An experiment of impact between 450 m/s water jets and polymethylme- thacrylate (PMMA) materials with complex surface geometry was conducted. The testing surfaces were a corner, step change, surface-breaking notch, in...An experiment of impact between 450 m/s water jets and polymethylme- thacrylate (PMMA) materials with complex surface geometry was conducted. The testing surfaces were a corner, step change, surface-breaking notch, inclined surface, etc. Stress waves propagation in the solid such as reflection, interference and diffraction was observed using polarized optics and an Imacon high speed camera (operating at both of 106 and 5×105 framing rates per second, fps). A damage test by the impact of the side jetting of an 850 m/s water jet was also carried out. It was found that stress waves propagation in solids depends not only on the surface geometry but also on the contact situation between liquid and solid. It was shown that the side jetting has sufficient damage potential although its head may consist of finer droplets. The results of this paper are useful to further analyze the dynamic stress state of solids under high-speed liquid impact.展开更多
This article reports an experimental investigation on the axial impact buckling of thin metallic cylindrical shells fully filled with water. Low velocity impact tests are carried out by DHR-9401 drop hammer rig. The w...This article reports an experimental investigation on the axial impact buckling of thin metallic cylindrical shells fully filled with water. Low velocity impact tests are carried out by DHR-9401 drop hammer rig. The whole process of dynamic buckling is simulated using LS-DYNA computer code. The consistency between experimental observation and numerical simulation is quite satisfactory. The investigation indicates that quite high internal hydrodynamic pressure occurs inside the shell during the impact process. Under the combined action of the high internal pressure and axial compression plastic buckling occurs easily in the thin-walled shells and buckling modes take on regular and axisymmetric wrinkles.展开更多
In order to investigate the material corrosion by liquid droplet solid impact, a nonlinear coupling wave model adopted to analyze the impact between the spherical liquid droplet and an elastic solid plane has been dev...In order to investigate the material corrosion by liquid droplet solid impact, a nonlinear coupling wave model adopted to analyze the impact between the spherical liquid droplet and an elastic solid plane has been developed. Many usable results such as the dimensionless pressure in the contact plane of liquid solid and inside the liquid droplet, the equivalent stress distribution inside the solid, the effect of solid elasticity on the impact, and the locations of the maximum equivalent stress in different...展开更多
To address the high rock strength and low drilling rate issues in deep oil/gas and geothermal exploitation, we performed mechanical property tests on three kinds of rock samples(granite, shale and sandstone) subjected...To address the high rock strength and low drilling rate issues in deep oil/gas and geothermal exploitation, we performed mechanical property tests on three kinds of rock samples(granite, shale and sandstone) subjected to liquid nitrogen(LN2) cooling and conducted rock-breaking experiments using LN2 jet. Rock-breaking characteristics and mechanisms of LN2 jet, heat transfer features between LN2 and rock and thermal stress evolution in rock were analyzed. A novel high-pressure LN2 jet assisted drilling method was proposed accordingly. The study results show that LN2 thermal shock can significantly reduce uniaxial compression strength and elastic modulus of rock. Rock damage and corresponding mechanical deterioration become more pronounced with increasing rock temperature. The LN2 jet has merits of high rock-breaking efficiency and low threshold rock-breaking pressure. Rock failure under LN2 jet impact is characterized by large volume breakage and the rock-breaking performance becomes more significant with increase of rock temperature. Under the impact of LN2 jet, the damage of granite is the most remarkable among the three rock samples. Thus, this method works better for high temperature granite formations. It has a good application prospect in speeding up drilling rate in deep hot dry rock geothermal reservoirs.展开更多
These experimental investigations are designed to study shock wave characteristics and spray structure. Supersonic liq- uid jets injected into ambient fields are empirically studied using projectile impacts in a two-s...These experimental investigations are designed to study shock wave characteristics and spray structure. Supersonic liq- uid jets injected into ambient fields are empirically studied using projectile impacts in a two-stage light gas gun. This study looks primarily at the design of the nozzle assembly, the tip velocity of the high speed jet, the structure of the spray jet and the shock wave generation process. The supersonic liquid jets were visualized using an ultra high-speed camera and the schlieren system for visualization to quantitatively analyze the shock wave angle. The experimental re- sults with straight cone nozzle types and various non-Newtonian fluid viscosities are presented in this paper. The effects of nozzle geometry on the jet behavior are described. The characteristics of the shock wave generation and spray jet structure were found to be significantly related to the nozzle geometry. The expansion gases accelerated the projectile, which had a mass of 6 grams, from 250 m/s. As a result, it was found that the maximum jet velocity appeared in the liquid jet with high viscosity properties. Supersonic liquid jets, which occurred at the leading edge the shock waves and the compression waves in front of the jets, were observed. Also, the shock waves significantly affected the atomization process for each spray droplet.展开更多
采用CLSVOF(coupled level set and volume of fluid)方法对单液滴撞击平面液膜初期的飞溅过程进行了数值模拟,探讨了撞击速度和液膜厚度对撞击后形成冠状水花形态及扩展直径的影响。结果显示,扩展直径随撞击速度的增大而增大,随液膜厚...采用CLSVOF(coupled level set and volume of fluid)方法对单液滴撞击平面液膜初期的飞溅过程进行了数值模拟,探讨了撞击速度和液膜厚度对撞击后形成冠状水花形态及扩展直径的影响。结果显示,扩展直径随撞击速度的增大而增大,随液膜厚度的增大而减小,CLSVOF方法可较好地用于液滴撞击过程的数值计算。展开更多
应用VOF(volume of fluid)方法对液滴撞击球面液膜的飞溅过程进行数值模拟,由计算结果分析了不同液滴撞击速度和液膜厚度对撞击产生的水花形态、高度和直径的影响。结果表明:随着液滴撞击速度和液膜厚度的增加,水花高度增大;随着液滴撞...应用VOF(volume of fluid)方法对液滴撞击球面液膜的飞溅过程进行数值模拟,由计算结果分析了不同液滴撞击速度和液膜厚度对撞击产生的水花形态、高度和直径的影响。结果表明:随着液滴撞击速度和液膜厚度的增加,水花高度增大;随着液滴撞击速度增加,水花直径增大,但当液膜厚度增加时,水花直径减小。展开更多
文摘An experiment of impact between 450 m/s water jets and polymethylme- thacrylate (PMMA) materials with complex surface geometry was conducted. The testing surfaces were a corner, step change, surface-breaking notch, inclined surface, etc. Stress waves propagation in the solid such as reflection, interference and diffraction was observed using polarized optics and an Imacon high speed camera (operating at both of 106 and 5×105 framing rates per second, fps). A damage test by the impact of the side jetting of an 850 m/s water jet was also carried out. It was found that stress waves propagation in solids depends not only on the surface geometry but also on the contact situation between liquid and solid. It was shown that the side jetting has sufficient damage potential although its head may consist of finer droplets. The results of this paper are useful to further analyze the dynamic stress state of solids under high-speed liquid impact.
