A two-grid algorithm based on Newton iteration for the stream function form of the Navier-Stokes equations

In this paper, we propose a two-grid algorithm for solving the stream function formulation of the stationary Navies-Stokes equations. The algorithm is constructed by reducing the original system to one small, nonlinear system on the coarse mesh space and two similar linear systems （with same stiffness matrix but different right-hand side） on the fine mesh space. The convergence analysis and error estimation of the algorithm are given for the case of conforming elements. Furthermore, the Mgorithm produces a numerical solution with the optimal asymptotic H^2-error. Finally, we give a numerical illustration to demonstrate the effectiveness of the two-grid algorithm for solving the Navier-Stokes equations.

RESIDUAL A POSTERIORI ERROR ESTIMATE TWO-GRID METHODS FOR THE STEADY (NAVIER-STOKES) EQUATION WITH STREAM FUNCTION FORM

Residual based on a posteriori error estimates for conforming finite element solutions of incompressible Navier-Stokes equations with stream function form which were computed with seven recently proposed two-level method were derived. The posteriori error estimates contained additional terms in comparison to the error estimates for the solution obtained by the standard finite element method. The importance of these additional terms in the error estimates was investigated by studying their asymptotic behavior. For optimal scaled meshes, these bounds are not of higher order than of convergence of discrete solution.

A FORM FUNCTION METHOD FOR FORM FINDING OF TENSION STRUCTURE

A new form function involving parameters Pi is presented. On the basis of the form function, an initial form of tension structure was Sound by interpolating through the control points on boundary of the structure. The form function can be controlled by changing beta (1) according to the pre-tension and the boundary of the structure. The final form of a tension structure should be an equilibrium system under the pretension. To examine the nature of the initial form, the FEM was used. Many examples show that the initial form gives a very ideal result for equal or unequal pre-tension in two directions of the structure. In general cases, there is little difference between the initial form and the final one.

A modeling approach for fuzzy programming with echelon form membership functions

In order to solve fuzzy mathematical programming with soft constraints,the initial models must first be converted into crisp models.Membership functions are employed to describe the fuzzy right-hand side parameters needed to achieve this conversion.In some cases,echelon form membership functions(EFMFs)are required to depict the actual fuzzy situation.However,due to their discrete properties,fuzzy programming problems with such membership functions cannot be modeled by traditional methods.Motivated by these challenges,this paper introduces a novel absolute value representation modeling approach to formulate fuzzy programming using EFMFs.This approach can translate a discrete model to a continuous one which can then be easily solved.Finally,by means of a numerical example,the effectiveness of our new approach is demonstrated.

Mathematic Model and Analytic Solution for a Cylinder Subject to Exponential Function

Hollow cylinders are widely used in spacecraft, rockets, weapons, metallurgy, materials, and mechanical manufacturing industries, and so on, hydraulic bulging roll cylinder and hydraulic press work all belong to hollow cylinders. However, up till now, the solution of the cylinder subjected to the pressures in the three-dimensional space is still at the stage of the analytical solution to the normal pressure or the approximate solution to the variable pressure by numerical method. The analytical solution to the variable pressure of the cylinder has not yet made any breakthrough in theory and can not meet accurate theoretical analysis and calculation requirements of the cylindrical in Engineering. In view of their importance, the precision calculation and theoretical analysis are required to investigate on engineering. A stress function which meets both the biharmonic equations and boundary conditions is constructed in the three-dimensional space. Furthermore, the analytic solution of a hollow cylinder subjected to exponential function distributed variable pressure on its inner and outer surfaces is deduced. By controlling the pressure subject to exponential function distributed variable pressure in the hydraulic bulging roller without any rolling load, using a static tester to record the strain supported hydraulic bulging roll, and comparing with the theoretical calculation, the experimental test result has a higher degree of agreement with the theoretical calculation. Simultaneously, the famous Lam6 solution can be deduced when given the unlimited length of cylinder along the axis. The analytic solution paves the way for the mathematic building and solution of hollow cylinder with randomly uneven pressure.

