A Study on Dual-Load-Zone Model of Overlying Strata andEvolution Law of Mining Stress

The changeable structure and movement law of overlying strata are the maincontributor to the change of mining stress.Starting from the relevant theory of keystratum and particularly based on the theory of mine ground pressure and strata control,this research proposed a new solution to mining stress problems by establishing adual-load-zone stratum structural model.Elastic foundation beam theory was used tosolve the stress of overlying strata of the dual-load-zones with superposition method,which revised the traditional calculation method of mining stress.The abnormal increaseof lead abutment pressure in the mining area was explained effectively,through which theevolution law of mining stress in the case of hard rock was obtained.The results indicatethat mining stress experiences a drastic change within the range of 50 m ahead of the coalwall due to the collapse of main roof;under the influence of main key stratum andinferior key strata,the influence range of lead abutment pressure is extended up toapproximately 120 m in the working face;this remarkable increase can be attributed tothe excessive length of sagging zone.Results from both the dual-load-zone modelexperiment and field measurement demonstrate high consistency.The model can predictthe influence range of abutment pressure effectively and thus guide the safety productionof mining.

Tomography of the dynamic stress coefficient for stress wave prediction in sedimentary rock layer under the mining additional stress

In this study,the tomography of dynamic stress coefficient(TDSC)was established based on a mechanical model of stress wave propagation in bedding planes and a mathematical model of the stress wave attenuation in rock masses.The reliability of the TDSC was verified by a linear bedding plane model and field monitoring.Generally,the TDSC in the dynamic stress propagation of bedding planes increases with the following conditions:(1)the increase of the normal stiffness of the bedding plane,(2)the increase of the incident angle of the stress wave,(3)the decrease of the incident frequency of the stress wave,or(4)the growth of three ratios(the ratios of rock densities,elastic moduli,and the Poisson’s ratios)of rocks on either side of bedding planes.The additional stress weakens TDSC linearly and slowly during the stress wave propagation in bedding planes,and the weakening effect increases with the growth of the three ratios.Besides,the TDSC decreases exponentially in the rock mass as propagation distance increases.In a field case,the TDSC decreases significantly as vertical and horizontal distances increase and its wave range increases as vertical distance increases in the sedimentary rock layers.

Development of a time-dependent energy model to calculate the mining-induced stress over gates and pillars

Generally, longwall mining-induced stress results from the stress relaxation due to destressed zone that occurs above the mined panel. Knowledge of induced stress is very important for accurate design of adjacent gateroads and intervening pillars which helps to raise the safety and productivity of longwall mining operations. This study presents a novel time-dependent analytical model for determination of the longwall mining-induced stress and investigates the coefficient of stress concentration over adjacent gates and pillars. The model is developed based on the strain energy balance in longwall mining incorporated to a rheological constitutive model of caved materials with time-varying parameters. The study site is the Tabas coal mine of Iran. In the proposed model, height of destressed zone above the mined panel, total longwall mining-induced stress, abutment angle, induced vertical stress, and coefficient of stress concentration over neighboring gates and intervening pillars are calculated. To evaluate the effect of proposed model parameters on the coefficient of stress concentration due to longwall mining, sensitivity analysis is performed based on the field data and experimental constants. Also, the results of the proposed model are compared with those of existing models. The comparative results confirm a good agreement between the proposed model and the in situ measurements. According to the obtained results, it is concluded that the proposed model can be successfully used to calculate the longwall mining-induced stress. Therefore, the optimum design of gate supports and pillar dimensions would be attainable which helps to increase the mining efficiency.

Mechanism of gas pressure action during the initial failure of coal containing gas and its application for an outburst inoculation

Faced with the continuous occurrence of coal and gas outburst(hereinafter referred to as“outburst”)disasters,as a main controlling factor in the evolution process of an outburst,for gas pressure,it is still unclear about the phased characteristics of the coupling process with in situ stress,which induce coal damage and instability.Therefore,in the work based on the mining stress paths induced by typical outburst accidents,the gradual and sudden change of three-dimensional stress is taken as the background for the mechanical reconstruction of the disaster process.Then the true triaxial physical experiments are conducted on the damage and instability of coal containing gas under multiple stress paths.Finally,the response characterization between coal damage and gas pressure has been clarified,revealing the mechanism of action of gas pressure during the initial failure of coals.And the main controlling mechanism during the outburst process is elucidated in the coupling process of in situ stress with gas pressure.The results show that during the process of stress loading and unloading,the original gas pressure enters the processes of strengthening and weakening the action ability successively.And the strengthening effect continues to the period of large-scale destruction of coals.The mechanical process of gas pressure during the initial failure of coals can be divided into three stages:the enhancement of strengthening action ability,the decrease of strengthening action ability,and the weakening action ability.The entire process is implemented by changing the dominant action of in situ stress into the dominant action of gas pressure.The failure strength of coals is not only affected by its original mechanical strength,but also by the stress loading and unloading paths,showing a particularly significant effect.Three stages can be divided during outburst inoculation process.That is,firstly,the coals suffer from initial damage through the dominant action of in situ stress with synergy of gas pressure;secondly,the coals with spallation of structural division are generated through the dominant action of gas pressure with synergy of in situ stress,accompanied by further fragmentation;and finally,the fractured coals suffer from fragmentation and pulverization with the gas pressure action.Accordingly,the final broken coals are ejected out with the gas action,initiating an outburst.The research results can provide a new perspective for deepening the understanding of coal and gas outburst mechanism,laying a theoretical foundation for the innovation of outburst prevention and control technologies.