基金the National Natural Science Foundation of China(19672039)the Shanxi Foundation for Returned Scholars from Abroad
文摘This article reports an experimental investigation on the axial impact buckling of thin metallic cylindrical shells fully filled with water. Low velocity impact tests are carried out by DHR-9401 drop hammer rig. The whole process of dynamic buckling is simulated using LS-DYNA computer code. The consistency between experimental observation and numerical simulation is quite satisfactory. The investigation indicates that quite high internal hydrodynamic pressure occurs inside the shell during the impact process. Under the combined action of the high internal pressure and axial compression plastic buckling occurs easily in the thin-walled shells and buckling modes take on regular and axisymmetric wrinkles.
基金Natural Science Foundation of Xi'an Jiaotong University (5 73 0 2 7)
文摘In order to investigate the material corrosion by liquid droplet solid impact, a nonlinear coupling wave model adopted to analyze the impact between the spherical liquid droplet and an elastic solid plane has been developed. Many usable results such as the dimensionless pressure in the contact plane of liquid solid and inside the liquid droplet, the equivalent stress distribution inside the solid, the effect of solid elasticity on the impact, and the locations of the maximum equivalent stress in different...
基金Supported by National Science Fund for Distinguished Young Scholars(NO.51725404)Program of Introducing Talents of Discipline to Chinese Universities(NO.B17045)National Natural Science Foundation of China(NO.51521063)
文摘To address the high rock strength and low drilling rate issues in deep oil/gas and geothermal exploitation, we performed mechanical property tests on three kinds of rock samples(granite, shale and sandstone) subjected to liquid nitrogen(LN2) cooling and conducted rock-breaking experiments using LN2 jet. Rock-breaking characteristics and mechanisms of LN2 jet, heat transfer features between LN2 and rock and thermal stress evolution in rock were analyzed. A novel high-pressure LN2 jet assisted drilling method was proposed accordingly. The study results show that LN2 thermal shock can significantly reduce uniaxial compression strength and elastic modulus of rock. Rock damage and corresponding mechanical deterioration become more pronounced with increasing rock temperature. The LN2 jet has merits of high rock-breaking efficiency and low threshold rock-breaking pressure. Rock failure under LN2 jet impact is characterized by large volume breakage and the rock-breaking performance becomes more significant with increase of rock temperature. Under the impact of LN2 jet, the damage of granite is the most remarkable among the three rock samples. Thus, this method works better for high temperature granite formations. It has a good application prospect in speeding up drilling rate in deep hot dry rock geothermal reservoirs.
文摘These experimental investigations are designed to study shock wave characteristics and spray structure. Supersonic liq- uid jets injected into ambient fields are empirically studied using projectile impacts in a two-stage light gas gun. This study looks primarily at the design of the nozzle assembly, the tip velocity of the high speed jet, the structure of the spray jet and the shock wave generation process. The supersonic liquid jets were visualized using an ultra high-speed camera and the schlieren system for visualization to quantitatively analyze the shock wave angle. The experimental re- sults with straight cone nozzle types and various non-Newtonian fluid viscosities are presented in this paper. The effects of nozzle geometry on the jet behavior are described. The characteristics of the shock wave generation and spray jet structure were found to be significantly related to the nozzle geometry. The expansion gases accelerated the projectile, which had a mass of 6 grams, from 250 m/s. As a result, it was found that the maximum jet velocity appeared in the liquid jet with high viscosity properties. Supersonic liquid jets, which occurred at the leading edge the shock waves and the compression waves in front of the jets, were observed. Also, the shock waves significantly affected the atomization process for each spray droplet.
文摘采用CLSVOF(coupled level set and volume of fluid)方法对单液滴撞击平面液膜初期的飞溅过程进行了数值模拟,探讨了撞击速度和液膜厚度对撞击后形成冠状水花形态及扩展直径的影响。结果显示,扩展直径随撞击速度的增大而增大,随液膜厚度的增大而减小,CLSVOF方法可较好地用于液滴撞击过程的数值计算。
文摘应用VOF(volume of fluid)方法对液滴撞击球面液膜的飞溅过程进行数值模拟,由计算结果分析了不同液滴撞击速度和液膜厚度对撞击产生的水花形态、高度和直径的影响。结果表明:随着液滴撞击速度和液膜厚度的增加,水花高度增大;随着液滴撞击速度增加,水花直径增大,但当液膜厚度增加时,水花直径减小。