On the generalized Cauchy function and new Conjecture on its exterior singularities

This article studies on Cauchy’s function f （z） and its integral, （2πi）J[ f （z）] ≡ ■C f （t）dt/（t z） taken along a closed simple contour C, in regard to their comprehensive properties over the entire z = x ＋ iy plane consisted of the simply connected open domain D ＋ bounded by C and the open domain D outside C. （1） With f （z） assumed to be C n （n ∞-times continuously differentiable） z ∈ D ＋ and in a neighborhood of C, f （z） and its derivatives f （n） （z） are proved uniformly continuous in the closed domain D ＋ = [D ＋ ＋ C]. （2） Cauchy’s integral formulas and their derivatives z ∈ D ＋ （or z ∈ D ） are proved to converge uniformly in D ＋ （or in D = [D ＋C]）, respectively, thereby rendering the integral formulas valid over the entire z-plane. （3） The same claims （as for f （z） and J[ f （z）]） are shown extended to hold for the complement function F（z）, defined to be C n z ∈ D and about C. （4） The uniform convergence theorems for f （z） and F（z） shown for arbitrary contour C are adapted to find special domains in the upper or lower half z-planes and those inside and outside the unit circle ｜z｜ = 1 such that the four general- ized Hilbert-type integral transforms are proved. （5） Further, the singularity distribution of f （z） in D is elucidated by considering the direct problem exemplified with several typ- ical singularities prescribed in D . （6） A comparative study is made between generalized integral formulas and Plemelj’s formulas on their differing basic properties. （7） Physical sig- nificances of these formulas are illustrated with applicationsto nonlinear airfoil theory. （8） Finally, an unsolved inverse problem to determine all the singularities of Cauchy function f （z） in domain D , based on the continuous numerical value of f （z） z ∈ D ＋ = [D ＋ ＋ C], is presented for resolution as a conjecture.

Novel two-directional grid multi-scroll chaotic attractors based on the Jerk system

A new method is presented to generate two-directional (2D) grid multi-scroll chaotic attractors via a specific form of the sine function and sign function series, which are applied to increase saddle points of index 2. The scroll number in the x-direction is modified easily through changing the thresholds of the specific form of the sine function, while the scroll number in the y-direction is controlled by the sign function series. Some basic dynamical properties, such as equilibrium points, bifurcation diagram, phase portraits, and Lyapunov exponents spectrum are studied. Furthermore, the electronic circuit of the system is designed and its simulation results are given by Multisim 10.

Theta Function and Hilbert Modular Forms of Half Integral Weight

In this paper a kind of theta function is constructed by means of spherical function. And we also obtain some Hilbert modular forms of half integral weight.

NECESSARY AND SUFFICIENT CONDITIONS FOR THE EXISTENCE OF LIAPUNOV FUNCTION OF LUR'E FORM WITH■≤0

This paper is concerned with the problem of absolute stability for a control system with severalexecutive elements. Necessary and sufficient conditions are obtained for the existence of Liapunovfunction of Lur'e form with negative semi--definite derivative (i.e. V≤0).

Interpretation of appropriate places: State ceremonies and the imperial main halls of the Tang and Song dynasties

This paper aims to inquiry on the dialectical relationships between Chinese architecture’s form and function in the horizon of long-term historical evolution,by clarifying how the histories of imperial main halls and state ceremonies relate to and interact with each other during the Tang and Song dynasties.The imperialmain halls are themost archetypical and accomplished ones among traditional Chinese buildings,and their function is primarily ritual rather than practical.Although these magnificent buildings are indisputably considered the crowning achievement of Chinese architectural history,how the built space cooperates with ritual practices did not receive deserved attention.With the thorough reading of voluminous official ritual documents and comprehensive utilization of archaeological discoveries together with visual materials,the research presents a broad understanding of the asynchronous developments of the ground-level architectural arrangement and the ritual configuration across these centuries.Also specifically depicted are details of how architecture engaged in the ritual narration and was used as an apparatus to articulate emperor-courtier relationships.

ERROR ESTIMATION OF PREDICTION-CORRECTION LEGENDRE SPECTRAL APPROXIMATION TO INCOMPRESSIBLE FLUID FLOW

The initial-boundary value problem of two-dimensional incompressible fluid flow in stream function form is considered. A prediction-correction Legendre spectral scheme is presented, which is easy to be performed. It is strictly proved that the numerical solution possesses the accuracy of second-order in time and higher order in space.