Constant load creep tests on isothermally forged Udimet 720Li, an advanced superalloy for gas turbine disc application, were run in the stress/temperature field 900-450MPa/650-700 ℃ producing rupture times in the 20-...Constant load creep tests on isothermally forged Udimet 720Li, an advanced superalloy for gas turbine disc application, were run in the stress/temperature field 900-450MPa/650-700 ℃ producing rupture times in the 20-5000h range. The creep curves have shown a predominant accelerating creep stage, that has been described by the following equation: where ε min depends on stress and temperature, while parameter C depends mainly on stress. A strain dependent damage, defined by the parameter C, causes the accelerating creep stage at stresses lower than 750MPa, whilst its contribution to the creep strain acceleration is less important at higher stresses. The model rationalizes the different behaviors at high and low stress and has been validated with variable stress and temperature creep behavior.展开更多
The Na I:Tl scintillator is an innovative material for dual-gamma-ray and neutron detection with a low ^(6)Li concentration.To achieve real-time n/γ discrimination,a zero-crossing time comparison algorithm based on t...The Na I:Tl scintillator is an innovative material for dual-gamma-ray and neutron detection with a low ^(6)Li concentration.To achieve real-time n/γ discrimination,a zero-crossing time comparison algorithm based on trapezoidal pulse shaping was developed.The algorithm can operate efficiently at low sampling rates and was implemented on a single-probe portable digital n/γ discriminator based on a field-programmable gate array.The discriminator and Na I:Tl,^(6)Li detector were tested in a neutron-gamma mixed field produced by an ^(241)Am-Be neutron source to evaluate the performance of the algorithm.The figure of merits was measured as 2.88 at a sampling rate of 50 MHz,indicating that the discriminator with its embedded algorithm has a promising n/γ discrimination capability.Efficient discrimination at sampling rates of 40 and 25 MHz demonstrates that the capability of this method is not limited by low sampling rates.展开更多
文摘Constant load creep tests on isothermally forged Udimet 720Li, an advanced superalloy for gas turbine disc application, were run in the stress/temperature field 900-450MPa/650-700 ℃ producing rupture times in the 20-5000h range. The creep curves have shown a predominant accelerating creep stage, that has been described by the following equation: where ε min depends on stress and temperature, while parameter C depends mainly on stress. A strain dependent damage, defined by the parameter C, causes the accelerating creep stage at stresses lower than 750MPa, whilst its contribution to the creep strain acceleration is less important at higher stresses. The model rationalizes the different behaviors at high and low stress and has been validated with variable stress and temperature creep behavior.
基金This work was supported by the National Natural Science Foundation of China(NSFC)(No.12075308).
文摘The Na I:Tl scintillator is an innovative material for dual-gamma-ray and neutron detection with a low ^(6)Li concentration.To achieve real-time n/γ discrimination,a zero-crossing time comparison algorithm based on trapezoidal pulse shaping was developed.The algorithm can operate efficiently at low sampling rates and was implemented on a single-probe portable digital n/γ discriminator based on a field-programmable gate array.The discriminator and Na I:Tl,^(6)Li detector were tested in a neutron-gamma mixed field produced by an ^(241)Am-Be neutron source to evaluate the performance of the algorithm.The figure of merits was measured as 2.88 at a sampling rate of 50 MHz,indicating that the discriminator with its embedded algorithm has a promising n/γ discrimination capability.Efficient discrimination at sampling rates of 40 and 25 MHz demonstrates that the capability of this method is not limited by low sampling rates.
