Two sulfonylurea herbicides, metsulfuron methyl （Ally 20 WP） and chlorimuron ethyl （Classic 25 WP） were evaluated for their dissipation bchaviour in alluvial, coastal saline and laterite soils under laboratory inc...Two sulfonylurea herbicides, metsulfuron methyl （Ally 20 WP） and chlorimuron ethyl （Classic 25 WP） were evaluated for their dissipation bchaviour in alluvial, coastal saline and laterite soils under laboratory incubated condition at 60% water holding capacity of soils and 30 ℃ temperature was maintained. In field study herbicides were applied twice for the control of grasses, annual and perennials broad leaves weeds and sedges in rice, wheat and soybean to find out the residual fate of both the herbicides on different matrices of respective crops after harvest. Extraction and clean up methodologies for the herbicides were standardized and subsequently analyzed by HPLC. The study revealed that the half-lives of metsulfuron methyl and chlorimuron ethyl ranged from 10.75 to 13.94 d irrespective of soils and doses applied. Field trials with rice, wheat and soybean also revealed that these two herbicides could safely be recommended for application as no residues were detected in the harvest samples.展开更多
Bound residue(BR) of 14 C-metsulfuron-methyl ( 14 C-BR) in seven kinds of soil was significantly negative-related to soil pH and positive-related to the clay content during the initial 20 d of incubat...Bound residue(BR) of 14 C-metsulfuron-methyl ( 14 C-BR) in seven kinds of soil was significantly negative-related to soil pH and positive-related to the clay content during the initial 20 d of incubation, but only was significantly negative-related to soil pH after 30 d incubation. Again, the soil pH was found to be the dominant factor affecting BR formation from 14 C-metsulfuron-methyl among the basic properties(soil pH, clay, OM and CEC etc.) of soil. The maximum content of 14 C-BR in the 7 soils accounted for 19.3%-52.6% of applied amount. In addition, the composition of the 14 C-BR in fluvio marine yellow loamy(S 7) at the 90 d of incubation was identified using the coupling technique of LC-MS and isotope tracing method. The results showed that the 14 C-[2-amino-4-hydroxyl-6-methyl-1, 3, 5]-triazine, 14 C-[2-amino-4-methoxy-6-methyl-1, 3, 5]-triazine and 14 C-metsulfuron-methyl parent compound constituted the main components of the BR derived from 14 C-metsulfuron-methyl in the S 7. The relative percentage of the three compounds accounted for 41.4%, 35.8% and 19.3% of total recovery radioactivity, respectively. The results also indicated that a non-radioactive component, 2-methylformate-benzenesulfonyl-isocyanate, one of the degraded products of metsulfuron-methyl in soil, was also found to be one of the components of the BR. The parent compound in BR can well explain the phytotoxic effect on substitution crops caused by the BR derived from metsulfuron-methyl in soil.展开更多
Metsulfuron-methyl molecularly imprinted polymer（MIP）-coated stir bar was prepared for sorptive extraction of sulfonylurea herbicides in complex samples.The MIP-coating was about 21.3 μm thickness with the relative...Metsulfuron-methyl molecularly imprinted polymer（MIP）-coated stir bar was prepared for sorptive extraction of sulfonylurea herbicides in complex samples.The MIP-coating was about 21.3 μm thickness with the relative standard deviation（RSD） of 4.4%（n=10）.It was homogeneous and porous with good thermal stability and chemical stability.The extraction capability of the MIP-coating was 2.8 times over that of the non-imprinted polymer（NIP）-coating in hexane.The MIP-coating exhibited selective adsorption ability to the template and its analogues.The extraction conditions,including extraction solvent,desorption solvent,extraction time,desorption time and stirring speed,were optimized.A method for the determination of six sulfonylurea herbicides by MIP-coated stir bar sorptive extraction coupled with high performance liquid chromatography（HPLC） was developed.The linear range was 10―200 μg/L and the detection limits were within a range of 2.0―3.3 μg/L.It was also applied to the analysis of sulfonylurea herbicides in spiked river water,soil and rice samples.展开更多
Differential pulse cathodic stripping voltammetry was used to determine pesticide metsulfuron-methyl on a suspended mercury electrode.Specific experimental parameters,such as the pH of Britton-Robinson buffer,accumula...Differential pulse cathodic stripping voltammetry was used to determine pesticide metsulfuron-methyl on a suspended mercury electrode.Specific experimental parameters,such as the pH of Britton-Robinson buffer,accumulation time,accumulation potential,and initial potential were optimized.The results show that a typical reduction peak appeared when pH was 2.0-4.0 and initial potential ranged from-0.75 to-1.0 V.To obtain the stripping signal of the best reduction peak,it is determined that the best pH was 2.0.The detection limit of the method was only 0.04 mg/L,and it had good selectivity and high accuracy,so the method has high sensitivity.In the analysis of actual drinking water,the recovery rate of metsulfuron-methyl could reach 93%-101%.展开更多
文摘Two sulfonylurea herbicides, metsulfuron methyl （Ally 20 WP） and chlorimuron ethyl （Classic 25 WP） were evaluated for their dissipation bchaviour in alluvial, coastal saline and laterite soils under laboratory incubated condition at 60% water holding capacity of soils and 30 ℃ temperature was maintained. In field study herbicides were applied twice for the control of grasses, annual and perennials broad leaves weeds and sedges in rice, wheat and soybean to find out the residual fate of both the herbicides on different matrices of respective crops after harvest. Extraction and clean up methodologies for the herbicides were standardized and subsequently analyzed by HPLC. The study revealed that the half-lives of metsulfuron methyl and chlorimuron ethyl ranged from 10.75 to 13.94 d irrespective of soils and doses applied. Field trials with rice, wheat and soybean also revealed that these two herbicides could safely be recommended for application as no residues were detected in the harvest samples.
