Using numerical solution of the full Maxwell-Bloch equations, which is obtained by the finite-difference time-domain method and the iterative predictor-orrector method, we investigate the modulation effect of relative...Using numerical solution of the full Maxwell-Bloch equations, which is obtained by the finite-difference time-domain method and the iterative predictor-orrector method, we investigate the modulation effect of relative carrierenvelope phase （hereinafter referred to as the relative phase） on resonant propagation of two-colour femtosecond ultrashort laser pulses in a V-type three-level atomic medium. It is found that the pulse splitting occurs for a smaller value of relative phase; when the value of relative phase increases to a certain value, only the variation of pulse shape is present and the pulse splitting does not occur any more; moreover, when the value of relative phase is smaller, the pulse group velocity is larger. The relative phase also has an obvious effect on population and spectral property. Different population transfers can be realized by adjusting the value of relative phase. Generally speaking, for the pulses with smaller areas their spectral strengths and frequency ranges decrease obviously with the value of relative phase increasing; for the pulses with larger areas, with value of the relative phase increasing, their spectral strengths decrease remarkably but the relative strengths of the higher frequency components increase significantly, while the spectral frequency range is not varied evidently.展开更多
In order to realize further stability of a stack-type thermoelectric power generating module (i.e. no electrical connections inside), flexible materials of metal springs and/or rods having restoring forces were instal...In order to realize further stability of a stack-type thermoelectric power generating module (i.e. no electrical connections inside), flexible materials of metal springs and/or rods having restoring forces were installed between lower-temperature-sides of thermoelectric elements. These flexible materials were expected to play three important roles of interpolating different thermal expansions of the module components, enlarging heat removal area and penetration of any media through themselves. Then, a low-boiling-point medium (i.e. NOVEC manufactured by 3M Japan Ltd.) was also applied for a high-speed direct heat removal via its phase change from the lower-temperature-sides of the thermoelectric elements in the proposing stack-type thermoelectric power generating module. No electrical disconnections inside the module were confirmed for more than 9 years of use, indicating further module stability. The power generating density was improved to about 120 mW·m-2 with SUS304 springs having 0.7 mm diameter. Increasing power generating density can be expected in terms of suitable selection of flexible metal with high Vickers hardness, cavities control on the spring surface, more vigorous multiphase flow with adding powders to the medium and optimization of the module configurations according to numerical simulations.展开更多
In this paper author consider the following problem Let u = u(x.t) be a continuous weak solution of the equation in RN ×(O,T] for some T >O.Then author conclude: corresponding to u there is a unique nonnegativ...In this paper author consider the following problem Let u = u(x.t) be a continuous weak solution of the equation in RN ×(O,T] for some T >O.Then author conclude: corresponding to u there is a unique nonnegative Borel measure v on RN which is the initial trace of u; there is the global inequality of Harnack type for u; the initial trace must belong to a certain growth class; consequently, by combining the results mentioned above a uniqueness conclusion is established.展开更多
Based on 294 earthquake sequences with magnitude greater than or equal to 5.0 occurred in Chinese mainland since 1970, the spatial distribution features of sequence types have been studied. In southwestern China, it t...Based on 294 earthquake sequences with magnitude greater than or equal to 5.0 occurred in Chinese mainland since 1970, the spatial distribution features of sequence types have been studied. In southwestern China, it takes mainshock-aftershock sequence type （MAT） as the major in Chuan-Dian rhombic block and concerned Xianshuihe-Anninghe-Xiaojiang seismic belt, as well as in Jinshajiang-Honghe seismic belt. Multiple mainshock type （MMT） mainly distributes in western Yunnan, and Longlin and Lancang areas in Tengchong-Baoshan block in west of Nujiang-Lancangjiang fault zone. A few isolated earthquake type （IET） mainly occurred in northwestern Sichuan and there is no IET occurred in Yunnan region. In northwestern China, it takes mainshock-aftershock sequence type （MAT） as the major in west segment of South Tianshan in Xinjiang region. Some MMT also occurred in this area in the intersection of Kalpin block and the Puchang fault zone. It takes IET as the major in middle Tianshan in Xinjiang. Along the Qilianshan seismic belt, most of sequences are MAT. In Qinghai region, it takes MAT as the major, but the regional feature of the spatial distribution of sequence types is not very clear. In North China, it takes MAT as the major in Yinshan-Yanshan-Bohai seismic belt, north edge of North China, and in Hebei plain seismic belt, as well as in sub-plate of lower river area of Yangtze River. In intersection of north segment of Shanxi seismic belt and the NW-trending Yinshan-Yanshan-Bohai seismic belt, there are several moderate or strong MMT with magnitude from 5.0 to 6.0 occurred. In south of North China around the latitude line of 35°N, it takes IET as the major. The spatial distribution of sequence types is relevant to the patterns of tectonic movements. MAT is mostly produced by the ruptures of locked units or asperities or the neonatal separating segments inside the fault zones. MMT is generally relevant to the conjugate structures or intersection of many tectonic settings. Further extension of simple fault often produces IET. Spatial distribution of sequence types is also correlative to the regional and deep environment of crustal medium to some extent. MAT mainly distributes in high velocity area in upper crust or in the transition zone between high velocity area and low velocity area, MMT mostly occurred in the low velocity area in upper crust.展开更多
In this paper we consider the following problem ui=△u^m+bi(u^n)x Letu=u(x,t)be a continuous weak solution of the equation in R^N×(0,T)for someT>0.Then we conclude;Corresponding to u there is a unique nonnega...In this paper we consider the following problem ui=△u^m+bi(u^n)x Letu=u(x,t)be a continuous weak solution of the equation in R^N×(0,T)for someT>0.Then we conclude;Corresponding to u there is a unique nonnegative Borel measure v on R^Nwhich is the initial trace of u;there is the global inequality of Harnack type for u;the initial tracev must belong to a certain growth class;consequently,by combining the results mentioned above a u-niqueness conclusion is established.展开更多
基金Project supported by the National Basic Research Program of China (Grant No. 2006CB806000)the National Natural Science Foundation of China (Grant No. 10875072)the Open Fund of the State Key Laboratory of High Field Laser Physics, Shanghai Institute of Optics and Fine Mechanics
文摘Using numerical solution of the full Maxwell-Bloch equations, which is obtained by the finite-difference time-domain method and the iterative predictor-orrector method, we investigate the modulation effect of relative carrierenvelope phase （hereinafter referred to as the relative phase） on resonant propagation of two-colour femtosecond ultrashort laser pulses in a V-type three-level atomic medium. It is found that the pulse splitting occurs for a smaller value of relative phase; when the value of relative phase increases to a certain value, only the variation of pulse shape is present and the pulse splitting does not occur any more; moreover, when the value of relative phase is smaller, the pulse group velocity is larger. The relative phase also has an obvious effect on population and spectral property. Different population transfers can be realized by adjusting the value of relative phase. Generally speaking, for the pulses with smaller areas their spectral strengths and frequency ranges decrease obviously with the value of relative phase increasing; for the pulses with larger areas, with value of the relative phase increasing, their spectral strengths decrease remarkably but the relative strengths of the higher frequency components increase significantly, while the spectral frequency range is not varied evidently.
