Estimation of tungsten production from the upper divertor in EAST during edge localized modes

During edge localized modes(ELMs), the sheath evolution in front of the Experimental Advanced Superconducting Tokamak(EAST) upper divertor is studied to estimate the sputtered tungsten(W) atoms from the divertor target. A large potential drop across the sheath is formed during ELMs by compared with inter-ELMs, and the maximum of sheath potential drop can exceed one thousand of e V in current EAST operation. Due to the enhancement of the sheath potential drop during ELMs, the W physical sputtering yield from the deuterium(D) ions and the impurity ions on the upper divertor target is found to be significant. It is established that the sputtered W yield during ELMs is at least higher by an order of magnitude than inter-ELMs, and D ions and carbon(C) ions are the main ions governing the W production for the current H-mode with ELMs discharges. With increase in the pedestal electron temperature, the maximum of the D and C ion impact energy during ELMs shows a nearly linear increase, and the D ions have sufficient impact energy to cause the strong W physical sputtering. As a consequence, the D ions may dominate the sputtered W flux from the divertor target when the C concentration is controlled less than one percent for the higher heating power H-mode with ELM discharges in near future.

Extended x-ray absorption fine structure study of MnFeP_(0.56)Si_(0.44) compound

The Mn Fe P0.56Si0.44 compound is investigated by x-ray diffraction, magnetic measurements, and x-ray absorption fine structure spectroscopy. It crystallizes in Fe2P-type structure with the lattice parameters a = b = 5.9823(0) and c = 3.4551(1) and undergoes a first-order phase transition at the Curie temperature of 255 K. The Fe K edge and Mn K edge x-ray absorption fine structure spectra show that Mn atoms mainly reside at 3g sites, while 3f sites are occupied by Fe atoms. The distances between the absorbing Fe atom and the first and second nearest neighbor Fe atoms in a 3f-layer shift from 2.65 and 4.01 in the ferromagnetic state to 2.61 and 3.96 in the paramagnetic phase. On the other hand, the distance between the 3g-layer and 3f-layer changes a little as 2.66 –2.73 below the Curie temperature and2.68 –2.75 above it.

Observation of chaotic ELMs in HL-2A tokamak

The high confinement mode （H-mode） operation is recently obtained in HL-2A divertor configuration, the corresponding edge localized mode （ELM） is recognized as being of type III. Time intervals in ELM time series are analysed to obtain the information about the ELM process. Signatures of unstable periodic orbits （UPOs） are detected, which are indicators of chaos and may be used to control the big ELM events.

Morphological and structural damage investigation of nanostructured molybdenum fuzzy surface after pulsed plasma bombardment

Steady high-flux helium(He)plasma with energy ranging from 50 eV to 90 eV is used to fabricate a fiber-form nanostructure called fuzz on a polycrystalline molybdenum(Mo)surface.Enhanced hydrogen(H)pulsed plasma in a wide power density range of 12 MW/m^(2)-35 MW/m^(2)is subsequently used to bombard the fuzzy Mo,thereby simulating the damage of edge localized mode(ELM)to fuzz.The comparisons of surface morphologies,crystalline structures,and optical reflectivity between the original Mo and the Mo treated with various He^(+)energy and transient power densities are performed.With the increase of He ion energy,the Mo nano-fuzz evolved density is enlarged due to the decrease of filament diameter and optical reflectivity.The fuzz-enhanced He release should be the consequence of crystalline growth and the lattice shrinkage inside the Mo-irradiated layers(^(2)00 nm).The fuzz induced by lower energy experiences more severe melting damage and dust release under the condition of the identical transient H plasma-bombardment.The H and He are less likely to be trapped due to aggravated melting evidenced by the enhanced crystalline size and distinct lattice shrinkage.As the transient power density rises,the thermal effect is enhanced,thereby causing the fuzz melting loss to aggravate and finally to completely disappear when the power density exceeds 21 MW/m^(2).Irreversible grain expansion results in huge tensile stress,leading to the observable brittle cracking.The effects of transient thermal load and He ion energy play a crucial role in etching Mo fuzz during ELM transient events.

Investigation of lower hybrid current drive during H-mode in EAST tokamak

H-mode discharges with lower hybrid current drive （LHCD） alone are achieved in EAST divertor plasma over a wide parameter range. These H-mode discharges are characterized by a sudden drop in Da emission and a spontaneous rise in main plasma density. Good lower hybrid （LH） coupling during H-mode is obtained by putting the plasma close to the antenna and by injecting D2 gas from a pipe near the grill mouse. The analysis of lower hybrid current drive properties shows that the LH deposition profile shifts off axis during H-mode, and current drive （CD） efficiency decreases due to the increase in density. Modeling results of H-mode discharges with a general ray trueing code GENRAY are reported.

