Behavior of Medium-frequency Core Loss in Fe-based Nanocrystalline Soft Magnetic Alloys

The dependences of the power loss per cycle on frequency have been investigated in the ranges of 100 Hz<= f<=25000 Hz and 0.1 T< =Bm <=1.0 T for three main original magnetic states in five sorts of Fe-based nanocrystalline soft magnetic alloys. The measured and calculated results showed that the total power loss per cycle clearly exhibited a nonlinear behavior in the range below 3 kHz～5 kHz depending on both the magnetic state and the value of Dm, whereas it showed a quasi-linear behavior above this range. The total loss was decomposed into hysteresis loss, classical eddy current loss and excess loss, the obvious nonlinear behavior has been confirmed to be completely determined by the dependence of the excess loss on frequency. It has been indicated that the change rate of the excess loss per cycle with respect to frequency sharp decreases with increasing frequency in the range below about 3 kHz～5 kHz, wherease the rate of change slowly varies above this range, thus leading to the quasilinear behavior of the total loss per cycle. In this paper, some linear expressions of the total loss per cycle has been given in a wider medium-frequency segment, which can be used for roughly estimating the total loss.

Numerical Simulation of Electromagnetic Field and Temperature Field in Medium-Frequency Induction Furnace Melting Process

A mathematical model for describing the melting process in the medium-frequency induction furnace was developed.Finite difference method was applied to deal with coupling electromagnetic field and temperature field in the melting process.The magnetic induction,temperature distribution and the phase interface moving characteristic during melting of the furnace burden were calculated.The effects of the direct current and inductive heating frequency on the process were analyzed.The simulation results show that:In the direction of burden radius,magnetic induction decreases from the outside of the burden to the center.Solid/liquid interface moves gradually from the outside of the burden to the center.The movement speed increases when the burden begins to melt.In the direction of the burden height,the distribution of eddy current in the surface is accord with the edge effect of the coil.Solid/liquid interface moves gradually from the center to the two sides.The direct current has a greater effect on the electromagnetic field and temperature field than frequency.

Influence of Negative Bias Voltage on the Mechanical and Tribological Properties of MoS_2/Zr Composite Films

MoS2/Zr composite films were deposited on the cemented carbide YT14 （WC＋14%TiC＋6%Co） by medium-frequency magnetron sputtered and coupled with multi-arc ion plated techniques.The influence of negative bias voltage on the composite film properties,including adhesion strength,micro-hardness,thickness and tribological properties were investigated.The results showed that proper negative bias voltage could significantly improve the mechanical and tribological properties of composite films.The effects of negative bias voltage on film properties were also put forward.The optimal negative bias voltage was -200 V under this experiment conditions.The obtained composite films were dense,the adhesion strength was about 60 N,the thickness was about 2.4 μm,and the micro-hardness was about 9.0 GPa.The friction coefficient and wear rate was 0.12 and 2.1×10-7 cm3/N·m respectively after 60 m sliding operation against hardened steel under a load of 20 N and a sliding speed of 200 rev·min-1.