Investigating the Effects of Interface Topology on Flow Development in Rod Bundle Supported by Spacer Grid with Split Mixing Vane Using STAR-CCM+

Flow development downstream of a spacer grid is dependent on the upstream conditions and the imposed interface topology, especially at inlet and outlet boundaries. In STAR-CCM+, all interfaces fall into two groups, direct and indirect. A direct interface directly joins together two boundaries composing the interface either permanently or temporarily, for the case of rigid body motion. An explicit connection is created between cells on each side of the interface, so that mass and energy or either of them will occur across the interface. Three options of interface topology namely, in-place, periodic and repeating are available to be imposed at the inlet-outlet boundaries for a flow problem. In the present work, computational fluid dynamic simulation using STAR-CCM+ was performed for the flow of water at a bundle’s Reynolds number of Re1 = 3.4 × 104 through a 5 × 5 rod bundle geometry supported by spacer grid with and without split mixing vanes for which the rod-to-rod pitch to diameter ratio was 1.33 and the rod to wall pitch to diameter ratio was 0.74. The two-layer k-epsilon turbulence model with an all y+ automatic wall treatment function in STAR-CCM+ was adopted for an isothermal single phase (water) flow through the geometry with and without imposed cyclic periodic interface boundary condition of fully developed flow type at inlet and outlet boundaries. The objectives were to primarily investigate the extent of predictability of the experimental data by the Computational Fluid Dynamic (CFD) simulation as a measure of reliability on the CFD code employed, and also study the effects of the imposed interface topology on flow redistribution in the presence and absence of split mixing vane. Validation of simulation results with experimental data showed a good correlation of mean flow parameters with experimental data. Generally, the agreement of simulation results with data obtained from the experimental investigation confirmed the suitability of the CFD code, STAR-CCM+ to analyze the physical problem considered. Trends of flow redistribution downstream of the spacer grid indicate that, the split mixing vanes acted to quickly bring the flow to an equitable redistribution downstream of the spacer grid irrespective of the imposed inlet-outlet interface topology. For the case of the spacer grid without mixing vanes, some extents of deviation were realized between the model with no imposed interface topology and that with imposed periodic interface topology. The variation in trends shows that, a much longer inlet segment of the domain is required to completely nullify the effect of the inlet-outlet interface topology on flow distribution in the absence of mixing vanes which may lead to a relatively higher demand for computational resources than required in the presence of mixing vanes.

Dual-channel tunable near-infrared absorption enhancement with graphene induced by coupled modes of topological interface states

The dual-channel nearly perfect absorption is realized by the coupled modes of topological interface states(TIS) in the near-infrared range. An all-dielectric layered heterostructure composed of photonic crystals(Ph C)/graphene/Ph C/graphene/Ph C on Ga As substrate is proposed to excite the TIS at the interface of adjacent Ph C with opposite topological properties. Based on finite element method(FEM) and transfer matrix method(TMM), the dualchannel absorption can be modulated by the periodic number of middle Ph C, Fermi level of graphene, and angle of incident light(TE and TM polarizations). Especially, by fine-tuning the Fermi level of graphene around 0.4 e V, the absorption of both channels can be switched rapidly and synchronously. This design is hopefully integrated into silicon-based chips to control light.

Tunable topological interface states and resonance states of surface waves based on the shape memory alloy

Topological interface state(TIS)of elastic wave has attracted significant research interest due to its potential prospects in strengthening acoustic energy and enhancing the signal accuracy of damage identification and quantification.However,previous implementations on the interface modes of surface waves are limited to the non-adjustable frequency band and unalterable mode width.Here,we demonstrate the tunable TIS and topological resonance state(TRS)of Rayleigh wave by using a shape memory alloy(SMA)stubbed semi-infinite one-dimensional(1D)solid phononic crystals(PnCs),which simultaneously possesses the adjustable mode width.The mechanism of tunability stems from the phase transformation of the SMA between the martensite at low temperature and the austenite at high temperature.The tunable TIS of Rayleigh wave is realized by combining two bandgap-opened PnCs with different Zak phases.The TRS with adjustable mode width is achieved in the heterostructures by adding PnCs with Dirac point to the middle of two bandgap-opened PnCs with different Zak phases,which exhibits the extraordinary robustness in contrast to the ordinary Fabry–Perot resonance state.This research provides new possibilities for the highly adjustable Rayleigh wave manipulation and find promising applications such as tunable energy harvesters,wide-mode filters,and high-sensitivity Rayleigh wave detectors.

Magnetic Proximity Effect in an Antiferromagnetic Insulator/Topological Insulator Heterostructure with Sharp Interface

We report an experimental study of electron transport properties of MnSe/(Bi,Sb)_2Te_3 heterostructures,in which MnSe is an antiferromagnetic insulator,and(Bi,Sb)_2Te_3 is a three-dimensional topological insulator(TI).Strong magnetic proximity effect is manifested in the measurements of the Hall effect and longitudinal resistances.Our analysis shows that the gate voltage can substantially modify the anomalous Hall conductance,which exceeds 0.1 e^(2)/h at temperature T=1.6 K and magnetic field μ_0H=5 T,even though only the top TI surface is in proximity to MnSe.This work suggests that heterostructures based on antiferromagnetic insulators provide a promising platform for investigating a wide range of topological spintronic phenomena.

Topological quantum memory interfacing atomic and superconducting qubits

We propose a scheme to manipulate a topological spin qubit which is realized with cold atoms in a one-dimensional optical lattice.In particular, by introducing a quantum opto-electro-mechanical interface, we are able to first transfer a superconducting qubit state to an atomic qubit state and then to store it into the topological spin qubit. In this way, an efficient topological quantum memory could be constructed for the superconducting qubit. Therefore, we can consolidate the advantages of both the noise resistance of the topological qubits and the scalability of the superconducting qubits in this hybrid architecture.