Responses of HFR-LWC beams under close-range blast loadings accompanying membrane action

The load-carrying capacities and failure patterns of reinforced concrete components can be significantly changed by membrane effects.However,limited work has been carried out to investigate the blast resistance of Hybrid Fiber Reinforced Lightweight Aggregate Concrete(HFR-LWC)members accompanying membrane action.This paper presents a theoretical approach to quantitatively depicting the membrane behavior and its contribution on the behavior of HFR-LWC beams under close-range blast loadings,and the suitability of the proposed model is validated by a series of field tests.An improved Single-Degree-of-Freedom(SDOF)model was employed to describe the dynamic responses of beam-like members under blast loadings accompanying membrane action,where the mass-load coefficient is determined according to the nonuniformly distributed load induced by close-range explosion,and the membrane action is characterized by an in-plane(longitudinal)force and a resisting moment.The elastoplastic and recovery responses of HFR-LWC beams under the combined action of blast load and membrane force were analyzed by the promoted model.A specially built end-constrain clamp was developed to provide membrane action for the beam member when they are subjected to blast load simultaneously.It is demonstrated that the analytical displacement-time histories are in good agreement with experimental results before peak deflections and that the improved SDOF model is an acceptable tool for predicting the behavior of HFR-LWC beams under blast loadings accompanying membrane action.

Membrane action in lateral restraint reinforced concrete slabs

Based on the assumption of additional three-hinge arching action,an analytical method was proposed to predict the additional load of lateral restraint reinforced concrete (RC) slab under compressive membrane action (CMA),and its ultimate load could be obtained by adding pure bending load. The experiment of twelve one-way RC slabs supported by shear-walls was carried out,and the calculations of this proposed method provide good predictions for the experimental evidences. The influence of some design parameters on bearing capacity was also investigated. It is shown that the effect of vertical load on ending shear-wall on the ultimate load capacity can be generally neglected when the bending restraint is satisfied. The additional load capacity also decreases with the increase of the span-to-height ratio of central slab. When reducing the reinforcement area,the additional load capacity is increased,and this method can be used to save steel or enhance the ultimate load capacity of low steel ratio slab.

THE SURFACE STATE OF MACROPHAGE MEMBRANE UNDER THE ACTION OF Ca^(2+) AND Con A.

The effects of Ca2+ and Con A on the membrane surface of macrophage were studied by STM. Higher peaks correspond to the membrane proteins which were aggregated. Some band-like and lower furrows were expressed in the domain of membrane lipids.