In 1989, there were 12 different building ma-terial products winning state awards for theirgood quality, among which two got gold medals andten got silver medals.
The application of mechanical and chemical syntheses in an high-energy vibration mill of the FESTU makes easy the process of the introduction of reinforced powders in castle composite materials on the Al basis. The ob...The application of mechanical and chemical syntheses in an high-energy vibration mill of the FESTU makes easy the process of the introduction of reinforced powders in castle composite materials on the Al basis. The obtained reinforced phases of Al-Ti-C composition have high specific Surface due to peculiarities of explosive mechanical and chemical syntheses. It increases the uniformity of their distribution in a matrix melt during the mixing process and also increases properties of castle composite materials.展开更多
The method "Material Flow Analysis (MFA)" is one of the effective tools to study law and quantification of material flow between economic system and ecological system. On the national level, economy-wide material ...The method "Material Flow Analysis (MFA)" is one of the effective tools to study law and quantification of material flow between economic system and ecological system. On the national level, economy-wide material flow analysis has been published for a number of countries. However, published studies on the regional or local level are still very limited and a standardized method does not exist yet. On the basis of framework of Material Flow Analysis proposed by Eurostat, the paper collected related data and analyzed material input and output for the Chengyang district in Qingdao. The results showed that DMI (Direct Material Input) and TMR (Total Material Requirement) in absolute number increased about 3.6 and 3.9 times, respectively from 1995 to 2004. Fossil fuel and mineral contributed to about 50.3%-76.3% of DMI. Imports of material increased about 5.0 times and became the most important Contributor to DMI, which showed that local economic growth was highly dependent on resources from other regions and countries. DPO (Domestic Processed Output) and TDO (Total Domestic Output) represent slow increasing trend, and DPO contributed to 22.2%-58.1% of TDO, suggesting local hidden flows were of obvious effect on TDO. The biggest component of DPO is CO2, approximately accounting for 90% of DPO. The material productivity increased 57.7% in last decade, reflecting improvement of efficiency of resources utilization in some extent. However, compared to developed countries and regions, material productivity of Chengyang district was relatively low. Therefore, in order to promote the sustainability, it is essential to develop circular economy and enhance materials productivity.展开更多
The issue of art production is an important topic discussed in China’s academia. The article first discusses thetheoretical issues of early art production in China, mainly taking Mr. Dong Xuewen’s views as an exampl...The issue of art production is an important topic discussed in China’s academia. The article first discusses thetheoretical issues of early art production in China, mainly taking Mr. Dong Xuewen’s views as an example. Second,scholars have their own views on the discussion of the unbalanced development of art production and materialproduction in the 1970s and 1980s. Third, this article uses the art production theory to construct the contemporaryliterary art form, and raises the art production theory to the essentialism to discuss the art production theory and thereflection theory. Fourth, the relationship between art production and art consumption is in large-scalecomprehensive systematic research.展开更多
Main performance of the cement grouting materials made up by Portland cement(PC) and sulphoaluminate cement(SAC) was investigated in this program, a kind of expanding agent(EA) which was mainly constituted by me...Main performance of the cement grouting materials made up by Portland cement(PC) and sulphoaluminate cement(SAC) was investigated in this program, a kind of expanding agent(EA) which was mainly constituted by metakaolin and alunite was utilized for the compensation of the shrinkage, the hydration products and micro structure of the grouting materials were researched by X-ray diffraction(XRD) and scanning electron microscopy(SEM). The results showed that a high expansion rate of the grouting materials could be reached as the expanding agent mixed in 6% of PC mass; the addition of SAC in the S2(PC:SAC:EA=34:6:2.25) brought a further improvement of the expansion rate of the grouting materials, the analysis of XRD and SEM showed that due to the reaction of expanding agent and SAC in the grouting materials, more ettringite crystal was generated, which resulted in a higher early strength, the addition of SAC played an expansion and strength reinforcement role in the grouting materials.展开更多
To obtain the compositions and microstructure of hydration products of cementitious material in different hydration ages and its growth law of filling strength, the optimal proportion of composite cementitious materia...To obtain the compositions and microstructure of hydration products of cementitious material in different hydration ages and its growth law of filling strength, the optimal proportion of composite cementitious material was determined according to the chemical composition of cement clinker which was composed of the Portland cement 32.5R, CSA 42.5 sulphoaluminate cement and two gypsum(CS). The characterization of composite cementitious materials in different hydration ages was conducted by NMR, XRD and SEM techniques. The mechanism of hydration was explored. It is shown that the compressive strength of the test block increases gradually with the increase of hydration age. The microstructure of composite cementitious material can be changed from Al-O