It is useful for practical operation to study the rules of production of propylene by the catalytic conversion of heavy oil in FCC （fluid catalytic cracking）. The effects of temperature and C/O ratio （catalyst to o...It is useful for practical operation to study the rules of production of propylene by the catalytic conversion of heavy oil in FCC （fluid catalytic cracking）. The effects of temperature and C/O ratio （catalyst to oil weight ratio） on the distribution of the product and the yield of propylene were investigated on a micro reactor unit with two model catalysts, namely ZSM-5/Al2O3 and USY/Al2O3, and Fushun vacuum gas oil （VGO） was used as the feedstock. The conversion of heavy oil over ZSM-5 catalyst can be comparable to that of USY catalyst at high temperature and high C/O ratio. The rate of conversion of heavy oil using the ZSM-5 equilibrium catalyst is lower compared with the USY equilibrium catalyst under the general FCC conditions and this can be attributed to the poor steam ability of the ZSM-5 equilibrium catalyst. The difference in pore topologies of USY and ZSM-5 is the reason why the principal products for the above two catalysts is different, namely gasoline and liquid petroleum gas （LPG）, repspectively. So the LPG selectivity, especially the propylene selectivity, may decline if USY is added into the FCC catalyst for maximizing the production of propylene. Increasing the C/O ratio is the most economical method for the increase of LPG yield than the increase of the temperature of the two model catalysts, because the loss of light oil is less in the former case. There is an inverse correlation between HTC （hydrogen transfer coefficient） and the yield of propylene, and restricting the hydrogen transfer reaction is the more important measure in increasing the yield of propylene of the ZSM-5 catalyst. The ethylene yield of ZSM-5/A1203 is higher, but the gaseous side products with low value are not enhanced when ZSM-5 catalyst is used. Moreover, for LPG and the end products, dry gas and coke, their ranges of reaction conditions to which their yields are dependent are different, and that of end products is more severe than that of LPG. So it is clear that maximizing LPG and propylene and restricting dry gas and coke can be both achieved via increasing the severity of reaction conditions among the range of reaction conditions which LPG yield is sensitive to.展开更多
Preparation of biodiesel from waste oils containing 72% of free fatty acids catalyzed by a novel Br?nsted acidic ionic liquid 1-sulfobutyl-3-methylimidazolium hydrosulfate([BHSO_3MIM][HSO_4]) was systematically invest...Preparation of biodiesel from waste oils containing 72% of free fatty acids catalyzed by a novel Br?nsted acidic ionic liquid 1-sulfobutyl-3-methylimidazolium hydrosulfate([BHSO_3MIM][HSO_4]) was systematically investigated.The optimum molar ratio of methanol to waste oils,catalyst amount,reaction temperature and reaction time were 8/1,10%(based on the mass of waste oils),140°C and 6 h,respectively,under which the obtained yield of biodiesel reached 94.9%.Also,[BHSO_3MIM][HSO_4] as a catalyst still retained around 97% of its original catalytic activity after successive re-use of 5 batches(6 h per batch),showing the excellent operational stability.Moreover,the acidic IL [BHSO_3MIM][HSO_4] was able to ef ficiently catalyze conversions of waste oils with different amounts of FFAs(free fatty acids) into biodiesel,and showed tremendous application potential.Therefore,an ef ficient and environmentally friendly catalyst is provided for the synthesis of biodiesel from waste oils with high acid value.展开更多
YTB block in Sichuan basin is a favorable area to exploit oil and gas in shallow tight rock. 3D seismic project of this zone has two characteristics. Firstly, it has high requirements for the tolerance rate of the con...YTB block in Sichuan basin is a favorable area to exploit oil and gas in shallow tight rock. 3D seismic project of this zone has two characteristics. Firstly, it has high requirements for the tolerance rate of the construction process and the acquisition of high signal-to-noise ratio seismic data;Second, there are widely obstacles and noises that lead to difficult acquisition construction organization. In acquisition practice, high signal-to-noise ratio seismic data was obtained by reasonable design of construction scheme, optimization of excitation parameters, improvement of receiving conditions and optimization of obstacle crossing observation system. .展开更多
