Controlling the light wavefront through a scattering medium based on direct digital frequency synthesis technology

Phase modulation is a crucial step when the frequency-based wavefront optimization technique is exploited to measure the optical transmission matrix(TM) of a scattering medium. We report a simple but powerful method, direct digital frequency synthesis(DDS) technology to modulate the phase front of the laser and measure the TM. By judiciously modulating the phase front of a He–Ne laser beam, we experimentally generate a high quality focus at any targeted location through a 2 mm thick 120 grit ground glass diffuser, which is commercially used in laser display and laser holographic display for improving brightness uniformity and reducing speckle. The signal to noise ratio(SNR) of the clear round focus is 50 and the size is about 44 μm. Our study will open up new avenues for enhancing light energy delivery to the optical engine in laser TV to lower the power consumption, phase compensation to reduce the speckle noise, and controlling the lasing threshold in random lasers.

Novel analysis method for the spurious spectrum of direct digitalfrequency synthesizer in the presence of phase truncation

Based on the analysis of the spurious introduced by phase accumulation truncation which was made by Nicholas, a new simplified algorithm for spurious spectrum in the presence of phase truncation is presented by using the mapping mathematics and number theoretic method, it is possible to precisely analyze the spurious location and the spurious amplitude introduced by phase truncation in practical applications by computer.

Absolutely Direct Frequency Measurement of Two-Photon Transition Using Multi-Peak Fitting Approach

The optical frequency comb has been widely used in precision measurement. In this study, a multi-peak fitting approach is first proposed to fit the two-photon transition spectrum which overlaps with the neighboring transition in Rb-87. The multi-peak fitting approach is used to eliminate the frequency shift affected by the neighboring transition. With locking the carrier envelope offset frequency at 1/4 repetition frequency, the transition frequency is measured to be 770569132739.9 +/- 5.8 kHz, which agrees well with the previous result recommended by Comite International des Poids et Mesures.

Direct Digital Frequency Control Based on the Phase Step Change Characteristic between Signals

We present a new digital phase lock technology to achieve the frequency control and transformation through high precision multi-cycle group synchronization between signals without the frequency transformation circuit. In the case of digital sampling, the passing zero point of the phase of the controlled signal has the phase step characteristic, the phase step of the passing zero point is monotonic continuous with high resolution in the phase lock process, and using the border effect of digital fuzzy area, the gate can synchronize with the two signals, the quantization error is reduced. This technique is quite different from the existing methods of frequency transformation and frequency synthesis, the phase change characteristic between the periodic signals with different nominal is used. The phase change has the periodic phenomenon, and it has the high resolution step value. With the application of the physical law, the noise is reduced because of simplifying frequency transformation circuits, and the phase is locked with high precision. The regular phase change between frequency signals is only used for frequency measurement, and the change has evident randomness, but this randomness is greatly reduced in frequency control, and the certainty of the process result is clear. The experiment shows that the short term frequency stability can reach 10-12/s orders of magnitude.

Fracture characteristics of the 1997 Jiashi,Xinjiang, China, earthquake swarm inferred from source spectra

Broadband P and S waves source spectra of 12 M_s≥5.0 earthquakes of the 1997 Jiashi, Xinjiang, China. earthquake swarm recorded at 13 GDSN stations have been analyzed. Rupture size and static stress drop of these earthquakes have been estimated through measuring the corner frequency of the source spectra. Direction of rupture propaga- tion of the earthquake faulting has also been inferred from the azimuthal variation of the comer frequency. The main results are as follows: ① The rupture size of M_s≥6.0 strong earthquakes is in the range of 10~20 km, while that of Ms_=5.0~5.5 earthquakes is 6~10 km. ② The static stress drop of the swarm earthquakes is rather low, being of the order of 0.1 MPa. This implies that the deformation release rate in the source region may be low. ③ Stress drop of the earthquakes appears to be proportional to their seismic moment, and also to be dependent on their focal mechanism. The stress drop of normal faulting earthquakes is usually lower than that of strike-slip type earth quakes. ④ For each M_s≥6.0 earthquake there exists an apparent azimuthal variation of the comer frequencies. Azimuthally variation pattern of comer frequencies of different earthquakes shows that the source rupture pattern of the Jiashi earthquake swarm is complex and no uniform rupture expanding direction exists.

DDFS spurious signals due to amplitude quantization in absence of phase-accumulator truncation

Spurious signals in direct digital frequency synthesizers （DDFSs） are partly caused by amplitude quantization and phase truncation, which affect their application to many wireless telecommunication systems. These signals are deterministic and periodic in the time domain, so they appear as line spectra in the frequency domain. Two types of spurious signals due to amplitude quantization are exactly formulated and compared in the time and frequency domains respectively. Then the frequency spectra and power levels of the spurious signals due to amplitude quantization in the absence of phase-accumulator truncation are emphatically analyzed, and the effects of the DDFS parameter variations on the spurious signals are thoroughly studied by computer simulation. And several important conclusions are derived which can provide theoretical support for parameter choice and spurious performance evaluation in the application of DDFSs.

