Study on the disaster caused by the linkage failure of the residual coal pillar and rock stratum during multiple coal seam mining:mechanism of progressive and dynamic failure

Multi-seam mining often leads to the retention of a significant number of coal pillars for purposes such as protection,safety,or water isolation.However,stress concentration beneath these residual coal pillars can significantly impact their strength and stability when mining below them,potentially leading to hydraulic support failure,surface subsidence,and rock bursting.To address this issue,the linkage between the failure and instability of residual coal pillars and rock strata during multi-seam mining is examined in this study.Key controls include residual pillar spalling,safety factor(f.),local mine stiffness(LMS),and the post-peak stiffness(k)of the residual coal pillar.Limits separating the two forms of failure,progressive versus dynamic,are defined.Progressive failure results at lower stresses when the coal pillar transitions from indefinitely stable(f,>1.5)to failing(f,<1.5)when the coal pillar can no longer remain stable for an extended duration,whereas sud-den(unstable)failure results when the strength of the pillar is further degraded and fails.The transition in mode of failure is defined by the LMS/k ratio.Failure transitions from quiescent to dynamic as LMS/k.<1,which can cause chain pillar instability propagating throughout the mine.This study provides theoretical guidance to define this limit to instability of residual coal pillars for multi-seam mining in similar mines.

Monitoring and evaluation of disaster risk caused by linkage failure and instability of residual coal pillar and rock strata in multi-coal seam mining

Comprehensive research methods such as literature research,theoretical analysis,numerical simulations and field monitoring have been used to analyze the disasters and characteristics caused by the linkage failure and instability of the residual coal pillars-rock strata in multi-seam mining.The effective monitoring area and monitoring design method of linkage instability of residual coal pillar-rock strata in multi-seam mining have been identified.The evaluation index and the risk assessment method of disaster risk have been established and the project cases have been applied and validated.The results show that:①The coal pillar will not only cause disaster in singleseam mining,but also more easily cause disaster in multi-seam mining.The instability of coal pillars can cause not only dynamical disasters such as rock falls and mine earthquakes,but also cause surface subsidence and other disasters.②When monitoring the linkage instability of residual coal pillar-rock strata,it is not only necessary to consider the monitoring of the apply load body(key block),the transition body(residual coal pillar)and the carrier body(interlayer rock and working face),but also to strengthen the monitoring of the fracture development height(linkage body).③According to the principles of objectivity,easy access and quantification,combined with investigation,analysis,and production and geological characteristics of this mining area,the main evaluation indexes of the degree of disaster caused by linkage instability of residual coal pillar-rock strata are determined as:microseismic energy,residual coal pillar damage degree,fracture development height.And the evaluation index classification table was also given.④According to the measured value of the evaluation index,the fuzzy comprehensive evaluation method was used to calculate the disaster risk degree in the studied mine belongs to class III,that is,medium risk level.The corresponding pressure relief technology was adopted on site,which achieved a good control effect,and also verified the accuracy and effectiveness of the risk evaluation results.