The oriented(CoIr)_(100-x)P_x(P = B, Ni, and SiO_2) soft magnetic films are prepared. Their morphology is measured using transmission electron microscopy(TEM), and reveals that these films exhibit good crystallinity a...The oriented(CoIr)_(100-x)P_x(P = B, Ni, and SiO_2) soft magnetic films are prepared. Their morphology is measured using transmission electron microscopy(TEM), and reveals that these films exhibit good crystallinity and high degree of the c-axis orientation. The magnetic properties are thoroughly investigated as a function of doping x. Our results show that all of these films possess negative magnetocrystalline anisotropy as required by possible applications. Both the intrinsic and extrinsic contributions are considered to interpret the broadening of the ferromagnetic resonance spectral linewidth. The intrinsic Gilbert damping is identified as the main cause of the linewidth broadening, while the extrinsic part originating from inhomogeneities only plays a minor role. More interestingly, our results show that the damping constant can be controlled by using the doping method.展开更多
Co2MnSi thin films are made by magnetron sputtering onto MgO （001） substrates. The crystalline quality is improved by increasing depositing temperature and/or annealing temperature. The sample deposited at 550℃ and...Co2MnSi thin films are made by magnetron sputtering onto MgO （001） substrates. The crystalline quality is improved by increasing depositing temperature and/or annealing temperature. The sample deposited at 550℃ and subsequently annealed at 550℃ （sample I） exhibits a pseudo-epitaxial growth with partially ordered L21 phase. Sample I shows a four-fold magnetic anisotropy, in addition to a relatively weak uniaxial anisotropy. The Gilbert damping factor of sample I is smaller than 0.001, much smaller than reported ones. The possible reasons responsible for the small Gilbert damping factor are discussed, including weak spin-orbit coupling, small density of states at Fermi level, and so on.展开更多
Shear-mode piezoelectric materials have been widely used to shunt the damping of vibrations where utilizing surface or interface shear stresses. The thick-shear mode （TSM） elastic constant and the mechanical loss fa...Shear-mode piezoelectric materials have been widely used to shunt the damping of vibrations where utilizing surface or interface shear stresses. The thick-shear mode （TSM） elastic constant and the mechanical loss factor can change correspondingly when piezoelectric materials are shunted to different electrical circuits. This phenomenon makes it possible to control the performance of a shear-mode piezoelectric damping system through designing the shunt circuit. However, due to the difficulties in directly measuring the TSM elastic constant and the mechanical loss factor of piezoelectric materials, the relationships between those parameters and the shunt circuits have rarely been investigated. In this paper, a coupling TSM electro-mechanical resonant system is proposed to indirectly measure the variations of the TSM elastic constant and the mechanical loss factor of piezoelectric materials. The main idea is to transform the variations of the TSM elastic constant and the mechanical loss factor into the changes of the easily observed resonant frequency and electrical quality factor of the coupling electro-mechanical resonator. Based on this model, the formular relationships are set up theoretically with Mason equivalent circuit method and they are validated with finite element （FE） analyses. Finally, a prototype of the coupling electro-mechanical resonator is fabricated with two shear-mode PZT5A plates to investigate the TSM elastic constants and the mechanical loss factors of different circuit-shunted cases of the piezoelectric plate. Both the resonant frequency shifts and the bandwidth changes observed in experiments are in good consistence with the theoretical and FE analyses under the same shunt conditions. The proposed coupling resonator and the obtained relationships are validated with but not limited to PZT5A.展开更多
