High Coupling Efficiency of the Fiber-Coupled Module Based on Photonic-Band-Crystal Laser Diodes

The coupling efficiency of the beam combination and the fiber-coupled module is limited due to the large vertical divergent angle of conventional semiconductor laser diodes. We present a high coupling efficiency module using photonic-band-crystal （PBC） laser diodes with narrow vertical divergent angles. Three PBC single-emitter laser diodes are combined into a fiber with core diameter of 105μm and numerical aperture of 0.22. A high coupling efficiency of 94.4% is achieved and the brightness is calculated to be 1.T MW/（cm2.sr） with the injection current of 8A.

Design and Analysis of Spatial Modulation Based Orthogonal Time Frequency Space System

In this paper,we design a spatial modulation based orthogonal time frequency space(SMOTFS)system to achieve improved transmission reliability and meet the high transmission rate and highspeed demands of future mobile communications,which fully utilizes the characteristics of spatial modulation(SM)and orthogonal time frequency space(OTFS)transmission.The detailed system design and signal processing of the SM-OTFS system have been presented.The closed-form expressions of the average symbol error rate(ASER)and average bit error rate(ABER)of the SM-OTFS system have been derived over the delay-Doppler channel with the help of the union bounding technique and moment-generating function(MGF).Meanwhile,the system complexity has been evaluated.Numerical results verify the correctness of the theoretical ASER and ABER analysis of the SM-OTFS system in the high signal-to-noise ratio(SNR)regions and also show that the SM-OTFS system outperforms the traditional SM based orthogonal frequency division multiplexing(SM-OFDM)system with limited complexity increase under mobile conditions,especially in high mobility scenarios.

Joint synchronization estimation based on genetic algorithm for OFDM/OQAM systems

This paper investigates the problem of synchronization for offset quadrature amplitude modulation based orthogonal frequency division multiplexing(OFDM/OQAM) systems based on the genetic algorithm. In order to increase the spectrum efficiency,an improved preamble structure without guard symbols is derived at first. On this basis, instead of deriving the log likelihood function of power spectral density, joint estimation of the symbol timing offset and carrier frequency offset based on the preamble proposed is formulated into a bivariate optimization problem. After that, an improved genetic algorithm is used to find its global optimum solution. Conclusions can be drawn from simulation results that the proposed method has advantages in the joint estimation of synchronization.

Compressive sensing based multiuser detector for massive MBM MIMO uplink

Media based modulation(MBM)is expected to be a prominent modulation scheme,which has access to the high data rate by using radio frequency(RF)mirrors and fewer transmit antennas.Associated with multiuser multiple input multiple output(MIMO),the MBM scheme achieves better performance than other conventional multiuser MIMO schemes.In this paper,the massive MIMO uplink is considered and a conjunctive MBM transmission scheme for each user is employed.This conjunctive MBM transmission scheme gathers aggregate MBM signals in multiple continuous time slots,which exploits the structured sparsity of these aggregate MBM signals.Under this kind of scenario,a multiuser detector with low complexity based on the compressive sensing(CS)theory to gain better detection performance is proposed.This detector is developed from the greedy sparse recovery technique compressive sampling matching pursuit(CoSaMP)and exploits not only the inherently distributed sparsity of MBM signals but also the structured sparsity of multiple aggregate MBM signals.By exploiting these sparsity,the proposed CoSaMP based multiuser detector achieves reliable detection with low complexity.Simulation results demonstrate that the proposed CoSaMP based multiuser detector achieves better detection performance compared with the conventional methods.

Magneto and Electro-Optic Intensity Modulator Based on Liquid Crystal and Magnetic Fluid Filled Photonic Crystal Fiber

We propose a novel light intensity modulator based on magnetic fluid and liquid crystal（LC） filled photonic crystal fibers（PCFs）. The influences of electric and magnetic fields on the transmission intensity are theoretically and experimentally analyzed and investigated. Both the electric and magnetic fields can manipulate the molecular arrangement of LC to array a certain angle without changing the refractive index of the LC. Therefore, light loss in the PCF varies with the electric and magnetic fields whereas the peak wavelengths remain constant. The experimental results show that the transmission intensity decreases with the increase of the electric and magnetic fields. The cut-off electric field is 0.899 V/um at 20 Hz and the cut-off magnetic field is 195 m T. This simple and compacted optical modulator will have a great prospect in sensing applications.

