Development of metal oxide semiconductors-based methane sensors with good response and low power consumption is one of the major challenges to realize the real-time monitoring of methane leakage.In this work,a self-as...Development of metal oxide semiconductors-based methane sensors with good response and low power consumption is one of the major challenges to realize the real-time monitoring of methane leakage.In this work,a self-assembled mulberry-like ZnO/SnO_(2)hierarchical structure is constructed by a two-step hydrothermal method.The resultant sensor works at room temperature with excellent response of~56.1%to 2000 ppm CH_(4)at 55%relative humidity.It is found that the strain induced at the ZnO/SnO_(2)interface greatly enhances the piezoelectric polarization on the ZnO surface and that the band bending results in the accumulation of chemically adsorbed O_(2)^(-)ions close to the interface,leading to significant improvement in the sensing performance of the methane gas sensor at room temperature.展开更多
Two-dimensional(2D) ZnO nanosheet arrays were prepared via vanadium(V)-doping assisted hydrothermal method, and then the nanosheet was successfully converted to a nanorod-on-nanosheet ZnO hierarchical structure by tre...Two-dimensional(2D) ZnO nanosheet arrays were prepared via vanadium(V)-doping assisted hydrothermal method, and then the nanosheet was successfully converted to a nanorod-on-nanosheet ZnO hierarchical structure by treating with Na_2S solution and subsequent hydrothermal reaction. Hierarchical films with different nanorod growth time(1–8h) were prepared and their photovoltaic properties were also investigated after electrodeposition of CdSe quantum dots. For the hierarchical nanorod-on-nanosheet ZnO films, increasing the ZnO nanorod growth time can enormously enlarge the length of branched nanorods and light-scattering ability, resulting in better light-harvesting efficiency and higher photo-generated electron concentration, which leads to higher short-circuit current density(J_(sc)) and open-circuit voltage(V_(oc)). However,further increasing nanorod growth time to 8h leads to the over-dense coverage of nanorods, which is harmful for light-harvesting efficiency and leads to severe electron recombination, eventually diminishes the power conversion efficiency(PCE). With the optimized nanorod modification and Cu_2S counter electrode, the PCE reaches a maximum value of 4.26%, which to the best of our knowledge, is among the highest PCE record for CdSe sensitized solar cells based on ZnO photoanodes.展开更多
基金financially supported by the National Natural Science Foundation of China(No.12174092,21902046,U21A20500)Overseas Expertise Introduction Center for Discipline Innovation(D18025)+1 种基金Hubei Provincial Department of Science and Technology(No.2019CFA079)Wuhan Science and Technology Bureau(2020010601012163)
文摘Development of metal oxide semiconductors-based methane sensors with good response and low power consumption is one of the major challenges to realize the real-time monitoring of methane leakage.In this work,a self-assembled mulberry-like ZnO/SnO_(2)hierarchical structure is constructed by a two-step hydrothermal method.The resultant sensor works at room temperature with excellent response of~56.1%to 2000 ppm CH_(4)at 55%relative humidity.It is found that the strain induced at the ZnO/SnO_(2)interface greatly enhances the piezoelectric polarization on the ZnO surface and that the band bending results in the accumulation of chemically adsorbed O_(2)^(-)ions close to the interface,leading to significant improvement in the sensing performance of the methane gas sensor at room temperature.
基金supported by the National Natural Science Foundation of China(51472274)the Programof Guangzhou Science and Technology(2014J4100016 and 201504010031)+1 种基金the Pearl River S&T Nova Program of Guangzhou(2014J2200025)the Natural Science Foundation of Guangdong Province(S2013030013474)
文摘Two-dimensional(2D) ZnO nanosheet arrays were prepared via vanadium(V)-doping assisted hydrothermal method, and then the nanosheet was successfully converted to a nanorod-on-nanosheet ZnO hierarchical structure by treating with Na_2S solution and subsequent hydrothermal reaction. Hierarchical films with different nanorod growth time(1–8h) were prepared and their photovoltaic properties were also investigated after electrodeposition of CdSe quantum dots. For the hierarchical nanorod-on-nanosheet ZnO films, increasing the ZnO nanorod growth time can enormously enlarge the length of branched nanorods and light-scattering ability, resulting in better light-harvesting efficiency and higher photo-generated electron concentration, which leads to higher short-circuit current density(J_(sc)) and open-circuit voltage(V_(oc)). However,further increasing nanorod growth time to 8h leads to the over-dense coverage of nanorods, which is harmful for light-harvesting efficiency and leads to severe electron recombination, eventually diminishes the power conversion efficiency(PCE). With the optimized nanorod modification and Cu_2S counter electrode, the PCE reaches a maximum value of 4.26%, which to the best of our knowledge, is among the highest PCE record for CdSe sensitized solar cells based on ZnO photoanodes.