A Novel Multi-Granularity Flexible-Grid Switching Optical-Node Architecture

A novel multi-granularity flexible-grid switching optical-node architecture is proposed in this paper.In our system,the photonic lanterns are used as mode division multiplexing/demultiplexing(MD-Mux/MD-Demux)for selecting mode.The wavelength division multiplexer/demultiplexer(WDMux/WD-Demux)and the fiber bragg gratings(FBGs)are used to select wavelength channels with the various grid.The experimental results show that the transmission bandwidth covers the C+L band,the average transmission loss is-13.4 dB,and the average crosstalk is-30.5 dB.The optical-node architecture is suit for mode division multiplexing(MDM)optical communication system.

Optimizing Fiber Topologies for WDM Optical Networks Based on Multi-Granularity Optical Switching Technology

For the quality of service （QoS） and fairness considerations, the hop counts of various lightpaths in a wavelength division multiplexing （WDM） optical network should be short and compact. The development of multi-granularity optical switching technology has made it possible to construct various fiber topologies over a fixed physical topology. This paper describes a fiber topology design （FTD） problem, which minimizes the maximum number of required fibers in the physical links for a maximum lightpath hop count in the fiber topology. After the formular description for the FTD problem, a method was given to obtain the lower bound on the maximum number of required fibers. For large or moderate scale networks, three heuristic algorithms are given to efficiently solve the FTD problem. This study gives a new way to optimize the resource configuration performance in WDM optical networks at the topology level and proves its effectiveness via both analyses and numerical experiments.

Power-induced polarization switching and bistability characteristics in 1550-nm VCSELs subjected to orthogonal optical injection

The polarization switching（PS） and polarization bistability（PB） characteristics of a 1550-nm vertical-cavity surfaceemitting laser（VCSEL） subjected to orthogonal optical injection are systematically investigated.The simulated results show that the PS and polarization-resolved nonlinear dynamical states of the VCSEL are critically dependent on the changing paths of the injected power.The polarization dynamics for different scanning directions of the injected power is presented to explain the polarization evolution during the formation of PS.In the case of forward scanning injected power,with the increase of frequency detuning level between the VCSEL and the injected light,the injected power required for PS gradually increases for negative frequency detuning but exhibits fluctuations for positive frequency detuning.In the case of reversely scanning injected power,the injected power required for PS displays fluctuant changes within the whole frequency detuning range.Specifically,PS may disappear under certain negative frequency detuning and large bias current.Furthermore,the hysteresis width as a function of the frequency detuning is calculated,and the regions for the appearance and disappearance of PB have been determined in the parameter space of the bias current and frequency detuning.

All-optical switching and nonlinear optical properties of HBT in ethanol solution

This paper demonstrates an all-optical switching model system comprising a single pulsed pump beam at 355 nm and a CW He-Ne signal beam at 632.8 nm with 2-（2＇-hydroxyphenyl）benzothiazole （HBT） in ethanol solution. The origins of the optical switching effect were discussed. By the study of nonlinear optical properties for HBT in ethanol solvent, this paper verified that the excited-state intramolecular proton transfer （ESIPT） effect of HBT and the thermal effect of solvent worked on quite different time scales and together induced the change of the refractive index of HBT solution, leading to the signal beam deflection. The results indicated that the HBT molecule could be an excellent candidate for high-speed and high-sensitive optical switching devices.

Research and Progress of Service Driven Optical Switching Network in China

National R&D activities on optical switching networkare introduced. Optical switching network testbedswere established in China including 3T-net andOBS ring and mesh network test-bed with the supportof national '863' program. As an importantmodule in OPS network, a novel all-optical serialmulticast mode is discussed.

Investigation of the influence of key parameters on system performance in all-optical label switching based on FSK/ASK orthogonal modulation format

The transmission characteristics of the optical label switching system based on the FSK/ASK orthogonal modulation format is investigated. The factors that affect the transmission performance, such as the FSK tone space, dispersion compensation and coupler split ratio, are studied by numerical simulation. The proposed scheme is also experimentally demonstrated with a transmission of 155 Mbit/s FSK label combined with 10 Gbit/s ASK payload.

Design and Simulation of Routing-switching Protocol Based on Optical Switch Array

An optical routing-switching technology based on optical switch array is proposed.The characteristics of the blocking and nonblocking networks are analyzed and compared,odd-even sorting network is used to realize optical routing-switching,relative routing-switching protocol is designed.Simulation test under load shows that it can reduce a blocking effectively and enhance an efficiency of switching.Further,it can transfer the processing and switching within parallel computer from electric domain to optical domain. It can make parallel computer coordinating computing and processing at much more higher speed, storing and transmitting even more efficiently.