octahedron into Al-O tetrahedron in the hydration process. The hydrated alkali alumi niumsilicate formed with Si-O tetrahedron and Al-O tetrahedron. The degree of polymerization of Si-O tetrahedron gradually increased, and the structural strength of cementitious materials continued to increase. The diffraction peak of clinker minerals gradually decreased with the extension of hydration age. The CaSO4 completely hydrated to produce Aft during hydration which resulted in high early strength of cementitious material. The early hydration product of composite cementitious materials was Aft with a needle bar structure. The main middle and last hydration products were CSH gel and CH gel with dense prismatic shape. The microscopic pore of composite cementitious material gradually decreased and improved the later strength of filling block. The strong support was provided for mined-out area.展开更多
This paper set up a series of comprehensive targets based on the concept of'anti-freeze filler', which include reasonable water retention rate, frost heave characteristics, and compaction characteristics of filling ...This paper set up a series of comprehensive targets based on the concept of'anti-freeze filler', which include reasonable water retention rate, frost heave characteristics, and compaction characteristics of filling material. Then, a type of permeable graded gravel is proposed, suitable for high-speed railway subgrade. A series of in-door water retention, permeability, and frost heave tests were performed under different graded conditions. Water retention, permeability, and frost heave characteristic of dif- ferent graded filling materials can be determined, in order to define the gradation range of permeable graded gravel. Relying on the frost-heave monitoring record of high speed railway in Northeast China, a series of experimental studies were per- formed, which included on-site filler production, compaction test, and the anti-frost effect test, in order to improve the pro- duction and compaction techniques of permeable graded gravel. From the research of this paper, the use of permeable graded gravel subgrade as the anti-frost structure for the high-speed railway subgrade in cold areas is feasible.展开更多
There is the challenge to use materials in a more sustainable way.Even though cork has an interesting eco-profile as a material,other aspects contributing to an enhanced sustainable use of the resource are discussed:a...There is the challenge to use materials in a more sustainable way.Even though cork has an interesting eco-profile as a material,other aspects contributing to an enhanced sustainable use of the resource are discussed:addressing the life-span of products,materials substitution,and the trend of materials development identified.展开更多
文摘In 1989, there were 12 different building ma-terial products winning state awards for theirgood quality, among which two got gold medals andten got silver medals.
文摘The application of mechanical and chemical syntheses in an high-energy vibration mill of the FESTU makes easy the process of the introduction of reinforced powders in castle composite materials on the Al basis. The obtained reinforced phases of Al-Ti-C composition have high specific Surface due to peculiarities of explosive mechanical and chemical syntheses. It increases the uniformity of their distribution in a matrix melt during the mixing process and also increases properties of castle composite materials.
基金Qingdao Agricultural University Research Fund (630707)
文摘The method "Material Flow Analysis (MFA)" is one of the effective tools to study law and quantification of material flow between economic system and ecological system. On the national level, economy-wide material flow analysis has been published for a number of countries. However, published studies on the regional or local level are still very limited and a standardized method does not exist yet. On the basis of framework of Material Flow Analysis proposed by Eurostat, the paper collected related data and analyzed material input and output for the Chengyang district in Qingdao. The results showed that DMI (Direct Material Input) and TMR (Total Material Requirement) in absolute number increased about 3.6 and 3.9 times, respectively from 1995 to 2004. Fossil fuel and mineral contributed to about 50.3%-76.3% of DMI. Imports of material increased about 5.0 times and became the most important Contributor to DMI, which showed that local economic growth was highly dependent on resources from other regions and countries. DPO (Domestic Processed Output) and TDO (Total Domestic Output) represent slow increasing trend, and DPO contributed to 22.2%-58.1% of TDO, suggesting local hidden flows were of obvious effect on TDO. The biggest component of DPO is CO2, approximately accounting for 90% of DPO. The material productivity increased 57.7% in last decade, reflecting improvement of efficiency of resources utilization in some extent. However, compared to developed countries and regions, material productivity of Chengyang district was relatively low. Therefore, in order to promote the sustainability, it is essential to develop circular economy and enhance materials productivity.
文摘The issue of art production is an important topic discussed in China’s academia. The article first discusses thetheoretical issues of early art production in China, mainly taking Mr. Dong Xuewen’s views as an example. Second,scholars have their own views on the discussion of the unbalanced development of art production and materialproduction in the 1970s and 1980s. Third, this article uses the art production theory to construct the contemporaryliterary art form, and raises the art production theory to the essentialism to discuss the art production theory and thereflection theory. Fourth, the relationship between art production and art consumption is in large-scalecomprehensive systematic research.
