste cooking oil with methanol in the presence of Fe2(SO4)3/C(ferric sulfate/active carbon) catalyst was studied.The effects of different temperature,methanol/FFA mole ratio and amount of catalyst on the conversion of FFA were investigated.The results demonstrated that under optimal esterification conditions the final acid value of the resultant system can be reduced to ～1(mg KOH)·g-1,which met fully the requirements in post-treatment for efficient separation of glycerin and biodiesel.The kinetics of the esterification were also investigated under different temperatures.The results indicated that the rate-control step could be attributed to the surface reaction and the esterification processes can be well-depicted by the as-calculated kinetic formula in the range of the experimental conditions.展开更多
The surfactant-coated Candida rugosa lipase was used as catalyst for hydrolysis of olive oil in two-phase system consisting of olive oil and phosphate buffer without organic solvent. For both the coated and native lip...The surfactant-coated Candida rugosa lipase was used as catalyst for hydrolysis of olive oil in two-phase system consisting of olive oil and phosphate buffer without organic solvent. For both the coated and native lipases,the optimal buffer/oil volume ratio of 1.0, aqueous pH 6.8 and reaction temperature 30℃ were determined. The maximum activity of the coated lipase was ca 1.3 times than that of the native lipase. The half-life of the coated lipase in olive oil and the native lipase in phosphate buffer was ca 9 h and 12 h, and the final residual activity was 27% and 20% of their initial values, respectively. The final substrate conversion by the coated lipase was ca 20% higher than that of the native lipase.展开更多
基金Supported by the Basic Research Funds Reserved to State-run Universities(18CX02171A,18CX02033A)
文摘Traditional oil-based drilling muds(OBMs) have a relatively high solid content, which is detrimental to penetration rate increase and reservoir protection. Aimed at solving this problem, an organoclay-free OBM system was studied, the synthesis methods and functioning mechanism of key additives were introduced, and performance evaluation of the system was performed. The rheology modifier was prepared by reacting a dimer fatty acid with diethanolamine, the primary emulsifier was made by oxidation and addition reaction of fatty acids, the secondary emulsifier was made by amidation of a fatty acid, and finally the fluid loss additive of water-soluble acrylic resin was synthesized by introducing acrylic acid into styrene/butyl acrylate polymerization. The rheology modifier could enhance the attraction between droplets, particles in the emulsion via intermolecular hydrogen bonding and improve the shear stress by forming a three-dimensional network structure in the emulsion. Lab experimental results show that the organoclay-free OBM could tolerate temperatures up to 220 ?C and HTHP filtration is less than 5 m L. Compared with the traditional OBMs, the organoclay-free OBM has low plastic viscosity, high shear stress, high ratio of dynamic shear force to plastic viscosity and high permeability recovery, which are beneficial to penetration rate increase, hole cleaning and reservoir protection.
文摘The increasing application of near balanced drilling technology to low-pressure and depleted fractured reservoirs requires the use of low-density drilling fluids to avoid formation damage.Solids-free oil-in-water(O/W)emulsion drilling fluid is one type of low-density drilling fluid suitable for depleted fractured reservoirs.In this paper,the solids-free O/W drilling fluid was developed and has been successfully used in the Bozhong 28-1 oil and gas field,by which lost circulation,a severe problem occurred previously when drilling into fractured reservoir beds,was controlled,thereby minimizing formation damage.The O/W emulsion drilling fluid was prepared by adding 20%(by volume)No.5 mineral oil(with high flash point,as dispersed phase)into seawater(as continuous phase).Surfactant HTO-1(as a primary emulsifier)and non-ionic surfactant HTO-2(as a secondary emulsifier)were added into the drilling fluid system to stabilize the emulsion;and YJD polymer was also added to seawater to improve the viscosity of the continuous phase(seawater).The drilling fluid was characterized by high flash point,good thermal stability and high stability to crude oil contamination.
文摘The esterification of free fatty acids(FFA) in waste cooking oil with methanol in the presence of Fe2(SO4)3/C(ferric sulfate/active carbon) catalyst was studied.The effects of different temperature,methanol/FFA mole ratio and amount of catalyst on the conversion of FFA were investigated.The results demonstrated that under optimal esterification conditions the final acid value of the resultant system can be reduced to ～1(mg KOH)·g-1,which met fully the requirements in post-treatment for efficient separation of glycerin and biodiesel.The kinetics of the esterification were also investigated under different temperatures.The results indicated that the rate-control step could be attributed to the surface reaction and the esterification processes can be well-depicted by the as-calculated kinetic formula in the range of the experimental conditions.
基金National Natural Science Foundation of China(No.29876031)
文摘The surfactant-coated Candida rugosa lipase was used as catalyst for hydrolysis of olive oil in two-phase system consisting of olive oil and phosphate buffer without organic solvent. For both the coated and native lipases,the optimal buffer/oil volume ratio of 1.0, aqueous pH 6.8 and reaction temperature 30℃ were determined. The maximum activity of the coated lipase was ca 1.3 times than that of the native lipase. The half-life of the coated lipase in olive oil and the native lipase in phosphate buffer was ca 9 h and 12 h, and the final residual activity was 27% and 20% of their initial values, respectively. The final substrate conversion by the coated lipase was ca 20% higher than that of the native lipase.