Study of Crosstalk Property in an Optical Packet Switching Node

The effect of queuing delay of output buffer on the crosstalk property in optical packet switching nodes is investigated. The relationship between crosstalk and buffer length is obtained. From the calculation and simulation results, it is concluded that the crosstalk power penalty predominantly depends on the buffer length, the longer the buffer, the greater the penalty, as well as the random range of the penalty. While comparing with the effect of queuing delay, the effect of random routing path delay takes very little proportion in the total power penalty.

Optical switching based on the manipulation of microparticles in a colloidal liquid using strong scattering force

This paper demonstrates the realization of an optical switch by optically manipulating a large number of polystyrene spheres contained in a capillary. The strong scattering force exerted on polystyrene spheres with a large diameter of 4.3 μm is employed to realize the switching operation. A transparent window is opened for the signal light when the polystyrene spheres originally located at the beam centre are driven out of the beam region by the strong scattering force induced by the control light. The switching dynamics under different incident powers is investigated and compared with that observed in the optical switch based on the formation of optical matter. It is found that a large extinction ratio of - 30 dB and fast switching-on and switching-off times can be achieved in this type of switch.

Fabrication of high-quality colloidal photonic crystals with sharp band edges for ultrafast all-optical switching

Application of the pressure controlled isothermal heating vertical deposition method to the fabrication of colloidal photonic crystals is systematically investigated in this paper. The fabricated samples are characterized by scanning electron microscope and transmission spectrum. High-quality samples with large transmissions in the pass bands and the sharp band edges are obtained and the optimum growth condition is determined. For the best sample, the transmission in the pass bands approaches 0.9 while that in the band gap reaches 0.1. More importantly, the maximum differential transmission as high as 0.1/nm is achieved. In addition, it is found that the number of stacking layers does not increase linearly with concentration of PS spheres in a solution, and a gradual saturation occurs when the concentration of PS spheres exceeds 1.5 wt.%. The uniformity of the fabricated samples is examined by transmission measurements on areas with different sizes. Finally, the tolerance of the fabricated samples to baking was studied.

Simulation of the Physical Performance of Optical Packet Switching Nodes

A graphical and visual simulation system for the study of optical packet switching (OPS) nodes is accomplished. With the simulation system, the effect on physical performance-bit error rate (BER) due to a variety of factors such as the crosstalk parameters of OPS nodes, number of cascaded OPS nodes, length of optical output buffer, traffic load and fluctuation of amplitude of optical signals are evaluated. Reliability of the simulation system is proved by the analytical results obtained in all the above cases.

A new Structure of Optical Buffer and 2×622MB/S ATM Photonic Switching System

A new structure of optical buffer for resolving ATM cell contention is presented in this paper. It is composed of fiber delay lines, optical waveguide switching array and nonlinear semiconductor optical amplifier. Also, an experimental system for switching ATM cells formed by data at different transmission rates (up to 622MB/s) from different users is reported. The throughput of this system is 1.2Gb/s.

Study of Token Generation for Burst Traffic Shaping in Optical Burst Switching Networks

Traffic shaping is one of important control operation to guarantee the Quality of Service (QoS) in optical burst switching (OBS) networks. The efficiency of traffic shaping is mainly determined by token generation method. In this paper, token generation methods of traffic shaping are evaluated by using three kinds of probability distribution, and are analyzed in terms of burst blocking probability, through-put and correlation by simulation. The simulation results show that the token generation methods decrease the burst correlation of Label Switched Paths (LSPs), and solve traffic congestion as well. The different burst arrival processes have small impact on the blocking probability for OBS net works. Key words optical burst switching - traffic shaping - token generation - quality of service CLC number TP 929.11 Foundation item: Supported by the National Natural Science Foundation of China (60132030) and the Korea Science and Engineering Foundation (KOSEF) through OIRC ProjectBiography: Tang Wan (1974-), female, Ph. D candidate, research direction: contention resolution and routing mechanism in OBS networks.