Automatic modulation classification using modulation fingerprint extraction

An automatic method for classifying frequency shift keying(FSK),minimum shift keying(MSK),phase shift keying(PSK),quadrature amplitude modulation(QAM),and orthogonal frequency division multiplexing(OFDM)is proposed by simultaneously using normality test,spectral analysis,and geometrical characteristics of in-phase-quadrature(I-Q)constellation diagram.Since the extracted features are unique for each modulation,they can be considered as a fingerprint of each modulation.We show that the proposed algorithm outperforms the previously published methods in terms of signal-to-noise ratio(SNR)and success rate.For example,the success rate of the proposed method for 64-QAM modulation at SNR=11 dB is 99%.Another advantage of the proposed method is its wide SNR range;such that the probability of classification for 16-QAM at SNR=3 dB is almost 1.The proposed method also provides a database for geometrical features of I-Q constellation diagram.By comparing and correlating the data of the provided database with the estimated I-Q diagram of the received signal,the processing gain of 4 dB is obtained.Whatever can be mentioned about the preference of the proposed algorithm are low complexity,low SNR,wide range of modulation set,and enhanced recognition at higher-order modulations.

STABILIZATION EFFECT OF MULTI-MACHINE POWER SYSTEM BY USING ADJUSTA BLE SPEED GENERATOR

This paper describes a stabilization effect after installating an adjustable speed generator (ASG) in a multi machine power system. A personal computer based ASG module has been de veloped for the simulations in parallel with the analog power system simulator i n the Research Laboratory of the Kyushu Electric Power Co. The three phase ins t antaneous value based ASG model has been developed in the Matlab/Simulink envir onment for its detailed and real time simulations, which have been performed on a digital signal processor (DSP) board with AD and DA conversion interfaces inst alled in a personal computer (PC). Simulational results indicate the hig hly improved overall stability of the multi machine power system after installa ting the ASG.

A DC Chopper Topology to Mitigate Commutation Failure of Line Commutated Converter Based High Voltage Direct Current Transmission

To reduce the probability of commutation failure(CF)of a line commutated converter based high-voltage direct current(LCC-HVDC)transmission,a DC chopper topology composed of power consumption sub-modules based on thyristor full-bridge module(TFB-PCSM)is proposed.Firstly,the mechanism of the proposed topology to mitigate CF is analyzed,and the working modes of TFB-PCSM in different operation states are introduced.Secondly,the coordinated control strategy between the proposed DC chopper and LCC-HVDC is designed,and the voltage-current stresses of the TFB-PCSMs are investigated.Finally,the ability to mitigate the CF issues and the fault recovery performance of LCC-HVDC system are studied in PSCAD/EMTDC.The results show that the probability of CF of LCC-HVDC is significantly reduced,and the performances of fault recovery are effectively improved by the proposed DC chopper.

Optical Nonlinearity in a Novel Optical Signal Regeneration System Based on Cross-Gain Modulation Using Cascaded Semiconductor Optical Amplifiers

We propose a novel optical signal regeneration system based on wavelength converters by use of cross gain modulation in cascaded semiconductor optical amplifiers. The nonlinearity in optical input/output characteristics and eye opening using NRZ signal were archived.

112 Gbit/s transmitter optical subassembly based on hybrid integrated directly modulated lasers

Based on the hybrid integration technology, an ultra-compact and low cost transmitter optical subassembly module is proposed. Four directly modulated lasers are combined with a coarse wavelength division multiplexer operated at the O-band. The bandwidth for all channels is measured to be approximately 3 GHz. The 112 Gb∕s transmission is experimentally demonstrated for a 10 km standard single mode fiber（SSMF）, in which an optical isolator is used for avoiding the back-reflected and scattered light to improve the bit error rate（BER） performance. A low BER and clear eye opening are achieved for 10 km transmission.

All-fiber acousto-optic modulator based on a cladding-etched optical fiber for active mode-locking

An all-fiber acousto-optic modulator(AOM), which features a compact structure and a low-driving voltage, is experimentally demonstrated for the active mode-locking of a fiber laser. The proposed AOM is based on the short length of the cladding-etched fiber, the ends of which are fixed on a slide glass. On top of the cladding-etched fiber, a piezoelectric transducer was overlaid. A chemical wet-etching technique, which is based on a mixed solution of NH_4F and (NH_4)2SO_4, is used to reduce the fiber diameter down to ～25 μm, and the length of the etched section is only 0.5 cm. The fabricated device exhibited a modulation depth of 73.10% at an acoustic frequency of 918.9 kHz and a peak-to-peak electrical voltage of 10 V, while a laser beam was coupled at 1560 nm.By using the prepared AOM within an erbium-doped-fiber ring cavity, the mode-locked pulses with a temporalwidth of 2.66 ps were readily obtained at a repetition rate of 1.838 MHz.

