This paper presents the model of one-tire kinetics、tires、the braking system and the model of control system.On virtual road,this paper builds a fuzzy predictive control system to insure the best attachment coefficie...This paper presents the model of one-tire kinetics、tires、the braking system and the model of control system.On virtual road,this paper builds a fuzzy predictive control system to insure the best attachment coefficient between tires and road. And it turns out to be that this fuzzy predictive control method has achieved good performances.展开更多
In this paper the authors present an analysis and the implementation of microprocessor-baseddigital phase-locked loop speed control system for an induction motor which is actuated by aSPWM-GTR inverter.The system is c...In this paper the authors present an analysis and the implementation of microprocessor-baseddigital phase-locked loop speed control system for an induction motor which is actuated by aSPWM-GTR inverter.The system is controlled by a 16-bit single chip microprocessor.A new type of frequency and phase detector is presented in detail,An adaptive method isadopted in speed controller.A three mode control scheme is used.These techniques are very use-ful to the improvement of the dynamic behavior of digital AC motor drive system.Experimental results show that the system is of good stability,high precision and good dynam-ic performance.展开更多
Nowadays validation of anti-lock braking systems（ABS） relies mainly on a large amount of road tests.An alternative means with higher efficiency is employing the hardware-in-the-loop simulation（HILS） system to subs...Nowadays validation of anti-lock braking systems（ABS） relies mainly on a large amount of road tests.An alternative means with higher efficiency is employing the hardware-in-the-loop simulation（HILS） system to substitute part of road tests for designing,testing,and tuning electronic control units（ECUs） of ABS.Most HILS systems for ABS use expensive digital signal processor hardware and special purpose software,and some fail-safe functions with regard to wheel speeds cannot be evaluated since artificial wheel speed signals are usually provided.In this paper,a low-cost ABS HILS test bench is developed and used for validating the anti-lock braking performance and tuning control parameters of ABS controllers.Another important merit of the proposed test bench is that it can comprehensively evaluate the fail-safe functions with regard to wheel speed signals since real tone rings and sensors are integrated in the bench.A 5-DOF vehicle model with consideration of longitudinal load transfer is used to calculate tire forces,wheel speeds and vehicle speed.Each of the four real-time wheel speed signal generators consists of a servo motor plus a ring gear,which has sufficient dynamic response ability to emulate the rapid changes of the wheel speeds under strict braking conditions of very slippery roads.The simulation of braking tests under different road adhesion coefficients using the HILS test bench is run,and results show that it can evaluate the anti-lock braking performance of ABS and partly the fail-safe functions.This HILS system can also be used in such applications as durability test,benchmarking and comparison between different ECUs.The test bench developed not only has a relatively low cost,but also can be used to validate the wheel speed-related ECU design and all its fail-safe functions,and a rapid testing and proving platform with a high efficiency for research and development of the automotive ABS is therefore provided.展开更多
Concurrency control is a critical technology and one of the problems in CSCW systems. With the development of agent based technology, it has also been applied to research and development of CSCW systems. An Agent ba...Concurrency control is a critical technology and one of the problems in CSCW systems. With the development of agent based technology, it has also been applied to research and development of CSCW systems. An Agent based method for concurrency control in CSCW is explored in this paper. This new way is achieved by making use of the thoughts of AOP (Agent Oriented Programming) to improve traditional locking method, on the basis of researching characteristics and functional requirements of concurrency control in CSCW, and analyzing various usually used concurrency control methods. All amendments to locking method are done on the basis of the analysis of limitations brought by locking. In this paper, a new algorithm supporting queue of locking request for Agent based concurrency control is also presented. All above aspects are discussed in some detail in this paper.展开更多
文摘This paper presents the model of one-tire kinetics、tires、the braking system and the model of control system.On virtual road,this paper builds a fuzzy predictive control system to insure the best attachment coefficient between tires and road. And it turns out to be that this fuzzy predictive control method has achieved good performances.
文摘In this paper the authors present an analysis and the implementation of microprocessor-baseddigital phase-locked loop speed control system for an induction motor which is actuated by aSPWM-GTR inverter.The system is controlled by a 16-bit single chip microprocessor.A new type of frequency and phase detector is presented in detail,An adaptive method isadopted in speed controller.A three mode control scheme is used.These techniques are very use-ful to the improvement of the dynamic behavior of digital AC motor drive system.Experimental results show that the system is of good stability,high precision and good dynam-ic performance.
基金supported by National Natural Science Foundation of China(Grant No.50908008)National Hi-tech Research and Development Program of China(863Program,Grant No.2009AA11Z216)
文摘Nowadays validation of anti-lock braking systems（ABS） relies mainly on a large amount of road tests.An alternative means with higher efficiency is employing the hardware-in-the-loop simulation（HILS） system to substitute part of road tests for designing,testing,and tuning electronic control units（ECUs） of ABS.Most HILS systems for ABS use expensive digital signal processor hardware and special purpose software,and some fail-safe functions with regard to wheel speeds cannot be evaluated since artificial wheel speed signals are usually provided.In this paper,a low-cost ABS HILS test bench is developed and used for validating the anti-lock braking performance and tuning control parameters of ABS controllers.Another important merit of the proposed test bench is that it can comprehensively evaluate the fail-safe functions with regard to wheel speed signals since real tone rings and sensors are integrated in the bench.A 5-DOF vehicle model with consideration of longitudinal load transfer is used to calculate tire forces,wheel speeds and vehicle speed.Each of the four real-time wheel speed signal generators consists of a servo motor plus a ring gear,which has sufficient dynamic response ability to emulate the rapid changes of the wheel speeds under strict braking conditions of very slippery roads.The simulation of braking tests under different road adhesion coefficients using the HILS test bench is run,and results show that it can evaluate the anti-lock braking performance of ABS and partly the fail-safe functions.This HILS system can also be used in such applications as durability test,benchmarking and comparison between different ECUs.The test bench developed not only has a relatively low cost,but also can be used to validate the wheel speed-related ECU design and all its fail-safe functions,and a rapid testing and proving platform with a high efficiency for research and development of the automotive ABS is therefore provided.
文摘Concurrency control is a critical technology and one of the problems in CSCW systems. With the development of agent based technology, it has also been applied to research and development of CSCW systems. An Agent based method for concurrency control in CSCW is explored in this paper. This new way is achieved by making use of the thoughts of AOP (Agent Oriented Programming) to improve traditional locking method, on the basis of researching characteristics and functional requirements of concurrency control in CSCW, and analyzing various usually used concurrency control methods. All amendments to locking method are done on the basis of the analysis of limitations brought by locking. In this paper, a new algorithm supporting queue of locking request for Agent based concurrency control is also presented. All above aspects are discussed in some detail in this paper.
