Experimental Research on Lower Hybrid Current Drive in Superconducting Tokamak HT-7

?Fundamental experiments on lower hybrid current drive (LHCD) have been undertaken on HT-7 superconducting tokamak. The experiments on LHCD efficiency reveal its depen- deuce on plasma density and the toroidal magnetic field. Furthermore, the experiments on HT-7 successfully demonstrate the ability for LHCD to sustain long pulse tokamak discharges, such as discharges with full non-inductive current drive for several seconds. The experimental study to improve plasma confinements by LHCD suggests that the improvement should be due to the change o f current profile. It has also been demonstrated by the experiments that the lower hybrid wave may lead to an enhanced ionization of particles in the region where the wave is deposited.

Effect of Wave Accessibility on Lower Hybrid Wave Current Drive in Experimental Advanced Superconductor Tokamak with H-Mode Operation

The effect of the wave accessibility condition on the lower hybrid cm＇rent drive in the experimental advanced superconductor Tokamak （EAST） plasma with H-mode operation is studied. Based on a simplified model, a mode conversion layer of the lower hybrid wave between the fast wave branch and the slow wave branch is proved to exist in the plasma periphery for typical EAST H-mode parameters. Under the framework of the lower hybrid wave simulation code （LSC）, the wave ray trajectory and the associated current drive are calculated numerically. The results show that the wave accessibility condition plays an important role on the lower hybrid current drive in EAST plasma. For wave rays with parallel refractive index n｜｜= 2.1 or n｜｜ = 2.5 launched from the outside midplane, the wave rays may penetrate the core plasma due to the toroida] geometry effect, while numerous reflections of the wave ray trajectories in the plasma periphery occur. However, low current drive efficiency is obtained. Meanwhile, the wave accessibility condition is improved if a higher confined magnetic field is applied. The simulation results show that for plasma parameters under present EAST H-mode operation, a significant lower hybrid wave current drive could be obtained for the wave spectrum with peak value n｜｜ = 2.1 if a toroidal magnetic field BT =2.5 T is applied.

Predictive Modeling and Parameter Optimization of Cutting Forces During Orbital Drilling

To optimize cutting control parameters and provide scientific evidence for controlling cutting forces,cutting force modeling and cutting control parameter optimization are researched with one tool adopted to orbital drill holes in aluminum alloy 6061.Firstly,four cutting control parameters(tool rotation speed,tool revolution speed,axial feeding pitch and tool revolution radius)and affecting cutting forces are identified after orbital drilling kinematics analysis.Secondly,hybrid level orthogonal experiment method is utilized in modeling experiment.By nonlinear regression analysis,two quadratic prediction models for axial and radial forces are established,where the above four control parameters are used as input variables.Then,model accuracy and cutting control parameters are analyzed.Upon axial and radial forces models,two optimal combinations of cutting control parameters are obtained for processing a13mm hole,corresponding to the minimum axial force and the radial force respectively.Finally,each optimal combination is applied in verification experiment.The verification experiment results of cutting force are in good agreement with prediction model,which confirms accracy of the research method in practical production.

Separation of contact stress components by moire interferometry

A hybrid technique of combining moire measurement and analytical solution is developed to separate the normal and the tangential components of distributed contact stresses between two co-plane bodies. The moire interfe-rometry offers the displacement fields near the deformed contact zone, from which the tangential strains and boundary slopes of the deformed configurations can be evaluated. Those experimental results provide boundary conditions for the discrete integration of Flamant＇s solutions, to inversely compute the separated components of the contact stresses.