文摘Bound residue(BR) of 14 C-metsulfuron-methyl ( 14 C-BR) in seven kinds of soil was significantly negative-related to soil pH and positive-related to the clay content during the initial 20 d of incubation, but only was significantly negative-related to soil pH after 30 d incubation. Again, the soil pH was found to be the dominant factor affecting BR formation from 14 C-metsulfuron-methyl among the basic properties(soil pH, clay, OM and CEC etc.) of soil. The maximum content of 14 C-BR in the 7 soils accounted for 19.3%-52.6% of applied amount. In addition, the composition of the 14 C-BR in fluvio marine yellow loamy(S 7) at the 90 d of incubation was identified using the coupling technique of LC-MS and isotope tracing method. The results showed that the 14 C-[2-amino-4-hydroxyl-6-methyl-1, 3, 5]-triazine, 14 C-[2-amino-4-methoxy-6-methyl-1, 3, 5]-triazine and 14 C-metsulfuron-methyl parent compound constituted the main components of the BR derived from 14 C-metsulfuron-methyl in the S 7. The relative percentage of the three compounds accounted for 41.4%, 35.8% and 19.3% of total recovery radioactivity, respectively. The results also indicated that a non-radioactive component, 2-methylformate-benzenesulfonyl-isocyanate, one of the degraded products of metsulfuron-methyl in soil, was also found to be one of the components of the BR. The parent compound in BR can well explain the phytotoxic effect on substitution crops caused by the BR derived from metsulfuron-methyl in soil.
基金Supported by the National Natural Science Foundation of China(Nos.21127008,21075140,21105133,90817012)the Key Program of Natural Science Foundation of Guangdong Province,China(No.9251027501000004)+1 种基金the Cooperation Project in Industry,Education and Research of Guangdong Province and Ministry of Education of China(No.2010B090400142)the Fundamental Research Funds for the Central Universities of China
文摘Metsulfuron-methyl molecularly imprinted polymer（MIP）-coated stir bar was prepared for sorptive extraction of sulfonylurea herbicides in complex samples.The MIP-coating was about 21.3 μm thickness with the relative standard deviation（RSD） of 4.4%（n=10）.It was homogeneous and porous with good thermal stability and chemical stability.The extraction capability of the MIP-coating was 2.8 times over that of the non-imprinted polymer（NIP）-coating in hexane.The MIP-coating exhibited selective adsorption ability to the template and its analogues.The extraction conditions,including extraction solvent,desorption solvent,extraction time,desorption time and stirring speed,were optimized.A method for the determination of six sulfonylurea herbicides by MIP-coated stir bar sorptive extraction coupled with high performance liquid chromatography（HPLC） was developed.The linear range was 10―200 μg/L and the detection limits were within a range of 2.0―3.3 μg/L.It was also applied to the analysis of sulfonylurea herbicides in spiked river water,soil and rice samples.
文摘Differential pulse cathodic stripping voltammetry was used to determine pesticide metsulfuron-methyl on a suspended mercury electrode.Specific experimental parameters,such as the pH of Britton-Robinson buffer,accumulation time,accumulation potential,and initial potential were optimized.The results show that a typical reduction peak appeared when pH was 2.0-4.0 and initial potential ranged from-0.75 to-1.0 V.To obtain the stripping signal of the best reduction peak,it is determined that the best pH was 2.0.The detection limit of the method was only 0.04 mg/L,and it had good selectivity and high accuracy,so the method has high sensitivity.In the analysis of actual drinking water,the recovery rate of metsulfuron-methyl could reach 93%-101%.
