A Photolithography Process Design for 5 nm Logic Process Flow

With the introduction of EUV lithography,the photolithographic process in 5 nm logic process can be simplified to use mostly single exposure method.In a typical 5 nm logic process,the contact-poly pitch(CPP)is 44-50 nm,the minimum metal pitch(MPP)is around 30-32 nm.And the overlay budget is estimated to be 2.5 nm(on product overlay).Although the optical resolution of a 0.33NA exposure tool(such as ASML NXE3400)can reach below 32 nm pitch,stochastics in the EUV absorption in photoresists has limited its application to smaller pitches.For the CPP mentioned above,one can use 193 nm immersion lithography with Self-Aligned Double Patterning(SADP)technique to provide good image contrast(or CDU,LWR)as well as good overlay,as for the 10 and 7 nm generations.In the BEOL,however,the 30-32 pitch cannot be realized by a single EUV exposure with enough printing defect process window.If this pitch is to be done by 193 nm immersion lithography,more than 6-8 exposures are needed with very complicated overlay result.For EUV,this can be done through self-aligned LELE with both good CD and overlay control.We have done an optimization of the photolithographic process parameters for the typical metal with a self-developed aerial image simulator based on rigorous coupled wave analysis(RCWA)algorithm and the Abbe imaging routine with an EUV absorption model which describes stochastics.We have calibrated our model with wafer exposure data from several photoresists under collaboration with IMEC.As we have presented last year,to accommodate all pitches under a logic design rule,as well as to provide enough CDU for the logic device performance,in DUV lithography,a typical minimum exposure latitude(EL)for the poly and metal layers can be set at,respectively,18%and 13%.In EUV,due to the existence of stochastics,13%EL,which corresponds to an imaging contrast of 40%,seems not enough for the metal trenches,and to obtain an imaging contrast close to 100%,which yields an EL of 31.4%means that we need to relax minimum pitch to above 41 nm(conventional imaging limit for 0.33NA).This is the best imaging contrast a photolithographic process can provide to reduce LWR and stochastics.In EUV,due to the significantly smaller numerical apertures compared to DUV,the aberration impact can cause much more pronounced image registration error,in order to satisfy 2.5 nm total overlay,the aberration induced shift needs to be kept under 0.2 nm.We have also studied shadowing effect and mask 3D scattering effect and our results will be provided for discussion.

PRODUCT MODELING AND PROCESS PLANNING WITHIN CONCURRENT ENGINEERING ENVIRONMENT

A prodouct modeling and a process planning that are two essential basses of realizing concurrent engineering are investigated , a logical modeling technique , grammar representation scheme of technology knowledge and architecture of expert system for process planning within con- current engineering environment are proposed. They have been utilized in a real reaserch project.

Practical Issues Concerning Moment Invariants

In this report several practical issues about moment invariants with application to image classification are concerned. A modified formulation for the approximation of the moments of digital images is suggested. Four computational procedures and their corresponding noise performances are studied in detail.