基金Funded by the National Key Technology R&D Program in the12th Five Year Plan of China(No.2011BAE14B06)the National High Technology ResearchDevelopment Program of China(No.2015AA034701)
文摘Main performance of the cement grouting materials made up by Portland cement(PC) and sulphoaluminate cement(SAC) was investigated in this program, a kind of expanding agent(EA) which was mainly constituted by metakaolin and alunite was utilized for the compensation of the shrinkage, the hydration products and micro structure of the grouting materials were researched by X-ray diffraction(XRD) and scanning electron microscopy(SEM). The results showed that a high expansion rate of the grouting materials could be reached as the expanding agent mixed in 6% of PC mass; the addition of SAC in the S2(PC:SAC:EA=34:6:2.25) brought a further improvement of the expansion rate of the grouting materials, the analysis of XRD and SEM showed that due to the reaction of expanding agent and SAC in the grouting materials, more ettringite crystal was generated, which resulted in a higher early strength, the addition of SAC played an expansion and strength reinforcement role in the grouting materials.
基金Funded by the National Natural Science Foundation of China(No.51574055)the Natural Science Foundation of Liaoning Province(No.20170540143)
文摘To obtain the compositions and microstructure of hydration products of cementitious material in different hydration ages and its growth law of filling strength, the optimal proportion of composite cementitious material was determined according to the chemical composition of cement clinker which was composed of the Portland cement 32.5R, CSA 42.5 sulphoaluminate cement and two gypsum(CS). The characterization of composite cementitious materials in different hydration ages was conducted by NMR, XRD and SEM techniques. The mechanism of hydration was explored. It is shown that the compressive strength of the test block increases gradually with the increase of hydration age. The microstructure of composite cementitious material can be changed from Al-O octahedron into Al-O tetrahedron in the hydration process. The hydrated alkali alumi niumsilicate formed with Si-O tetrahedron and Al-O tetrahedron. The degree of polymerization of Si-O tetrahedron gradually increased, and the structural strength of cementitious materials continued to increase. The diffraction peak of clinker minerals gradually decreased with the extension of hydration age. The CaSO4 completely hydrated to produce Aft during hydration which resulted in high early strength of cementitious material. The early hydration product of composite cementitious materials was Aft with a needle bar structure. The main middle and last hydration products were CSH gel and CH gel with dense prismatic shape. The microscopic pore of composite cementitious material gradually decreased and improved the later strength of filling block. The strong support was provided for mined-out area.
基金supported by the China Railways Corporation research projects entitled"The technical tests for the high speed railway subgrade frost heave prevention in the alpine"(Project No.Z2013-038)The long term observation of frost-heave technology for Ha-Da high-speed railway during the operation(Project No.Z2012-062)+2 种基金Optimal design for high-speed railway subgrade structure under different grade and environment(Project No.2014G003-A)from the Railway Scientific and Technological Research and Development Center called"The mechanism and evolution rule of the graded gravel under freeze and thawing cycles for the high speed railway"(Project No.J2014G003)The disease control technology and equipment of gradating gravel in surface layer of subgrade bed(Project No.2013YJ032)
文摘This paper set up a series of comprehensive targets based on the concept of'anti-freeze filler', which include reasonable water retention rate, frost heave characteristics, and compaction characteristics of filling material. Then, a type of permeable graded gravel is proposed, suitable for high-speed railway subgrade. A series of in-door water retention, permeability, and frost heave tests were performed under different graded conditions. Water retention, permeability, and frost heave characteristic of dif- ferent graded filling materials can be determined, in order to define the gradation range of permeable graded gravel. Relying on the frost-heave monitoring record of high speed railway in Northeast China, a series of experimental studies were per- formed, which included on-site filler production, compaction test, and the anti-frost effect test, in order to improve the pro- duction and compaction techniques of permeable graded gravel. From the research of this paper, the use of permeable graded gravel subgrade as the anti-frost structure for the high-speed railway subgrade in cold areas is feasible.
基金the Portuguese Foundation for Science and Technology (FCT reference:SFRH/BD/46646/2008)
文摘There is the challenge to use materials in a more sustainable way.Even though cork has an interesting eco-profile as a material,other aspects contributing to an enhanced sustainable use of the resource are discussed:addressing the life-span of products,materials substitution,and the trend of materials development identified.