A new silicon beam resonator design for a novel gas sensor based on simultaneous conductivity and mass change measurement is investigated. High selectivity and sensitivity in gas detection can be obtained by measuring...A new silicon beam resonator design for a novel gas sensor based on simultaneous conductivity and mass change measurement is investigated. High selectivity and sensitivity in gas detection can be obtained by measuring the charge-to-mass ratio of gas molecules. Structures of silicon beam resonators are designed, simulated, and optimized. This gas sensor is fabricated using sacrificial layer microelectronmechanical system technology, and the resonant frequency of the microbeam is measured.展开更多
The formaldehyde （HCHO） detecting at room temperature is of great significance. Different ratios of P3HT/ZnO composite films （3：1, 1：1, and 1：3） were deposited on the organic thin film transistor （OTFT） by sp...The formaldehyde （HCHO） detecting at room temperature is of great significance. Different ratios of P3HT/ZnO composite films （3：1, 1：1, and 1：3） were deposited on the organic thin film transistor （OTFT） by spray-deposition technology, and the electrical properties and HCHO-sensing properties of all the prepared OTFT devices were measured by Keithley 4200-SCS source measurement unit. The results show that the OTFT sensor based on the P3HT/ZnO films with the ratio of 1：1 exhibited the best output and transfer curves. Different changing tendency were observed with the increase of ZnO proportion when exposed to HCHO at room temperature, and the device with the ratio of 1：1 behaved a good response and recovery characteristics.展开更多
文中提出基于 Bluetooth 技术的分布式无线网络测控系统的体系结构,并设计了系统的前、后端硬件构成。由此得出 Bluetooth 传感器的工作原理与功能,重点对 Bluetooth 传感器的电路结构和软件功能及其应用进行了研究。Bluetooth 传感器...文中提出基于 Bluetooth 技术的分布式无线网络测控系统的体系结构,并设计了系统的前、后端硬件构成。由此得出 Bluetooth 传感器的工作原理与功能,重点对 Bluetooth 传感器的电路结构和软件功能及其应用进行了研究。Bluetooth 传感器由单片机80C51、通用数字传感器接口 ADIB60和 Bluetooth 模块 BlueCore01B 等组成,通过对 BlueCore01B 和 ADIB60的结构特性的分析,对 80C51与 BlueCore 和 ADIB60之间接口和通信的软、硬件进行了设计。Bluetooth 传感器可实现测控微微网和互联网,扩大和增强了测控应用领域和功能。展开更多
The application of Bluetooth on the pH sensor was accomplished.Based on the experimental results,Bluetooth technology was used to measure pH values without limiting the distance.Moreover,Biuetooth technology provides ...The application of Bluetooth on the pH sensor was accomplished.Based on the experimental results,Bluetooth technology was used to measure pH values without limiting the distance.Moreover,Biuetooth technology provides low power, low cost and small volume,therefore,it can increase the practicability of the system.In this investigation,the pH value was detected by the SnO_2/ITO glass-based pH sensor.During the signal progress,the detected signal was transferred to the microchip PIC18.After that,the microchip was able to communicate with PC by the Bluetooth.Moreover,the microchip can diagnose the sensing signal and sends the warning signal by alert function.In addition,the part of PC has the ability to record the information,builds the database for analyzing the pH values,and provides a better long-distance monitoring system.展开更多
文摘A new silicon beam resonator design for a novel gas sensor based on simultaneous conductivity and mass change measurement is investigated. High selectivity and sensitivity in gas detection can be obtained by measuring the charge-to-mass ratio of gas molecules. Structures of silicon beam resonators are designed, simulated, and optimized. This gas sensor is fabricated using sacrificial layer microelectronmechanical system technology, and the resonant frequency of the microbeam is measured.
基金supported by National Natural Foundation of China under Grant No.61176066 and 61101031
文摘The formaldehyde （HCHO） detecting at room temperature is of great significance. Different ratios of P3HT/ZnO composite films （3：1, 1：1, and 1：3） were deposited on the organic thin film transistor （OTFT） by spray-deposition technology, and the electrical properties and HCHO-sensing properties of all the prepared OTFT devices were measured by Keithley 4200-SCS source measurement unit. The results show that the OTFT sensor based on the P3HT/ZnO films with the ratio of 1：1 exhibited the best output and transfer curves. Different changing tendency were observed with the increase of ZnO proportion when exposed to HCHO at room temperature, and the device with the ratio of 1：1 behaved a good response and recovery characteristics.
文摘The application of Bluetooth on the pH sensor was accomplished.Based on the experimental results,Bluetooth technology was used to measure pH values without limiting the distance.Moreover,Biuetooth technology provides low power, low cost and small volume,therefore,it can increase the practicability of the system.In this investigation,the pH value was detected by the SnO_2/ITO glass-based pH sensor.During the signal progress,the detected signal was transferred to the microchip PIC18.After that,the microchip was able to communicate with PC by the Bluetooth.Moreover,the microchip can diagnose the sensing signal and sends the warning signal by alert function.In addition,the part of PC has the ability to record the information,builds the database for analyzing the pH values,and provides a better long-distance monitoring system.
