Rate transient analysis methods for water-producing gas wells in tight reservoirs with mobile water

Tight gas reservoirs with mobile water exhibit multi-phase flow and high stress sensitivity.Accurately analyzing the reservoir and well parameters using conventional single-phase rate transient analysis methods proves challenging.This study introduces novel rate transient analysis methods incorporating evaluation processes based on the conventional flowing material balance method and the Blasingame type-curve method to examine fractured gas wells producing water.By positing a gas-water two-phase equivalent homogenous phase that considers characteristics of mobile water,gas,and high stress sensitivity,the conventional single-phase rate transient analysis methods can be applied by integrating the phase's characteristics and defining the phase's normalized parameters and material balance pseudotime.The rate transient analysis methods based on the equivalent homogenous phase can be used to quantitatively assess the parameters of wells and gas reservoirs,such as original gas-in-place,fracture half-length,reservoir permeability,and well drainage radius.This facilitates the analysis of production dynamics of fractured wells and well-controlled areas,subsequently aiding in locating residual gas and guiding the configuration of well patterns.The specific evaluation processes are detailed.Additionally,a numerical simulation mechanism model was constructed to verify the reliability of the developed methods.The methods introduced have been successfully implemented in field water-producing gas wells within tight gas reservoirs containing mobile water.

An eigenelement method and two homogenization conditions

Under inspiration from the structure-preserving property of symplectic difference schemes for Hamiltonian systems, two homogenization conditions for a representative unit cell of the periodical composites are proposed, one condition is the equivalence of strain energy, and the other is the deformation similarity. Based on these two homogenization conditions, an eigenelement method is presented, which is characteristic of structure-preserving property. It follows from the frequency comparisons that the eigenelement method is more accurate than the stiffness average method and the compliance average method.

Site response of heterogeneous natural deposits to harmonic excitation applied to more than 100 case histories

Variation of shear-wave propagation velocity （SWV） with depth was studied by analyzing more than one hundred actual SWV profiles. Linear, power, and hyperbolic variation schemes were investigated to find the most representative form for naturally occurred alluvial deposits. It was found that hyperbolic （asymptotic） variation dominates the majority of cases and it can be reliably implemented in analytical or analytical-numerical procedures. Site response analyses for a one-layer heterogeneous stratum were conducted to find an equivalent homogeneous alternative which simplifies the analysis procedure but does not compromise the accuracy of the resonance and amplification responses. Harmonic average, arithmetic average and mid-value equivalents are chosen from the literature for investigation. Furthermore, full and partial depth averaging schemes were evaluated and compared in order to verify the validity of current practices which rely upon averaging shallow depths, viz., the first 30 m of the strata. Engineering bedrock concept was discussed and the results were compared.

EXPERIMENTAL EVALUATION ON MODULUS OF EQUIVALENT HOMOGENEOUS ETTRINGITE

In the present study, the average modulus of delayed ettringite is evaluated by an experimental method combined with theoretical analysis. Firstly, the delayed ettringite crystal is synthesized by chemical reaction of Aluminum sulfate and calcium hydroxide. Secondly, specimens are obtained by compressing the delayed ettringite crystal under different pre-loads. Thirdly, the variation of the modulus of the specimen with different pre-loads is tested using Instron material test machine and the SHPB technique, respectively. It is found that the experimental data may be suitably fitted by Boltzmann Function. Finally, the porosity of the specimen is detected using the saturation method, and the effect of the porosity on the modulus is analyzed by the Eshelby＇s equivalent inclusion method and the Mori-Tanaka＇s scheme. The static and dynamic modulli of the equivalent homogeneous ettringite obtained in present study are approximately 10.64 GPa and 24.61 GPa, respectively.

THE CONSTITUTIVE EQUATION RESEMBLANCE OF ELASTIC-PLASTIC MULTIPHASE SOLID

Based on composite materials, the equivalent elastic-plastic constitutive equations of multiphase solid are researched. According to the suggested definition of. constitutive equivalence it is demonstrated that the multiphase solid, composed of several kinds of homogeneous elastic-plastic media that conform to the generalized normality rule, has the same type of constitutive equations as its constituents have that also conform to the generalized normality rule.

A new equivalent method to obtain the stoichiometric fuel-air cloud from the inhomogeneous cloud based on FLACS-dispersion

The fuel-air cloud resulting from an accidental discharge event is normally irregular in shape and varying in concentration. Performance of dispersion simulations using the computational fluid dynamics （CFD）-based tool FLACS can get an uneven and irregular cloud. For the performance of gas explosion study with FLACS, the equivalent stoichiometric fuel-air cloud concept is widely applied to get a representative distribution of explosion loads. The Q9 cloud model that is employed in FLACS is an equivalent fuel-air cloud representation, in which the laminar burning velocity with first order SL and volume expansion ratio are taken into consideration. However, during an explosion in congested areas, the main part of the combustion involves turbulent flame propagation. Hence, to give a more reasonable equivalent fuel-air size, the turbulent burning velocity must be taken into consideration. The paper presents a new equivalent cloud method using the turbulent burning velocity, which is described as a function of SL, deduced from the TNO multi- energy method.