A Ka-band wide locking range frequency divider with high injection sensitivity

This paper proposes a direct injection-locked frequency divider（ILFD） with a wide locking range in the Ka-band. A complementary cross-coupled architecture is used to enhance the overdriving voltage of the switch transistor so that the divider locking range is extended efficiently. New insights into the locking range and output power are proposed. A new method to analyze and optimize the injection sensitivity is presented and a layout technique to reduce the parasitics of the cross-coupled transistors is applied to decrease the frequency shift and the locking range degradation. The circuit is designed in a standard 90-nm CMOS process. The total locking range of the ILFD is 43.8% at 34.5 GHz with an incident power of –3.5 dBm. The divider IC consumes 3.6 mW of power at the supply voltage of 1.2 V. The chip area including the pads is 0.50.5 mm2.

A high speed direct digital frequency synthesizer realized by a segmented nonlinear DAC

This paper presents a high speed ROM-less direct digital frequency synthesizer （DDFS） which has a phase resolution of 32 bits and a magnitude resolution of 10 bits. A 10-bit nonlinear segmented DAC is used in place of the ROM look-up table for phase-to-sine amplitude conversion and the linear DAC in a conventional DDFS. The design procedure for implementing the nonlinear DAC is presented. To ensure high speed, current mode logic （CML） is used. The chip is implemented in Chartered 0.35μm COMS technology with active area of 2.0 × 2.5 mm^2 and total power consumption of 400 mW at a single 3.3 V supply voltage. The maximum operating frequency is 850 MHz at room temperature and 1.0 GHz at 0℃.

A 4 GHz 32 bit direct digital frequency synthesizer based on a novel architecture

This paper presents a novel direct digital frequency synthesizer （DDFS） architecture based on nonlinear DAC coarse quantization and the ROM-based piecewise approximation method, which has the advantages of high speed, low power and low hardware resources. By subdividing the sinusoid into a collection of phase segments, the same initial value of each segment is realized by a nonlinear DAC. The ROM is decomposed with a coarse ROM and fine ROM using the piecewise approximation method. Then, the coarse ROM stores the offsets between the initial value of the common segment and the initial value of each line in the same segment. Meanwhile, the fine ROM stores the differences between the line values and the initial value of each line. A ROM compression ratio of 32 can be achieved in the case of 11 bit phase and 9 bit amplitude. Based on the above method, a prototype chip was fabricated using 1.4 #m GaAs HBT technology. The measurement shows an average spurious-free dynamic range （SFDR） of 45 dBc, with the worst SFDR only 40.07 dBc at a 4.0 GHz clock. The chip area is 4.6 × 3.7 mm2 and it consumes 7 W from a --4.9 V power supply.

A high speed direct digital frequency synthesizer based on multi-channel structure

This paper presents a direct digital frequency synthesizer （DDFS） for high speed application based on multi-channel structure. This DDFS has phase resolution of 32 bits and magnitude resolution of 12 bits. In order to ensure the high speed and high resolution at the same time, the multi-channel sampling technique is used and a 12 bits linear digital-to-analog converter is implemented. The chip is fabricated in TSMC 130 nm CMOS technology with active area of 0.89 x 0.98 mm2 and total power consumption of 300 mW at a single 1.2 V supply voltage. The maximum operating speed is up to 2.0 GHz at room temperature.

Ocean dynamic noise energy flux directivity in the 400 Hz to 700 Hz frequency band

Results of field studies of underwater dynamic noise energy flux directivity at two wind speeds, 6 m/s and 12 m/s, in the 400 Hz to 700 Hz frequency band in the deep open ocean are presented. The measurements were made by a freely drifting telemetric combined system at 500 m depth. Statistical characteristics of the horizontal and vertical dynamic noise energy flux directivity are considered as functions of wind speed and direction. Correlation between the horizontal dynamic noise energy flux direction and that of the wind was determined; a mechanism of the horizontal dynamic noise energy flux generation is related to the initial noise field scattering on ocean surface waves.

Design of an experimental platform to investigate the effects of audible sounds on plant growth

An experimental platform was developed to investigate the effects of audible sound(20 Hz to 20 MHz)on plant growth promotion,which included a microcontroller-based embedded system for audible sound adjustment and analysis.The direct digital frequency synthesis(DDFS)method was used to generate various waveforms of sound in the platform.Soundproof glass and mufflers were used to reduce background noise.The developed system was tested on various plants,including hydroponic tomatoes,celery and mung bean.The testing results showed that the developed platform could produce pure tone and mixing audible sound with high stability and accuracy,make octave analysis of the sound under experimental environments,and the background noise in the testing chamber of the platform was lower than 55 dB(A)when the compression engine was working.The developed experimental platform has a great potential on facilitating scientific research on acoustic biology effects on plants and collecting real-time experimental data.