Magnesium based alloys with aluminum and zinc were obtained through electrochemical co-deposition from LiCl-NaCl-MgCl2 melt. The possibility of electrochemical co-deposition was discussed in detail by electro-analytic...Magnesium based alloys with aluminum and zinc were obtained through electrochemical co-deposition from LiCl-NaCl-MgCl2 melt. The possibility of electrochemical co-deposition was discussed in detail by electro-analytical methods including cyclic voltametry,square wave voltametry,and chronopotentiometry. The co-deposition happens when the concentration of aluminum and zinc ions is kept at low value and the current density is high enough. The components of alloy elements can be controlled by fixing the components of the feeding salts. A laboratory experiment of the preparation by step-current co-deposition was also performed and certain compositions of the Mg-Al,and Mg-Zn were obtained. The alloys obtained from the co-deposition show a typical as-cast microstructure. The best conditions of electrolysis such as temperature,amount of addition and mode of feeding were discussed in detail.展开更多
We investigate experimentally and analytically the combustion behavior of a high-metal magnesium-based hydro- reactive fuel under high temperature gaseous atmosphere. The fuel studied in this paper contains 73% magnes...We investigate experimentally and analytically the combustion behavior of a high-metal magnesium-based hydro- reactive fuel under high temperature gaseous atmosphere. The fuel studied in this paper contains 73% magnesium powders. An experimental system is designed and experiments are carried out in both argon and water vapor atmo- spheres. It is found that the burning surface temperature of the fuel is higher in water vapor than that in argon and both of them are higher than the melting point of magnesium, which indicates the molten state of magnesium particles in the burning surface of the fuel. Based on physical considerations and experimental results, a mathematical one-dimensional model is formulated to describe the combustion behavior of the high-metal magnesium-based hydro-reactive fuel. The model enables the evaluation of the burning surface temperature, the burning rate and the flame standoff distance each as a function of chamber pressure and water vapor concentration. The results predicted by the model show that the burning rate and the surface temperature increase when the chamber pressure and the water vapor concentration increase, which are in agreement with the observed experimental trends.展开更多
This paper presents the ways of comprehensive utilization of the natural magnesium containing resources and the trends of the MgO based refractories used in high temperature industries. In the first part, the uses and...This paper presents the ways of comprehensive utilization of the natural magnesium containing resources and the trends of the MgO based refractories used in high temperature industries. In the first part, the uses and productions of metal Mg, sorel cement, Mg (OH) 2 fire retardant, light magnesium carbonate, light magnesia and magnesium sulphate are described. In the second part, the developments of MgO based refractories used in steelmaking process, nonferrous metallurgy, cement rotary kiln and waste melting furnace are described from some applied theories, including corrosion resistant and slaking resistant MgO CaO materials, chrome free bricks such as MgO CaO ZrO 2 , MgO MgO Al 2 O 3 , MgO MgO·Al 2 O 3 ZrO 2 , MgO MgO·Al 2 O 3 2MgO ·TiO 2 and MgO FeO·Al 2 O 3 , and MgO containing monolithic refractories etc.展开更多
Limestone in cement could be a source of CO3^2- needed for thaumasite formation which will result in thanmasite form of sulfate attack （TSA） probably. TSA has more deterioration than ettringite or gypsum form of sul...Limestone in cement could be a source of CO3^2- needed for thaumasite formation which will result in thanmasite form of sulfate attack （TSA） probably. TSA has more deterioration than ettringite or gypsum form of sulfate attack because it targets the calcium silicate hydrates （C-S-H） which is the main binder phase in all Portland cement-based materials. By means of physical and mechanical property testing as well as erosion phases analysis, magnesium sulfate attack of cement-based material containing 35% limestone powder by mass at 5 ± 2 ℃ is investigated. The compressive strength and flexural strength of mortar specimen immersed in MgSO4 solution increase firstly, then decrease rapidly with the immersing age. Relative dynamic elastic modulus of mortar specimen changes in a phased process. After immersing in MgSO4 solution for 15 weeks, the main erosion phases in paste specimen change from four phases compounds, three phases compounds to two phases compounds from surface to inside. Deterioration course of limestone cement-based material exposed to magnesium sulfate aggressive environment appears progressive damage layer by layer, and every layer probably suffers four stages, which are property strengthening stage, initial degradation stage, thaumasite formation stage and cementation loss stage, respectively.展开更多