Tunable frequency-multiplying optoelectronic oscillator based on a dual-parallel Mach-Zehnder modulator incorporating a phase-shifted fiber Bragg grating

A tunable frequency-multiplying optoelectronic oscillator(OEO) based on a dual-parallel Mach-Zehnder modulator(DPMZM) is proposed and experimentally demonstrated. In the proposed system, the tunable fundamental microware signal is generated by a tunable optoelectronic oscillator incorporating a phase-shifted fiber Bragg grating(PS-FBG). By adjusting the DC bias of the DPMZM, the frequency-doubled microwave signal with a tunable frequency range from 11 GHz to 20 GHz and the frequency-quadrupled microwave signal with a tunable frequency range from 22.5 GHz to 26 GHz are generated. The phase noises of the fundamental, frequency-doubled and frequency-quadrupled signals at 10 k Hz offset frequency are-105.9 d Bc/Hz,-103.3 d Bc/Hz and-86.2 d Bc/Hz, respectively.

High-Performance Optical Modulators Based on Potential- Tailored Quantum Wells

The five -layer asymmetric coupled quantum well ( FACQW) , which is one of the potential -tailored quantum wells, is expected to show very large electrorefrac live index cha nge in a wideband transpar ency region far from the absorption edge. Characteristics of the FACQW and its application to compact, ultrafast , low voltage optical modul ators and switches are dis cussed.

A Novel Electro-Optic Polymer Modulator Based on Long Period Fiber Gratings

A novel high-speed electro-optic (EO) polymer modulator based on long period gratings (LPG) is designed. Using the theory of multi-cladding optical waveguide, we achieved relationship between modulate voltage and LPG's resonant wavelength.

Electrical nonlinearity in silicon modulators based on reversed PN junctions

The electrical nonlinearity of silicon modulators based on reversed PN junctions was found to severely limit the linearity of the modulators.This effect,however,was inadvertently neglected in previous studies.Considering the electrical nonlinearity in simulation,a 32.2 dB degradation in the CDR3(i.e.,the suppression ratio between the fundamental signal and intermodulation distortion)of the modulator was observed at a modulation speed of 12 GHz,and the spurious free dynamic range was simultaneously degraded by 17.4 dB.It was also found that the linearity of the silicon modulator could be improved by reducing the series resistance of the PN junction.The frequency dependence of the linearity due to the electrical nonlinearity was also investigated.

A position sensor based on grating projection with spatial filtering and polarization modulation

A position sensor based on grating projection with spatial filtering and polarization modulation is presented. A grating is projected onto the object to be measured through a 4f optical system with a spatial filter. After reflected by the object, the grating projection is imaged on a detection grating through another 4f optical system to form moiré fringes, The polarization modulated moiré signal is detected to obtain the position information of the object. In the position sensor, the moiré signal varies sinusoidally with the position of object. The measurement is independent of the incident intensity on the projection grating and the reflectivity of the object to be measured, In experiments, the effectiveness of the position sensor is proved, and the root mean square （RMS） error at each measurement position is less than 13 nm.

All-optical modulator based on MoS_2-PVA thin film

The all-optical approach plays an important role in ultrafast all-optical signal processing, and the all-fiber scheme has a wide application in optical communications. In this letter, we investigate an all-optical modulator using few-layer molybdenum disulfide（MoS2）-polyvinyl alcohol（PVA） thin films based on the thermo-optic effect and obtain a long-time stable modulated output by applying polarization interference. By absorbing the injected 980 nm pump（control light）, MoS2 generates heat, changes the refractive index of MoS2, and modulates the polarization of light. The obtained thermal all-optical modulator has a rise time of 526 μs.

Novel Variable PDL Emulator Based on LiNbO_3 Modulator

We propose and demonstrate a novel variable PDL emulator based on a LiNbO3 modulator. The proposed emulator could vary the PDL values simply by adjusting the bias voltage of modulator. The results show that the proposed PDL emulator could generate a wide range of PDL values (0 ~ 35 dB). The generated PDL value could be maintained within ±0.02 dB for >70 minutes. The wavelength dependency was about 0.03 dB in the range of 1520 nm~ 1590 nm.

Single to 16-Channel Wavelength Conversion at 10 Gb/s Based on Cross-Gain Modulation of ASE in SOA

Based on cross-gain modulation of Amplified Spontaneous Emission (ASE) in Semiconductor Optical Amplifier (SOA), single to 16-channel wavelength conversion at 10Gb/s is first demonstrated simultaneously without any additional probe lights.

An optical modulation format generation scheme based on spectral filtering and frequency-to-time mapping

An optical modulation format generation scheme based on spectral filtering and frequency-to-time mapping is experimentally demonstrated. Many modulation formats with continuously adjustable duty radio and bit rate can be formed by changing the dispersion of dispersion element and the bandwidth of shaped spectrum in this scheme. In the experiment, non-return-to-zero(NRZ) signal with bit rate of 29.41 Gbit/s and 1/2 duty ratio return-to-zero(RZ) signal with bit rate of 13.51 Gbit/s are obtained. The maximum bit rate of modulation format signal is also analyzed.