The adsorption behavior of molybdenum onto D314 was studied with the static adsorption method. The adsorption process was analyzed from thermodynamic and kinetic aspects. The experimental results show that the equilib...The adsorption behavior of molybdenum onto D314 was studied with the static adsorption method. The adsorption process was analyzed from thermodynamic and kinetic aspects. The experimental results show that the equilibrium adsorption data conform satisfactorily to the Langmuir equation. In the adsorption process of D314 for molybdenum, the enthalpy change ΔH is positive when temperature is in the range of 298-338 K, which indicates that the adsorption is an endothermic process, and the elevated temperature benefits to the adsorption. Kinetic analysis shows that the adsorption rate is controlled by intraparticle diffusion and chemical diffusion at the same time. The adsorption mechanism of molybdenum onto D314 was discussed based on IR spectra.展开更多
An experimental measurement of the lifetime of 3d^(9) ^(2)D_(3/2) metastable level in Mo^(15+)is reported in this work.The Mo^(15+)ions are produced and trapped in an electron beam ion trap with a magnetic field of 0....An experimental measurement of the lifetime of 3d^(9) ^(2)D_(3/2) metastable level in Mo^(15+)is reported in this work.The Mo^(15+)ions are produced and trapped in an electron beam ion trap with a magnetic field of 0.65 T.The decay photons emitted from 3d^(9) ^(2)D_(3/2) level are subsequently recorded via a cooled photomultiplier tube.Through meticulous scrutiny of potential systematic uncertainties affecting the measurement outcomes,we have determined the lifetime of Mo^(15+)3d^(9)2D_(3/2)metastable level to be 2.83(22)ms.The experimental result provides a clear distinguishment from existing calculations based on various theoretical approaches.展开更多
研究了采用ZGA351大孔强碱性阴离子交换树脂从粗钨酸铵溶液中吸附分离钼的工艺方法,考察了树脂型号、料液硫含量、料液陈化时间、料液陈化温度、料液pH值、吸附流速、吸附温度对树脂吸附分离钼效果的影响。结果表明:使用100 mL ZGA351...研究了采用ZGA351大孔强碱性阴离子交换树脂从粗钨酸铵溶液中吸附分离钼的工艺方法,考察了树脂型号、料液硫含量、料液陈化时间、料液陈化温度、料液pH值、吸附流速、吸附温度对树脂吸附分离钼效果的影响。结果表明:使用100 mL ZGA351树脂进行动态吸附试验,在料液硫含量为理论量1.1倍、料液陈化时间48 h、料液陈化温度40℃、料液pH值10.0、吸附流速15 mL/h、吸附温度40℃的最优条件下,料液钨损失率仅为0.54%,树脂钼穿透容量为107.77 g/L_(湿树脂),相比目前工业生产应用的HBDM-1树脂钼穿透容量提高了3.15倍。另外,重复试验稳定性良好,ZGA351树脂吸附后得到的纯钨酸铵溶液平均钼钨比为0.88×10^(-4),满足工业生产APT产品用纯钨酸铵溶液钼钨比小于2×10^(-4)的需求。综合而言,采用强碱性阴离子交换树脂从粗钨酸铵溶液中分离钼具有钼穿透容量高、钨损失率低、钨钼分离效率高等优势,为工业化应用提供了一种有效技术参考。展开更多
The separation techniques of vanadium and molybdenum were summarized, and a new method of removal V(Ⅴ) from Mo(Ⅵ) by adsorption with chelate resin was presented. Nine kinds of chelate resins were used to investigate...The separation techniques of vanadium and molybdenum were summarized, and a new method of removal V(Ⅴ) from Mo(Ⅵ) by adsorption with chelate resin was presented. Nine kinds of chelate resins were used to investigate the adsorbent capability of V(Ⅴ) in ammonium molybdate solution with static method. The test results show that DDAS, CUW and CW-2 resins can easily adsorb V(Ⅴ) in ammonium molybdate solution, but hardly adsorb Mo(Ⅵ). The dynamic experimental results show more than 99.5% of V(Ⅴ) can be adsorbed, and the adsorption rate of Mo(Ⅵ) is less than 0.27% at 294-296 K for 60 min at pH 7.42-8.02. The mass ratio of V to Mo decreases to l/5 0000 in the effluent from 1/255 in the initial solution. The loaded resin can be desorbed by 5% NH3·H2O solution, and the vanadium desorption rate can reach 99.6%. The max concentration of vanadium in desorbed solution can reach 20 g/L, while the concentration of molybdenum is less than 0.8 g/L.展开更多