Piezoelectric shunt damping has been widely used in vibration suppression, sound absorption, noise elimination, etc. In such applications, the variant elastic constants of piezoelectric materials are the essential par...Piezoelectric shunt damping has been widely used in vibration suppression, sound absorption, noise elimination, etc. In such applications, the variant elastic constants of piezoelectric materials are the essential parameters that determine the performances of the systems, when piezoelectric materials are shunted to normal electrical elements, i.e., resistance, inductance and capacitance, as well as their combinations. In recent years, many researches have demonstrated that the wideband sound absorption or vibration suppression can be realized with piezoelectric materials shunted to negative capacitance. However, most systems using the negative-capacitance shunt circuits show their instabilities in the optimal condition, which are essentially caused by the singular variation properties of elastic constants of piezoelectric materials when shunted to negative capacitance. This paper aims at investigating the effects of negative-capacitance shunt circuits on elastic constants of a piezoelectric ceramic plate through theoretical analyses and experiments, which gives an rational explanation for why negative capacitance shunt circuit is prone to make structure instable. First, the relationships between the elastic constants c11, c33, c55 of the piezoelectric ceramic and the shunt negative capacitance are derived with the piezoelectric constitutive law theoretically. Then, an experimental setup is established to verify the theoretical results through observing the change of elastic constant c55 of the shunted piezoelectric plate with the variation of negative capacitance. The experimental results are in good agreement with the theoretical analyses, which reveals that the instability of the shunt damping system is essentially caused by the singular variation property of the elastic constants of piezoelectric material shunted to negative capacitance.展开更多
直流微电网中恒功率负荷(constant power load,CPL)表现为负阻尼特性,其大量接入会降低系统阻尼,引起直流母线电压振荡失稳。为此,提出一种虚拟电阻控制策略补偿下垂系数来提高系统稳定裕度。基于所提控制方法,建立直流微电网的小信号模...直流微电网中恒功率负荷(constant power load,CPL)表现为负阻尼特性,其大量接入会降低系统阻尼,引起直流母线电压振荡失稳。为此,提出一种虚拟电阻控制策略补偿下垂系数来提高系统稳定裕度。基于所提控制方法,建立直流微电网的小信号模型,分析直流侧电容、负荷功率、下垂系数和电流控制器参数变化对系统稳定性的影响,并对各参数进行灵敏度分析;根据下垂系数灵敏度大这一分析结果,提出虚拟电阻控制策略。再者,对于虚拟电阻在不同源变换器的应用效果,分别从Nyquist曲线图和灵敏度进行定性、定量分析,得出所提控制策略应用到网侧变换器对系统稳定性的提高效果更好。最后,在Matlab/Simulink中建立直流微电网模型进行仿真,仿真结果表明,所提控制策略能有效增强系统阻尼,提高系统稳定性。展开更多
基金Project supported by the National Natural Science Foundation of China(Grant Nos.11574122 and 11704167)the Fundamental Research Funds for the Central Universities,China(Grant Nos.lzujbky-2017-k20 and lzujbky-2017-31)
文摘The oriented(CoIr)_(100-x)P_x(P = B, Ni, and SiO_2) soft magnetic films are prepared. Their morphology is measured using transmission electron microscopy(TEM), and reveals that these films exhibit good crystallinity and high degree of the c-axis orientation. The magnetic properties are thoroughly investigated as a function of doping x. Our results show that all of these films possess negative magnetocrystalline anisotropy as required by possible applications. Both the intrinsic and extrinsic contributions are considered to interpret the broadening of the ferromagnetic resonance spectral linewidth. The intrinsic Gilbert damping is identified as the main cause of the linewidth broadening, while the extrinsic part originating from inhomogeneities only plays a minor role. More interestingly, our results show that the damping constant can be controlled by using the doping method.
基金Supported by the National Basic Research Program of China under Grant No 2015CB921502the National Natural Science Foundation of China under Grant Nos 11474184 and 11174183+3 种基金the 111 Project under Grant No B13029the Natural Science Foundation of Shandong Province under Grant No JQ201201the Doctorate Foundation of Shandong Province under Grant No BS2013CL042the Young Scientists Fund of the National Natural Science Foundation of China under Grant No 11204164
文摘Co2MnSi thin films are made by magnetron sputtering onto MgO （001） substrates. The crystalline quality is improved by increasing depositing temperature and/or annealing temperature. The sample deposited at 550℃ and subsequently annealed at 550℃ （sample I） exhibits a pseudo-epitaxial growth with partially ordered L21 phase. Sample I shows a four-fold magnetic anisotropy, in addition to a relatively weak uniaxial anisotropy. The Gilbert damping factor of sample I is smaller than 0.001, much smaller than reported ones. The possible reasons responsible for the small Gilbert damping factor are discussed, including weak spin-orbit coupling, small density of states at Fermi level, and so on.