Properties of plasma radiation during discharges with improved confinement on HL-2A Tokamak

In the recent experiment on the HL-2A tokamak, two types of improved confinement regimes have been achieved in different configurations. One is the improved confinement regime in limiter configuration during electron cyclotron resonant heating （ECRH）, characterized by a sharp decrease in Hα emission accompanied by an increase in the total radiation of plasma, the line averaged electron density and the stored energy of plasma. The other is high confinement regime （H-mode） in divertor configuration during a combination of ECRH and Neutral beam injection （NBI） heating, characterized with edge localized modes （ELMs） besides the features mentioned above. The ELMs are found to be localized on the plasma edge （r/a ≥ 0.8）, causing average losses of particles and stored energy in the ranges of about 1 3% and 3-5% respectively during a single ELM event. So far, the ELMs observed in the HL-2A are type Ⅲ ELMs with low amplitude and high repetition frequency in a range from 200 Hz to 350 Hz. An investigation of the radiated power density profiles shows that radiative cooling effect plays a significant role in the transition back to the L-mode and the triggering of ELM events.

Uncertainties of clock and shift operators for an electron in one-dimensional nonuniform lattice systems

The clock operator U and shift operator V are higher-dimensional Pauli operators. Just recently, tighter uncertainty relations with respect to U and V were derived, and we apply them to study the electron localization properties in several typical one-dimensional nonuniform lattice systems. We find that uncertainties △U^2 are less than, equal to, and greater than uncertainties △V^2 for extended, critical, and localized states, respectively. The lower bound LB of the uncertainty relation is relatively large for extended states and small for localized states. Therefore, in combination with traditional quantities,for instance inverse participation ratio, these quantities can be as novel indexes to reflect Anderson localization.

SAMPLING PRINCIPLE AND TECHNOLOGY IN WAVELET ANALYSIS FOR SIGNALS

Sampling principle and characteristics and edge effect of orthogonal wavelet transform of signals are researched. Two samples of signals and wavelet bases must be taken in wavelet transform. In the second sample sampling interval or sampling length in different frequency range will be automatically adjusted. Wavelet transform can detect singular points. Both ends of signals are singular points. Edge effect is not avoidable.

Bayesian edge detector for SAR imagery using discontinuity-adaptive Markov random feld modeling

Synthetic aperture radar（SAR）image is severely affected by multiplicative speckle noise,which greatly complicates the edge detection.In this paper,by incorporating the discontinuityadaptive Markov random feld（DAMRF）and maximum a posteriori（MAP）estimation criterion into edge detection,a Bayesian edge detector for SAR imagery is accordingly developed.In the proposed detector,the DAMRF is used as the a priori distribution of the local mean reflectivity,and a maximum a posteriori estimation of it is thus obtained by maximizing the posteriori energy using gradient-descent method.Four normalized ratios constructed in different directions are computed,based on which two edge strength maps（ESMs）are formed.The fnal edge detection result is achieved by fusing the results of two thresholded ESMs.The experimental results with synthetic and real SAR images show that the proposed detector could effciently detect edges in SAR images,and achieve better performance than two popular detectors in terms of Pratt＇s fgure of merit and visual evaluation in most cases.

Effect of vegetated-banks on local scour around a wing-wall abutment with circular edges

Failure of bridges due to local scour in the vicinity of bridge abutments is a common occurrence. In this study, experiments under two different channel conditions were conducted to assess the impacts of vegetation on channel banks on local scour around a wing-wall abutment with circular edges. Some experiments were conducted in channel with vegetation on channel banks, and other experiments in channel without vegetation on channel bank. The flow velocity and Reynolds stress distributions in scour holes around a wing-wall abutment with circular edges were compared under these 2 different channel conditions. Results reveal that the vegetated-banks can reduce the time for achieving the equilibrium condition from 17 h to 9 h. Also, vegetated-bank channels can result in a significant decrease in the maximum scour depth from 0.084 m（for bare channel bank） to 0.00032 m. Additionally, around the abutment, vegetated-banks play a significant role in diminishing the Reynolds stress（RS） near the bed and removing negative values in RS distribution by weakening unfavorable pressure gradient and down-flow in the upstream of abutment.

Edge localized modes suppression via edge E × B velocity shear induced by RF sheath of ion cyclotron resonance heating in EAST

The control of large edge localized modes(ELMs) is a critical issue for the successful operation of future burning plasma devices,such as the international thermonuclear experimental reactor(ITER) and China fusion engineering test reactor(CFETR). In this paper, we present a new active and effective means of ELM suppression using ion cyclotron resonant heating(ICRH) on the experimental advanced superconducting tokamak(EAST). We obtained the key role of the external E × B velocity shear near the pedestal top and the scrape-off-layer(SOL) induced by the RF sheath potential of ICRH in ELM suppression. The experimental results showed a positive correlation between the RF sheath and the E × B shear rate in SOL. BOUT++ simulations indicate that increased E × B velocity shear rates in the pedestal and SOL regions promote ELM suppression;thereby, supporting the experimental observations on EAST. These findings suggest a new simple approach to access the ELM suppressed regimes in plasma with low torque input as ITER baseline discharges.

Improved Bounds on the Generalized Acyclic Chromatic Number

An r-acyclic edge chromatic number of a graph G,denoted by α＇r（G）,is the minimum number of colors used to produce an edge coloring of the graph such that adjacent edges receive different colors and every cycle C has at least min {｜C｜,r} colors.We prove that α＇r（G） ≤（4r ＋ 1）△（G）,when the girth of the graph G equals to max{50,△A（G）} and 4 ≤ r ≤ 7.If we relax the restriction of the girth to max {220,A（G）},the upper bound of a＇r（G） is not larger than（2r ＋ 5）△（G） with 4 ≤r≤ 10.