Analysis of Mechanical Properties of Injection Molded Short Glass Fibre (SGF)/Calcite/ABS Composites

Acrylonitrile-butadiene-Styrene (ABS), with and without calcium carbonate (calcite) particles,was used as the matrix for reinforcement with as-received short-glass fibres (were originallytreated by the manufacturer) and sized short-glass fibres with two amino-silane coupling agents.The calcite particle content is 0, 11.7 and 23.5 vol. pct for the matrices. The glass fiber contentis 0, 10 and 15 vol. pct. The matrix materials and corresponding composites were compoundedusing a twin screw extruder and dumbbell-shaped tensile bars were prepared with an injectionmolding process. The tensile and flexural properties as well as the unnotched and notchedCharpy impact energies of short glass fibre/calcite/ABS composites were studied in this paper.The effects of fibres, fibre surface treatments and particles on these mechanical properties ofthe composites were discussed in detail. An importarit information was obtained, which is thatthe tensile and flexural strengths of hybrid SGF/calcite/ABS composites are the same as thoseof corresponding fibre composites when the ratio of the interfacial adhesion strength betweenparticles and matrix to that between fibres and matrix is higher than certain value. otherwise theformer are lower than the latter.

Microstructure and mechanical property of MIM 418 superalloy

In this study, the influence of hot isostatic pressing（HIP） process on the 418 alloy produced by metal injection molding（MIM） technique（named as MIM 418）was investigated based on the characteristic analysis of 418 alloy powder. And comparison analysis of the microstructure and mechanical property between the MIM 418 and as-cast 418 alloys was performed by scanning electron microscopy（SEM）, energy-dispersive spectroscopy（EDS）,and X-ray diffraction（XRD）. The results show that MIM418 alloy exhibits fine grain（~30 μm） and uniform microstructure. The defects existing in MIM 418 alloy formed during sintering process can be eliminated through HIP treatment, and the relative density increases from97.0 % to 99.5 %. The mechanical property can be improved significantly because of the elimination of defects, and the tensile strength and elongation are1,271 MPa and 16.8 %, respectively, which are increased by 34.5 % and 180 % compared with K418 alloy after solution heat treatment.

Glycidyl methacrylate-compatibilized poly(lactic acid)/hemp hurd biocomposites： Processing, crystallization, and thermo-mechanical response

Poly（lactic acid）-based biocomposites were developed with hemp hurd （Cannabis sativa L.） with grafting-based interfacial compatibilization. Poly（lactic acid） was extruded with hemp hurd and glycidyl methacrylate as the polymer/hurd interfacial compatibilizer, and injection molded. Interfacial compatibility between poly（lactic acid） and hemp hurd increased with grafted glycidyl methacrylate in comparison to the non-compatibilized control, as corroborated by scanning electron microscopy fractog- raphy and mechanical analysis, which showed increases in the glycidyl methacrylate-grafted 20% （w/w） hemp hurd/poly（lactic acid） biocomposite, retaining 94% of the neat polymer strength, with increases in crystallinity, and showing a range of thermo-mechanical properties desirable for rigid biocomposite aoolications.