The application of the technique of removing molybdenum by moving packed bedand fluidized bed ion-exchange in a factory was described. The data showed that the Mo removalefficiency is above 99 percent, and the Mo cont...The application of the technique of removing molybdenum by moving packed bedand fluidized bed ion-exchange in a factory was described. The data showed that the Mo removalefficiency is above 99 percent, and the Mo content in APT (Ammonium Paratungstate) is controlledsteadily below 18 X l0^(-6), in the case of treating the feed liquor containing Mo 1.4 g/L. Thetechnique is simple and convenient in operation, good reusability of resin, loss consumption ofdesorption reagent and little pollution on environment. The loss of tungsten is less than 0.5percent. The technique bas been proved to be an economical and efficient process for Mo removal.展开更多
基金Project(51104186)supported by the National Natural Science Foundation of China
文摘The adsorption behavior of molybdenum onto D314 was studied with the static adsorption method. The adsorption process was analyzed from thermodynamic and kinetic aspects. The experimental results show that the equilibrium adsorption data conform satisfactorily to the Langmuir equation. In the adsorption process of D314 for molybdenum, the enthalpy change ΔH is positive when temperature is in the range of 298-338 K, which indicates that the adsorption is an endothermic process, and the elevated temperature benefits to the adsorption. Kinetic analysis shows that the adsorption rate is controlled by intraparticle diffusion and chemical diffusion at the same time. The adsorption mechanism of molybdenum onto D314 was discussed based on IR spectra.
基金Project supported by the National Key R&D Program of China(Grant No.2022YFA1602500)the National Natural Science Foundation of China(Grant No.12274352)。
文摘An experimental measurement of the lifetime of 3d^(9) ^(2)D_(3/2) metastable level in Mo^(15+)is reported in this work.The Mo^(15+)ions are produced and trapped in an electron beam ion trap with a magnetic field of 0.65 T.The decay photons emitted from 3d^(9) ^(2)D_(3/2) level are subsequently recorded via a cooled photomultiplier tube.Through meticulous scrutiny of potential systematic uncertainties affecting the measurement outcomes,we have determined the lifetime of Mo^(15+)3d^(9)2D_(3/2)metastable level to be 2.83(22)ms.The experimental result provides a clear distinguishment from existing calculations based on various theoretical approaches.
基金Project(2007AA06Z129) supported by the National High-tech Research and Development Program of China
文摘The separation techniques of vanadium and molybdenum were summarized, and a new method of removal V(Ⅴ) from Mo(Ⅵ) by adsorption with chelate resin was presented. Nine kinds of chelate resins were used to investigate the adsorbent capability of V(Ⅴ) in ammonium molybdate solution with static method. The test results show that DDAS, CUW and CW-2 resins can easily adsorb V(Ⅴ) in ammonium molybdate solution, but hardly adsorb Mo(Ⅵ). The dynamic experimental results show more than 99.5% of V(Ⅴ) can be adsorbed, and the adsorption rate of Mo(Ⅵ) is less than 0.27% at 294-296 K for 60 min at pH 7.42-8.02. The mass ratio of V to Mo decreases to l/5 0000 in the effluent from 1/255 in the initial solution. The loaded resin can be desorbed by 5% NH3·H2O solution, and the vanadium desorption rate can reach 99.6%. The max concentration of vanadium in desorbed solution can reach 20 g/L, while the concentration of molybdenum is less than 0.8 g/L.
文摘The application of the technique of removing molybdenum by moving packed bedand fluidized bed ion-exchange in a factory was described. The data showed that the Mo removalefficiency is above 99 percent, and the Mo content in APT (Ammonium Paratungstate) is controlledsteadily below 18 X l0^(-6), in the case of treating the feed liquor containing Mo 1.4 g/L. Thetechnique is simple and convenient in operation, good reusability of resin, loss consumption ofdesorption reagent and little pollution on environment. The loss of tungsten is less than 0.5percent. The technique bas been proved to be an economical and efficient process for Mo removal.