文摘In order to realize further stability of a stack-type thermoelectric power generating module (i.e. no electrical connections inside), flexible materials of metal springs and/or rods having restoring forces were installed between lower-temperature-sides of thermoelectric elements. These flexible materials were expected to play three important roles of interpolating different thermal expansions of the module components, enlarging heat removal area and penetration of any media through themselves. Then, a low-boiling-point medium (i.e. NOVEC manufactured by 3M Japan Ltd.) was also applied for a high-speed direct heat removal via its phase change from the lower-temperature-sides of the thermoelectric elements in the proposing stack-type thermoelectric power generating module. No electrical disconnections inside the module were confirmed for more than 9 years of use, indicating further module stability. The power generating density was improved to about 120 mW·m-2 with SUS304 springs having 0.7 mm diameter. Increasing power generating density can be expected in terms of suitable selection of flexible metal with high Vickers hardness, cavities control on the spring surface, more vigorous multiphase flow with adding powders to the medium and optimization of the module configurations according to numerical simulations.
文摘In this paper author consider the following problem Let u = u(x.t) be a continuous weak solution of the equation in RN ×(O,T] for some T >O.Then author conclude: corresponding to u there is a unique nonnegative Borel measure v on RN which is the initial trace of u; there is the global inequality of Harnack type for u; the initial trace must belong to a certain growth class; consequently, by combining the results mentioned above a uniqueness conclusion is established.
基金Joint Seismological Science Foundation of China (105076) and continued subject ″Statistic Features of Aftershock Sequences and Forecast of the Large Aftershocks″ (2004BA601B01-04-02), Ministry of Science and Technology of China in the 10th Five-Year Plan.
文摘Based on 294 earthquake sequences with magnitude greater than or equal to 5.0 occurred in Chinese mainland since 1970, the spatial distribution features of sequence types have been studied. In southwestern China, it takes mainshock-aftershock sequence type （MAT） as the major in Chuan-Dian rhombic block and concerned Xianshuihe-Anninghe-Xiaojiang seismic belt, as well as in Jinshajiang-Honghe seismic belt. Multiple mainshock type （MMT） mainly distributes in western Yunnan, and Longlin and Lancang areas in Tengchong-Baoshan block in west of Nujiang-Lancangjiang fault zone. A few isolated earthquake type （IET） mainly occurred in northwestern Sichuan and there is no IET occurred in Yunnan region. In northwestern China, it takes mainshock-aftershock sequence type （MAT） as the major in west segment of South Tianshan in Xinjiang region. Some MMT also occurred in this area in the intersection of Kalpin block and the Puchang fault zone. It takes IET as the major in middle Tianshan in Xinjiang. Along the Qilianshan seismic belt, most of sequences are MAT. In Qinghai region, it takes MAT as the major, but the regional feature of the spatial distribution of sequence types is not very clear. In North China, it takes MAT as the major in Yinshan-Yanshan-Bohai seismic belt, north edge of North China, and in Hebei plain seismic belt, as well as in sub-plate of lower river area of Yangtze River. In intersection of north segment of Shanxi seismic belt and the NW-trending Yinshan-Yanshan-Bohai seismic belt, there are several moderate or strong MMT with magnitude from 5.0 to 6.0 occurred. In south of North China around the latitude line of 35°N, it takes IET as the major. The spatial distribution of sequence types is relevant to the patterns of tectonic movements. MAT is mostly produced by the ruptures of locked units or asperities or the neonatal separating segments inside the fault zones. MMT is generally relevant to the conjugate structures or intersection of many tectonic settings. Further extension of simple fault often produces IET. Spatial distribution of sequence types is also correlative to the regional and deep environment of crustal medium to some extent. MAT mainly distributes in high velocity area in upper crust or in the transition zone between high velocity area and low velocity area, MMT mostly occurred in the low velocity area in upper crust.
文摘In this paper we consider the following problem ui=△u^m+bi(u^n)x Letu=u(x,t)be a continuous weak solution of the equation in R^N×(0,T)for someT>0.Then we conclude;Corresponding to u there is a unique nonnegative Borel measure v on R^Nwhich is the initial trace of u;there is the global inequality of Harnack type for u;the initial tracev must belong to a certain growth class;consequently,by combining the results mentioned above a u-niqueness conclusion is established.