To improve the sliding wear resistance of AZ91D magnesium alloy, Cu-based amorphous composite coatings made of CuaTTi34Zr11Nis and Cu47Ti34Zr11Ni8＋20 wt pct SiC powders were fabricated on AZ91D magnesium alloy by las...To improve the sliding wear resistance of AZ91D magnesium alloy, Cu-based amorphous composite coatings made of CuaTTi34Zr11Nis and Cu47Ti34Zr11Ni8＋20 wt pct SiC powders were fabricated on AZ91D magnesium alloy by laser cladding, respectively. SEM （scanning electron microscopy）, EDS （energy dispersive X-ray spectroscopy）, XRD （X-ray diffraction） and TEM （transmission electron microscopy） techniques were employed to study the phases of the coatings. The results show that the coatings mainly consist of amorphous phase and different intermetallic compounds. The reason of formation of amorphous phase and the function of SiC particles were explained in details.展开更多
镁合金作为最有潜力的轻量化节能材料和储能材料,其研究发展对中国双碳战略意义重大。本文基于文献计量学系统分析了2019~2023年发表的镁及镁合金相关论文(Web of Science核心合集数据库),分析探讨了镁及镁合金领域热点研究方向。分析表...镁合金作为最有潜力的轻量化节能材料和储能材料,其研究发展对中国双碳战略意义重大。本文基于文献计量学系统分析了2019~2023年发表的镁及镁合金相关论文(Web of Science核心合集数据库),分析探讨了镁及镁合金领域热点研究方向。分析表明,在结构镁合金方面,微观组织、力学性能和腐蚀与防护仍是主要研究热点。生物镁材料、镁离子电池和镁基储氢材料正在受到广泛关注。基于目前镁基节能材料和储能材料发展现状,对未来研究重点进行展望。展开更多
With the increased use of renewable energy sources,the need to store large amounts of energy will become increasingly important in the near future.A cost efficient possibility is to use the reaction of recycled Mg was...With the increased use of renewable energy sources,the need to store large amounts of energy will become increasingly important in the near future.A cost efficient possibility is to use the reaction of recycled Mg waste with hydrogen as thermo-chemical energy storage.Owing to the high reaction enthalpy,the moderate pressure and appropriate temperature conditions,the broad abundance and the recyclability,the Mg/Al alloy is perfectly suitable for this purpose.As further development of a previous work,in which the performance of recycled Mg/Al waste was presented,a kinetic model for hydro-and dehydrogenation is derived in this study.Temperature and pressure dependencies are determined,as well as the rate limiting step of the reaction.First experiments are carried out in an autoclave with a scaled-up powder mass,which is also used to validate the model by simulating the geometry with the scaled-up experiments at different conditions.展开更多
基金Project(50374012) supported by the National Natural Science Foundation of China
文摘Magnesium based alloys with aluminum and zinc were obtained through electrochemical co-deposition from LiCl-NaCl-MgCl2 melt. The possibility of electrochemical co-deposition was discussed in detail by electro-analytical methods including cyclic voltametry,square wave voltametry,and chronopotentiometry. The co-deposition happens when the concentration of aluminum and zinc ions is kept at low value and the current density is high enough. The components of alloy elements can be controlled by fixing the components of the feeding salts. A laboratory experiment of the preparation by step-current co-deposition was also performed and certain compositions of the Mg-Al,and Mg-Zn were obtained. The alloys obtained from the co-deposition show a typical as-cast microstructure. The best conditions of electrolysis such as temperature,amount of addition and mode of feeding were discussed in detail.
基金Project supported by the Young Scientist Fund of the National Natural Science Foundation of China(Grant No.51006118)
文摘We investigate experimentally and analytically the combustion behavior of a high-metal magnesium-based hydro- reactive fuel under high temperature gaseous atmosphere. The fuel studied in this paper contains 73% magnesium powders. An experimental system is designed and experiments are carried out in both argon and water vapor atmo- spheres. It is found that the burning surface temperature of the fuel is higher in water vapor than that in argon and both of them are higher than the melting point of magnesium, which indicates the molten state of magnesium particles in the burning surface of the fuel. Based on physical considerations and experimental results, a mathematical one-dimensional model is formulated to describe the combustion behavior of the high-metal magnesium-based hydro-reactive fuel. The model enables the evaluation of the burning surface temperature, the burning rate and the flame standoff distance each as a function of chamber pressure and water vapor concentration. The results predicted by the model show that the burning rate and the surface temperature increase when the chamber pressure and the water vapor concentration increase, which are in agreement with the observed experimental trends.
