A novel technology of preparation of felt-metal supported modified polyvinyl alcohol（PVA） ultrafiltration（UF） membrane was invented, which could avoid the blockage of the holes of support layer and the leakage of ...A novel technology of preparation of felt-metal supported modified polyvinyl alcohol（PVA） ultrafiltration（UF） membrane was invented, which could avoid the blockage of the holes of support layer and the leakage of the casting solution through the holes of support layer. Felt-metal supported ferric sulfate modified PVA composite UF membranes were prepared by the innovative technology. The results show that the composite membranes are used to treat 1 000 mg/L oil/water emulsion at trans-membrane pressure from 0.25 to 0.45 MPa, the permeate flux is from 36 to 52 L/（m2·h）, and the retention of chemical oxygen demand（COD） is over 92%. The composite membrane resistance increases with the increase of trans-naembrane pressure.展开更多
A hydrophilic composite polybutylene terephthalate(PBT)/polyvinyl alcohol(PVA)membrane with great potential applications in biological filtration has been investigated in this research.The composite membranes were fab...A hydrophilic composite polybutylene terephthalate(PBT)/polyvinyl alcohol(PVA)membrane with great potential applications in biological filtration has been investigated in this research.The composite membranes were fabricated by electrospinning with PBT meltblown nonwovens as the receiving substrate.These membranes have higher strength than the conventional single layer electrospinning membrane,smaller pore diameter than the common meltblown PBT nonwovens,good hydrophilicity,and high water flux.The flux of the composite membrane was 5.97×10^(3) L/(m^(2)·h)for 5%(mass fraction)glucose solution,which was higher than that of the commercial blood filtration membranes.The optimal process for preparing PBT/PVA composite membranes was obtained by orthogonal experiments.In general,the preparation process is simple and easy to control.展开更多
Metal-polyvinyl alcohol(PVA) composite ultrafiltration membranes were prepared by coating a certain concentration of PVA solution on metallic fiber sintered membranes. The effects of preparation conditions, such as th...Metal-polyvinyl alcohol(PVA) composite ultrafiltration membranes were prepared by coating a certain concentration of PVA solution on metallic fiber sintered membranes. The effects of preparation conditions, such as the coating solution concentration, sequence and times of coating, and heat-treatment on the properties of the composite membranes were studied. The results show that the hole diameter of the composite membrane decreases with the increase of the concentration of PVA, the hole diameter of composite membrane is different when the sequence of coating is different. When the higher concentration of PVA solution is used to coat the metallic membrane for the first time and the other smaller one for the second time, the hole diameter of the composite membrane is relatively small, compared with that of the composite membrane made by the smaller concentration of PVA solution for the first time and the other higher one for the second time. The holes of the composite membrane contract and the stability of the membrane is improved by heat treatment. When metal-PVA composite hydrophilic membranes are used to treat the oil/water emulsion with the concentration of 1 000 mg·L -1 , the retention is from 80% to 90%, and the permeate flux is from 15 L·m -2 ·h -1 to 40 L·m -2 ·h -1 at pressure of 0.2 to 0.3 MPa.展开更多
文摘A novel technology of preparation of felt-metal supported modified polyvinyl alcohol（PVA） ultrafiltration（UF） membrane was invented, which could avoid the blockage of the holes of support layer and the leakage of the casting solution through the holes of support layer. Felt-metal supported ferric sulfate modified PVA composite UF membranes were prepared by the innovative technology. The results show that the composite membranes are used to treat 1 000 mg/L oil/water emulsion at trans-membrane pressure from 0.25 to 0.45 MPa, the permeate flux is from 36 to 52 L/（m2·h）, and the retention of chemical oxygen demand（COD） is over 92%. The composite membrane resistance increases with the increase of trans-naembrane pressure.
文摘A hydrophilic composite polybutylene terephthalate(PBT)/polyvinyl alcohol(PVA)membrane with great potential applications in biological filtration has been investigated in this research.The composite membranes were fabricated by electrospinning with PBT meltblown nonwovens as the receiving substrate.These membranes have higher strength than the conventional single layer electrospinning membrane,smaller pore diameter than the common meltblown PBT nonwovens,good hydrophilicity,and high water flux.The flux of the composite membrane was 5.97×10^(3) L/(m^(2)·h)for 5%(mass fraction)glucose solution,which was higher than that of the commercial blood filtration membranes.The optimal process for preparing PBT/PVA composite membranes was obtained by orthogonal experiments.In general,the preparation process is simple and easy to control.
文摘Metal-polyvinyl alcohol(PVA) composite ultrafiltration membranes were prepared by coating a certain concentration of PVA solution on metallic fiber sintered membranes. The effects of preparation conditions, such as the coating solution concentration, sequence and times of coating, and heat-treatment on the properties of the composite membranes were studied. The results show that the hole diameter of the composite membrane decreases with the increase of the concentration of PVA, the hole diameter of composite membrane is different when the sequence of coating is different. When the higher concentration of PVA solution is used to coat the metallic membrane for the first time and the other smaller one for the second time, the hole diameter of the composite membrane is relatively small, compared with that of the composite membrane made by the smaller concentration of PVA solution for the first time and the other higher one for the second time. The holes of the composite membrane contract and the stability of the membrane is improved by heat treatment. When metal-PVA composite hydrophilic membranes are used to treat the oil/water emulsion with the concentration of 1 000 mg·L -1 , the retention is from 80% to 90%, and the permeate flux is from 15 L·m -2 ·h -1 to 40 L·m -2 ·h -1 at pressure of 0.2 to 0.3 MPa.