文摘It is useful for practical operation to study the rules of production of propylene by the catalytic conversion of heavy oil in FCC （fluid catalytic cracking）. The effects of temperature and C/O ratio （catalyst to oil weight ratio） on the distribution of the product and the yield of propylene were investigated on a micro reactor unit with two model catalysts, namely ZSM-5/Al2O3 and USY/Al2O3, and Fushun vacuum gas oil （VGO） was used as the feedstock. The conversion of heavy oil over ZSM-5 catalyst can be comparable to that of USY catalyst at high temperature and high C/O ratio. The rate of conversion of heavy oil using the ZSM-5 equilibrium catalyst is lower compared with the USY equilibrium catalyst under the general FCC conditions and this can be attributed to the poor steam ability of the ZSM-5 equilibrium catalyst. The difference in pore topologies of USY and ZSM-5 is the reason why the principal products for the above two catalysts is different, namely gasoline and liquid petroleum gas （LPG）, repspectively. So the LPG selectivity, especially the propylene selectivity, may decline if USY is added into the FCC catalyst for maximizing the production of propylene. Increasing the C/O ratio is the most economical method for the increase of LPG yield than the increase of the temperature of the two model catalysts, because the loss of light oil is less in the former case. There is an inverse correlation between HTC （hydrogen transfer coefficient） and the yield of propylene, and restricting the hydrogen transfer reaction is the more important measure in increasing the yield of propylene of the ZSM-5 catalyst. The ethylene yield of ZSM-5/A1203 is higher, but the gaseous side products with low value are not enhanced when ZSM-5 catalyst is used. Moreover, for LPG and the end products, dry gas and coke, their ranges of reaction conditions to which their yields are dependent are different, and that of end products is more severe than that of LPG. So it is clear that maximizing LPG and propylene and restricting dry gas and coke can be both achieved via increasing the severity of reaction conditions among the range of reaction conditions which LPG yield is sensitive to.
基金Supported by the National Natural Science Foundation of China(21676104,21336002,21376096)the Open Funding Project of the State Key Laboratory of Bioreactor Engineeringthe Program of State Key Laboratory of Pulp and Paper Engineering(2017ZD05)
文摘Preparation of biodiesel from waste oils containing 72% of free fatty acids catalyzed by a novel Br?nsted acidic ionic liquid 1-sulfobutyl-3-methylimidazolium hydrosulfate([BHSO_3MIM][HSO_4]) was systematically investigated.The optimum molar ratio of methanol to waste oils,catalyst amount,reaction temperature and reaction time were 8/1,10%(based on the mass of waste oils),140°C and 6 h,respectively,under which the obtained yield of biodiesel reached 94.9%.Also,[BHSO_3MIM][HSO_4] as a catalyst still retained around 97% of its original catalytic activity after successive re-use of 5 batches(6 h per batch),showing the excellent operational stability.Moreover,the acidic IL [BHSO_3MIM][HSO_4] was able to ef ficiently catalyze conversions of waste oils with different amounts of FFAs(free fatty acids) into biodiesel,and showed tremendous application potential.Therefore,an ef ficient and environmentally friendly catalyst is provided for the synthesis of biodiesel from waste oils with high acid value.
文摘YTB block in Sichuan basin is a favorable area to exploit oil and gas in shallow tight rock. 3D seismic project of this zone has two characteristics. Firstly, it has high requirements for the tolerance rate of the construction process and the acquisition of high signal-to-noise ratio seismic data;Second, there are widely obstacles and noises that lead to difficult acquisition construction organization. In acquisition practice, high signal-to-noise ratio seismic data was obtained by reasonable design of construction scheme, optimization of excitation parameters, improvement of receiving conditions and optimization of obstacle crossing observation system. .
