The particle collision behavior and heat transfer performance are investigated to reveal the heat transfer enhancement and fouling prevention mechanism in a Na_(2)SO_(4) circulating fluidized bed evaporator.The partic...The particle collision behavior and heat transfer performance are investigated to reveal the heat transfer enhancement and fouling prevention mechanism in a Na_(2)SO_(4) circulating fluidized bed evaporator.The particle collision signals are analyzed with standard deviation by varying the amount of added particles ε(1%–3%),circulation flow velocity u(0.37–1.78 m·s^(-1)),and heat flux q(7.29–12.14 kW·m^(-2)).The results show that the enhancement factor reach up to 14.6%by adding polytetrafluoroethylene particles at ε=3%,u=1.78 m·s^(-1),and q=7.29 kW·m^(-2).Both the standard deviation of the particle collision signal and enhancement factor increase with the increase in the amount of added particles.The standard deviation increases with the increase in circulation flow velocity;however,the enhancement factor initially decreases and then increases.The standard deviation slightly decreases with the increase in heat flux at low circulation flow velocity,but initially increases and then decreases at high circulation flow velocity.The enhancement factor decreases with the increase in heat flux.The enhancement factor in Na_(2)SO_(4) solution is superior to that in water at high amount of added particles.The empirical correlation for heat transfer is established,and the model results agree well with the experimental data.展开更多
The modification effects of ytterbium(Yb), Na_3PO_4 and Yb + Na_3PO_4 on primary Mg_2Si phase in Mg-4Si alloys were investigated by means of X-ray diffraction(XRD), optical microscopy(OM), scanning electron microscopy...The modification effects of ytterbium(Yb), Na_3PO_4 and Yb + Na_3PO_4 on primary Mg_2Si phase in Mg-4Si alloys were investigated by means of X-ray diffraction(XRD), optical microscopy(OM), scanning electron microscopy(SEM) and energy dispersive spectroscopy(EDS) analysis in this work. The results indicate that the morphology of the primary Mg_2Si phase apparently changes from coarse dendrites to fine dispersive polygonal particles and the mean size decreases from 276.6 μm to 7.1 μm, with combined modification of 0.8wt.% Yb and 2.64 wt.% Na_3PO_4. Such a morphological evolution results in improvement in the ultimate tensile strength and elongation of the alloys as compared to the base alloy. This may be attributed to the formation of the YbP particles that acted as the heterogeneous nucleation substrates for the primary Mg_2Si particles, resulting in a refined distribution of these precipitates. The results of XRD examination show that there was no reaction between Si and Yb or Na_3PO_4. Solo addition of Yb or Na_3PO_4 into the melt has no real modification effect on the microstructure, but the primary Mg_2Si particles and α-Mg phases become coarser than that in the unmodified alloy.展开更多
Using low-cost FePO4·2H2O as iron source,Na2FePO4F/C composite is prepared by alcohol-assisted ball milling and solid-state reaction method.The XRD pattern of Na2FePO4F/C composite demonstrates sharp peaks,indica...Using low-cost FePO4·2H2O as iron source,Na2FePO4F/C composite is prepared by alcohol-assisted ball milling and solid-state reaction method.The XRD pattern of Na2FePO4F/C composite demonstrates sharp peaks,indicating high crystalline and phase purity.The SEM and TEM images reveal that diameter of the spherical-like Na2FePO4F/C particles ranges from 50 to 300 nm,and HRTEM image shows that the surface of Na2FePO4F/C composite is uniformly coated by carbon layer with a average thickness of about 3.6 nm.The carbon coating constrains the growth of the particles and effectively reduces the agglomeration of nanoparticles.Using lithium metal as anode,the composite delivers a discharge capacities of 102.8,96.4 and 90.3 mA·h/g at rates of 0.5C,1C and 2C,respectively.After 100 cycles at 0.5C,a discharge capacity of 98.9 mA·h/g is maintained with capacity retention of 96.2%.The Li+diffusion coefficient(D)of Na2FePO4F/C composite is calculated as 1.71×10^–9 cm^2/s.This study reveals that the simple solid state reaction could be a practical and effective synthetic route for the industrial production of Na2FePO4F/C material.展开更多
目的：用化学发光微粒子免疫分析法（CM IA ）联合梅毒螺旋体明胶凝集试验（T PPA ）和甲苯胺红不加热血清试验（TRUST）检测梅毒抗体（TP-Ab），探讨CMIA在筛查梅毒螺旋体特异性抗体中的临床应用价值。方法采用CMIA对住院和门诊患者进...目的：用化学发光微粒子免疫分析法（CM IA ）联合梅毒螺旋体明胶凝集试验（T PPA ）和甲苯胺红不加热血清试验（TRUST）检测梅毒抗体（TP-Ab），探讨CMIA在筛查梅毒螺旋体特异性抗体中的临床应用价值。方法采用CMIA对住院和门诊患者进行TP-Ab筛查，阳性标本再进行TPPA和TRUST 的检测，对比分析3种检测方法的检验结果的符合率。结果25030例血清标本经CM IA筛查共检出T P-Ab阳性732例，检出率为2．9％。以TPPA和TRUST对阳性标本进行联合检测的阳性检出率分别为78．7％、37．2％。以 TPPA为标准参考方法， CM IA S/CO在1～＜9的阳性符合率为29．7％～90．1％，S/CO≥9的阳性符合率为100．0％。结论 CM IA可取代传统的非密螺旋体抗原血清试验用于高通量梅毒抗体的筛查。展开更多
基金This work is supported by the open foundation of State Key Laboratory of Chemical Engineering(SKL-ChE-18B03)the Municipal Science and Technology Commission of Tianjin,China under Contract No.2009ZCKFGX01900.