A Comparison and Performance of Different Optical Switching Architectures

Optical Packet Switching (OPS) and transmission networks based on Wavelength Division Multiplexing (WDM) have been increasingly deployed in the Internet infrastructure over the last decade in order to meet the huge increasing demand for bandwidth. Several different technologies have been developed for optical packet switching such as space switches, broadcast-and-select, input buffered switches and output buffered switches. These architectures vary based on several parameters such as the way of optical buffering, the placement of optical buffers, the way of solving the external blocking inherited from switching technologies in general and the components used to implement the WDM. This study surveys most of the exiting optical packet switching architectures. A simulation-based comparison of input buffered and output buffered architectures is presented. The performance analysis of the selected two architectures is derived using simulation program and compared at different scenarios. We found that the output buffered architectures give better performance than input buffered architectures. The simulation results show that the-broadcast-and-select architecture is attractive in terms that it has lees number of components compared to other switches.

Limited Delay Preemption Based Priority in Differentiated Optical Burst Switching Networks with Small Buffers

The composite scheme based on preemption and small buffers is an efficient method for contention resolution. To support services differentiation, it is the first time that the analytical model of delay preemption based priority is built. Further, in order to guarantee the low-loss requirement for high priority bursts, an improved scheme is proposed and investigated by limiting the buffered right of low priority bursts within the specific traffic states. The simulation results show that, without the deterioration of blocking performance, there is more than 40% reduction on burst loss being achieved under the conditionρ=1.0 for high priority bursts.

Nonlinear characterization and optical switching in bromophenol blue solutions

In this paper the results from investigations of the nonlinear refractive index and nonlinear absorption coefficient of Bromophenol Blue using the Z-scan technique with a continuous wave laser beam at wavelengths 488 nm and 514 nm are presented. It was observed that the material exhibited reverse saturation absorption and self defocusing behavior. It was found that the increase in solution concentration resulted in linear increase of the nonlinear refractive index. A pump and probe technique was used to obtain the absorption spectrum of triplet state. Furthermore the nonlinear absorption effect was used to demonstrate all optical switching.

Performance analysis of optical burst switching node with limited wavelength conversion capabilities

The systematical and scalable frameworks were provided for estimating the blocking probabilities under asynchronous traffic in optical burst switching(OBS) nodes with limited wavelength conversion capability(LWCC) . The relevant system architectures of limited range and limited number of wavelength converters(WCs) deployed by a share-per-fiber(SPF) mode were developed,and the novel theoretical analysis of node blocking probability was derived by combining the calculation of discouraged arrival rate in a birth-death process and two-dimensional Markov chain model of SPF. The simulation results on single node performance verify the accuracy and effectiveness of the analysis models. Under most scenarios,it is difficult to distinguish the plots generated by the analysis and simulation. As the conversion degree increases,the accuracy of the analysis model worsens slightly. However,the utmost error on burst loss probability is far less than one order of magnitude and hence,still allows for an accurate estimate. Some results are of actual significance to the construction of next-generation commercial OBS backbones.

Optimization of Key Parameters in 622-Mb/s Amplitude Shift Keying Labeled 40-Gb/s Return to Zero Differential Phase Shift Keying Optical Switching Network

Optimized are the label extinction ratio and dispersion compensation of an optical label switching transmission system,which employs 40-Gb/s return to zero differential phase shift keying(RZ-DPSK)payload labeled with 622-Mb/s amplitude shift keying(ASK)control data.In our scheme,the receiver sensitivities of payload and label achieves-27.8dBm and-33.5dBm,respectively.After transmitted over 40km,60km and 80km single mode fiber(SMF)(with dispersion compensation)respectively,the payload can be recovered with no power penalty,while the label can be recovered with less than 2dB penalty.

Nonlinear Optical Properties, Optical Limiting and Optical Switching of Ag Nanoparticles Prepared by a Green Synthetic Method

Silver nanoparticles were synthesized using an aqueous extract of cinnamon berks (cinnamon cassia) as a reducer and stabilizer. The synthesized silver nanoparticles were characterized using UV-Vis spectrometry and Transmission Electron Microscopy (TEM), which revealed the nano nature of the particles. Nonlinear absorption and nonlinear refraction were measured using a Z-scan technique at different wavelengths with CW lasers. The third order nonlinear susceptibility was found to be between (1.5 to 22) ×10-14 m2/V2. The nonlinear property of the synthesized silver nanoparticles was used to demonstrate optical limiting and all-optical switching. An optical limiting threshold was found to be 0.1 mW at 632.8 nm.

Optical Switching and Digital Signal Amplification Using an Optical Fiber Grating OBD

It is proposed that an optical fiber grating bistability device may be used for an all optical switching or an all optical digital signal amplifier with low power and high speed. The principle, characteristic and paremeter are analysed, and some design ideas are given.