基金Project supported by the National Defense Foundation of China(Grant No.9149A12050414JW02180)
文摘Shear-mode piezoelectric materials have been widely used to shunt the damping of vibrations where utilizing surface or interface shear stresses. The thick-shear mode （TSM） elastic constant and the mechanical loss factor can change correspondingly when piezoelectric materials are shunted to different electrical circuits. This phenomenon makes it possible to control the performance of a shear-mode piezoelectric damping system through designing the shunt circuit. However, due to the difficulties in directly measuring the TSM elastic constant and the mechanical loss factor of piezoelectric materials, the relationships between those parameters and the shunt circuits have rarely been investigated. In this paper, a coupling TSM electro-mechanical resonant system is proposed to indirectly measure the variations of the TSM elastic constant and the mechanical loss factor of piezoelectric materials. The main idea is to transform the variations of the TSM elastic constant and the mechanical loss factor into the changes of the easily observed resonant frequency and electrical quality factor of the coupling electro-mechanical resonator. Based on this model, the formular relationships are set up theoretically with Mason equivalent circuit method and they are validated with finite element （FE） analyses. Finally, a prototype of the coupling electro-mechanical resonator is fabricated with two shear-mode PZT5A plates to investigate the TSM elastic constants and the mechanical loss factors of different circuit-shunted cases of the piezoelectric plate. Both the resonant frequency shifts and the bandwidth changes observed in experiments are in good consistence with the theoretical and FE analyses under the same shunt conditions. The proposed coupling resonator and the obtained relationships are validated with but not limited to PZT5A.
文摘Piezoelectric shunt damping has been widely used in vibration suppression, sound absorption, noise elimination, etc. In such applications, the variant elastic constants of piezoelectric materials are the essential parameters that determine the performances of the systems, when piezoelectric materials are shunted to normal electrical elements, i.e., resistance, inductance and capacitance, as well as their combinations. In recent years, many researches have demonstrated that the wideband sound absorption or vibration suppression can be realized with piezoelectric materials shunted to negative capacitance. However, most systems using the negative-capacitance shunt circuits show their instabilities in the optimal condition, which are essentially caused by the singular variation properties of elastic constants of piezoelectric materials when shunted to negative capacitance. This paper aims at investigating the effects of negative-capacitance shunt circuits on elastic constants of a piezoelectric ceramic plate through theoretical analyses and experiments, which gives an rational explanation for why negative capacitance shunt circuit is prone to make structure instable. First, the relationships between the elastic constants c11, c33, c55 of the piezoelectric ceramic and the shunt negative capacitance are derived with the piezoelectric constitutive law theoretically. Then, an experimental setup is established to verify the theoretical results through observing the change of elastic constant c55 of the shunted piezoelectric plate with the variation of negative capacitance. The experimental results are in good agreement with the theoretical analyses, which reveals that the instability of the shunt damping system is essentially caused by the singular variation property of the elastic constants of piezoelectric material shunted to negative capacitance.
文摘直流微电网中恒功率负荷(constant power load,CPL)表现为负阻尼特性,其大量接入会降低系统阻尼,引起直流母线电压振荡失稳。为此,提出一种虚拟电阻控制策略补偿下垂系数来提高系统稳定裕度。基于所提控制方法,建立直流微电网的小信号模型,分析直流侧电容、负荷功率、下垂系数和电流控制器参数变化对系统稳定性的影响,并对各参数进行灵敏度分析;根据下垂系数灵敏度大这一分析结果,提出虚拟电阻控制策略。再者,对于虚拟电阻在不同源变换器的应用效果,分别从Nyquist曲线图和灵敏度进行定性、定量分析,得出所提控制策略应用到网侧变换器对系统稳定性的提高效果更好。最后,在Matlab/Simulink中建立直流微电网模型进行仿真,仿真结果表明,所提控制策略能有效增强系统阻尼,提高系统稳定性。