文摘The particle collision behavior and heat transfer performance are investigated to reveal the heat transfer enhancement and fouling prevention mechanism in a Na_(2)SO_(4) circulating fluidized bed evaporator.The particle collision signals are analyzed with standard deviation by varying the amount of added particles ε(1%–3%),circulation flow velocity u(0.37–1.78 m·s^(-1)),and heat flux q(7.29–12.14 kW·m^(-2)).The results show that the enhancement factor reach up to 14.6%by adding polytetrafluoroethylene particles at ε=3%,u=1.78 m·s^(-1),and q=7.29 kW·m^(-2).Both the standard deviation of the particle collision signal and enhancement factor increase with the increase in the amount of added particles.The standard deviation increases with the increase in circulation flow velocity;however,the enhancement factor initially decreases and then increases.The standard deviation slightly decreases with the increase in heat flux at low circulation flow velocity,but initially increases and then decreases at high circulation flow velocity.The enhancement factor decreases with the increase in heat flux.The enhancement factor in Na_(2)SO_(4) solution is superior to that in water at high amount of added particles.The empirical correlation for heat transfer is established,and the model results agree well with the experimental data.
基金financially supported by the Fundamental Research Funds for Central Universities(Grant No.:XDJK2015B001)
文摘The modification effects of ytterbium(Yb), Na_3PO_4 and Yb + Na_3PO_4 on primary Mg_2Si phase in Mg-4Si alloys were investigated by means of X-ray diffraction(XRD), optical microscopy(OM), scanning electron microscopy(SEM) and energy dispersive spectroscopy(EDS) analysis in this work. The results indicate that the morphology of the primary Mg_2Si phase apparently changes from coarse dendrites to fine dispersive polygonal particles and the mean size decreases from 276.6 μm to 7.1 μm, with combined modification of 0.8wt.% Yb and 2.64 wt.% Na_3PO_4. Such a morphological evolution results in improvement in the ultimate tensile strength and elongation of the alloys as compared to the base alloy. This may be attributed to the formation of the YbP particles that acted as the heterogeneous nucleation substrates for the primary Mg_2Si particles, resulting in a refined distribution of these precipitates. The results of XRD examination show that there was no reaction between Si and Yb or Na_3PO_4. Solo addition of Yb or Na_3PO_4 into the melt has no real modification effect on the microstructure, but the primary Mg_2Si particles and α-Mg phases become coarser than that in the unmodified alloy.
基金Projects(51472211,51502256)supported by the National Natural Science Foundation of ChinaProjects(2016GK4005,2016GK4030)supported by the Strategic New Industry of Hunan Province,ChinaProject(13C925)supported by the Research Foundation of Education Bureau of Hunan Province,China
文摘Using low-cost FePO4·2H2O as iron source,Na2FePO4F/C composite is prepared by alcohol-assisted ball milling and solid-state reaction method.The XRD pattern of Na2FePO4F/C composite demonstrates sharp peaks,indicating high crystalline and phase purity.The SEM and TEM images reveal that diameter of the spherical-like Na2FePO4F/C particles ranges from 50 to 300 nm,and HRTEM image shows that the surface of Na2FePO4F/C composite is uniformly coated by carbon layer with a average thickness of about 3.6 nm.The carbon coating constrains the growth of the particles and effectively reduces the agglomeration of nanoparticles.Using lithium metal as anode,the composite delivers a discharge capacities of 102.8,96.4 and 90.3 mA·h/g at rates of 0.5C,1C and 2C,respectively.After 100 cycles at 0.5C,a discharge capacity of 98.9 mA·h/g is maintained with capacity retention of 96.2%.The Li+diffusion coefficient(D)of Na2FePO4F/C composite is calculated as 1.71×10^–9 cm^2/s.This study reveals that the simple solid state reaction could be a practical and effective synthetic route for the industrial production of Na2FePO4F/C material.
文摘目的：用化学发光微粒子免疫分析法（CM IA ）联合梅毒螺旋体明胶凝集试验（T PPA ）和甲苯胺红不加热血清试验（TRUST）检测梅毒抗体（TP-Ab），探讨CMIA在筛查梅毒螺旋体特异性抗体中的临床应用价值。方法采用CMIA对住院和门诊患者进行TP-Ab筛查，阳性标本再进行TPPA和TRUST 的检测，对比分析3种检测方法的检验结果的符合率。结果25030例血清标本经CM IA筛查共检出T P-Ab阳性732例，检出率为2．9％。以TPPA和TRUST对阳性标本进行联合检测的阳性检出率分别为78．7％、37．2％。以 TPPA为标准参考方法， CM IA S/CO在1～＜9的阳性符合率为29．7％～90．1％，S/CO≥9的阳性符合率为100．0％。结论 CM IA可取代传统的非密螺旋体抗原血清试验用于高通量梅毒抗体的筛查。