文摘This paper presents the ways of comprehensive utilization of the natural magnesium containing resources and the trends of the MgO based refractories used in high temperature industries. In the first part, the uses and productions of metal Mg, sorel cement, Mg (OH) 2 fire retardant, light magnesium carbonate, light magnesia and magnesium sulphate are described. In the second part, the developments of MgO based refractories used in steelmaking process, nonferrous metallurgy, cement rotary kiln and waste melting furnace are described from some applied theories, including corrosion resistant and slaking resistant MgO CaO materials, chrome free bricks such as MgO CaO ZrO 2 , MgO MgO Al 2 O 3 , MgO MgO·Al 2 O 3 ZrO 2 , MgO MgO·Al 2 O 3 2MgO ·TiO 2 and MgO FeO·Al 2 O 3 , and MgO containing monolithic refractories etc.
基金Funded by the National Natural Science Foundation of China(No.51109073)
文摘Limestone in cement could be a source of CO3^2- needed for thaumasite formation which will result in thanmasite form of sulfate attack （TSA） probably. TSA has more deterioration than ettringite or gypsum form of sulfate attack because it targets the calcium silicate hydrates （C-S-H） which is the main binder phase in all Portland cement-based materials. By means of physical and mechanical property testing as well as erosion phases analysis, magnesium sulfate attack of cement-based material containing 35% limestone powder by mass at 5 ± 2 ℃ is investigated. The compressive strength and flexural strength of mortar specimen immersed in MgSO4 solution increase firstly, then decrease rapidly with the immersing age. Relative dynamic elastic modulus of mortar specimen changes in a phased process. After immersing in MgSO4 solution for 15 weeks, the main erosion phases in paste specimen change from four phases compounds, three phases compounds to two phases compounds from surface to inside. Deterioration course of limestone cement-based material exposed to magnesium sulfate aggressive environment appears progressive damage layer by layer, and every layer probably suffers four stages, which are property strengthening stage, initial degradation stage, thaumasite formation stage and cementation loss stage, respectively.
基金supported by the Open Fund of the State Key Laboratory of Advanced Welding Production Technology in Harbin Institute of Technology,Chinathe Open Fund of the State Key Laboratory of Materials Processing and Die&Mould Technology in Huazhong University of Science and Technology,China
文摘To improve the sliding wear resistance of AZ91D magnesium alloy, Cu-based amorphous composite coatings made of CuaTTi34Zr11Nis and Cu47Ti34Zr11Ni8＋20 wt pct SiC powders were fabricated on AZ91D magnesium alloy by laser cladding, respectively. SEM （scanning electron microscopy）, EDS （energy dispersive X-ray spectroscopy）, XRD （X-ray diffraction） and TEM （transmission electron microscopy） techniques were employed to study the phases of the coatings. The results show that the coatings mainly consist of amorphous phase and different intermetallic compounds. The reason of formation of amorphous phase and the function of SiC particles were explained in details.
文摘镁合金作为最有潜力的轻量化节能材料和储能材料,其研究发展对中国双碳战略意义重大。本文基于文献计量学系统分析了2019~2023年发表的镁及镁合金相关论文(Web of Science核心合集数据库),分析探讨了镁及镁合金领域热点研究方向。分析表明,在结构镁合金方面,微观组织、力学性能和腐蚀与防护仍是主要研究热点。生物镁材料、镁离子电池和镁基储氢材料正在受到广泛关注。基于目前镁基节能材料和储能材料发展现状,对未来研究重点进行展望。
文摘With the increased use of renewable energy sources,the need to store large amounts of energy will become increasingly important in the near future.A cost efficient possibility is to use the reaction of recycled Mg waste with hydrogen as thermo-chemical energy storage.Owing to the high reaction enthalpy,the moderate pressure and appropriate temperature conditions,the broad abundance and the recyclability,the Mg/Al alloy is perfectly suitable for this purpose.As further development of a previous work,in which the performance of recycled Mg/Al waste was presented,a kinetic model for hydro-and dehydrogenation is derived in this study.Temperature and pressure dependencies are determined,as well as the rate limiting step of the reaction.First experiments are carried out in an autoclave with a scaled-up powder mass,which is also used to validate the model by simulating the geometry with the scaled-up experiments at different conditions.
