High-voltage power supply (HVPS) of Electron Cyclotron Resonance Heating (ECRH) for HT-7 and HT-7U is presently being constructed. The high voltage (100 kV) energy of HVPS is stored in the capacitor banks, and they ca...High-voltage power supply (HVPS) of Electron Cyclotron Resonance Heating (ECRH) for HT-7 and HT-7U is presently being constructed. The high voltage (100 kV) energy of HVPS is stored in the capacitor banks, and they can power one or two gyrotrons. All the operation of the charging system will be done by the control system, where the field signals are interfaced to programmable logic controller (PLC). The use of PLC not only simplifies the control system, but also enhances the reliability. The software written by using configuration software installed in the master computer allows for remote and multiple operator control, and the status and data information is also remotely available.展开更多
Traditional transformer in high-voltage power supplies has many disadvantages such as high turn’s ratio, large volume and great design difficulties. Parallel resonant converters (PRCs) are widely used in high-voltage...Traditional transformer in high-voltage power supplies has many disadvantages such as high turn’s ratio, large volume and great design difficulties. Parallel resonant converters (PRCs) are widely used in high-voltage power supplies. A kind of high-voltage circuit topology can be formed by combining PRCs and voltage-doubler rectifier, which is called parallel resonant dual voltage converters (PRDVCs). In PRDVCs both voltage-doubler rectifier and transformer can boost voltage, which reduced turn’s ratio and volume of the transformer, making it easier to produce. Thus it not only realizes the high-voltage output, but also realizes the miniaturization of high-voltage power supply. Three modes of the converters were researched and simulated. Converting conditions of three modes were given. At last, PRDVCs was used to design a 5000V/50mA high-voltage power supply. The waveforms and results of the experiment were given, which validated the feasibility of the converters and its conversion efficiency might be improved to 93%.展开更多
Purpose Chinese Spallation Neutron Source(CSNS)is one of the key projects of China,in which the main magnet power supplies adopt the structures of resonant networks(Wang et al.in Sci China Phys Mech Astron 54(Suppl 2)...Purpose Chinese Spallation Neutron Source(CSNS)is one of the key projects of China,in which the main magnet power supplies adopt the structures of resonant networks(Wang et al.in Sci China Phys Mech Astron 54(Suppl 2):239-244,2011).Since each network contains a lot of components,and the working state of all the components will affect the whole accelerator,it is necessary to monitor the operation of each part in the resonant network.Methods In this protections system,a supervision to 314 switch signals and 118 analog signals is realized using a chip of field programmable gate array(FPGA).The details about the hardware and software designs are introduced in this paper.Results This protection system has been used in CSNS project,and the result proves that the RCS has been well monitored by this system.Conclusions This system is a self-developed protection system according to the engineering needs of CSNS.It can realize the real-time monitoring and protection of the working state of resonance network by processing a large number of data using FPGA.展开更多
在交-直-交电力机车和交-直电力机车混跑线路的牵引供电系统中,存在丰富的宽频域谐波电流,且易产生车网谐振问题。文章首先采用谐波阻抗分析法建立了牵引网谐波阻抗电路模型,推导了牵引网谐振阻抗与谐波频率及供电臂长度的函数关系,分...在交-直-交电力机车和交-直电力机车混跑线路的牵引供电系统中,存在丰富的宽频域谐波电流,且易产生车网谐振问题。文章首先采用谐波阻抗分析法建立了牵引网谐波阻抗电路模型,推导了牵引网谐振阻抗与谐波频率及供电臂长度的函数关系,分析车网谐振产生机理和谐振特性,给出了车网谐振治理方式及装置安装位置的选择;然后,针对目前牵引网的宽频域谐波,提出一种地面加装有源电力滤波器(active power filter,APF)和无源高通滤波器(high pass filter,HPF)的综合治理方法,并给出“APF+HPF”装置的工程设计方法;最后,结合国内某铁路牵引网案例进行仿真验证。仿真结果显示,采用该方法后谐波电流总畸变率由75.29%下降到1.58%(“APF+二阶HPF”滤波器)和2.55%(“APF+阻波HPF”滤波器),证明该方法对宽频域谐波具有良好的治理效果,能有效抑制车网谐振现象并消除其危害,保障了牵引供电系统的安全运行。展开更多
基金The project supported by the National Meg-science Engineering Project of the Chinese Government
文摘High-voltage power supply (HVPS) of Electron Cyclotron Resonance Heating (ECRH) for HT-7 and HT-7U is presently being constructed. The high voltage (100 kV) energy of HVPS is stored in the capacitor banks, and they can power one or two gyrotrons. All the operation of the charging system will be done by the control system, where the field signals are interfaced to programmable logic controller (PLC). The use of PLC not only simplifies the control system, but also enhances the reliability. The software written by using configuration software installed in the master computer allows for remote and multiple operator control, and the status and data information is also remotely available.
文摘Traditional transformer in high-voltage power supplies has many disadvantages such as high turn’s ratio, large volume and great design difficulties. Parallel resonant converters (PRCs) are widely used in high-voltage power supplies. A kind of high-voltage circuit topology can be formed by combining PRCs and voltage-doubler rectifier, which is called parallel resonant dual voltage converters (PRDVCs). In PRDVCs both voltage-doubler rectifier and transformer can boost voltage, which reduced turn’s ratio and volume of the transformer, making it easier to produce. Thus it not only realizes the high-voltage output, but also realizes the miniaturization of high-voltage power supply. Three modes of the converters were researched and simulated. Converting conditions of three modes were given. At last, PRDVCs was used to design a 5000V/50mA high-voltage power supply. The waveforms and results of the experiment were given, which validated the feasibility of the converters and its conversion efficiency might be improved to 93%.
文摘Purpose Chinese Spallation Neutron Source(CSNS)is one of the key projects of China,in which the main magnet power supplies adopt the structures of resonant networks(Wang et al.in Sci China Phys Mech Astron 54(Suppl 2):239-244,2011).Since each network contains a lot of components,and the working state of all the components will affect the whole accelerator,it is necessary to monitor the operation of each part in the resonant network.Methods In this protections system,a supervision to 314 switch signals and 118 analog signals is realized using a chip of field programmable gate array(FPGA).The details about the hardware and software designs are introduced in this paper.Results This protection system has been used in CSNS project,and the result proves that the RCS has been well monitored by this system.Conclusions This system is a self-developed protection system according to the engineering needs of CSNS.It can realize the real-time monitoring and protection of the working state of resonance network by processing a large number of data using FPGA.
文摘在交-直-交电力机车和交-直电力机车混跑线路的牵引供电系统中,存在丰富的宽频域谐波电流,且易产生车网谐振问题。文章首先采用谐波阻抗分析法建立了牵引网谐波阻抗电路模型,推导了牵引网谐振阻抗与谐波频率及供电臂长度的函数关系,分析车网谐振产生机理和谐振特性,给出了车网谐振治理方式及装置安装位置的选择;然后,针对目前牵引网的宽频域谐波,提出一种地面加装有源电力滤波器(active power filter,APF)和无源高通滤波器(high pass filter,HPF)的综合治理方法,并给出“APF+HPF”装置的工程设计方法;最后,结合国内某铁路牵引网案例进行仿真验证。仿真结果显示,采用该方法后谐波电流总畸变率由75.29%下降到1.58%(“APF+二阶HPF”滤波器)和2.55%(“APF+阻波HPF”滤波器),证明该方法对宽频域谐波具有良好的治理效果,能有效抑制车网谐振现象并消除其危害,保障了牵引供电系统的安全运行。
